ABSTRACT
Achieving control of the surface chemistry of colloidal quantum dots (CQDs) is essential to fully exploit their properties in solar cells, but direct measurement of the chemistry and electronic structure in the outermost atomic layers is challenging. Here we probe the surface oxidation and passivation of cation-exchanged PbS/CdS core/shell CQDs with sub nm-scale precision using synchrotron-radiation-excited depth-profiling photoemission. We investigate the surface composition of the topmost 1-2.5 nm of the CQDs as a function of depth, for CQDs of varying CdS shell thickness, and examine how the surface changes after prolonged air exposure. We demonstrate that the Cd is localized at the surface of the CQDs. The surface-localized products of oxidation are identified, and the extent of oxidation quantified. We show that oxidised sulfur species are progressively eliminated as Cd replaces Pb at the surface. A sub-monolayer surface 'decoration' of Cd is found to be effective in passivating the CQDs. We show that the measured energy-level alignments at PbS/CdS colloidal quantum dot surfaces differ from those expected on the basis of bulk band offsets, and are strongly affected by the oxidation products. We develop a model for the passivating action of Cd. The optimum shell thickness (of around 0.1 nm, previously found to give maximised power conversion efficiency in PbS/CdS solar cells) is found to correspond to a trade-off between the rate of oxidation and the introduction of a surface barrier to charge transport.
ABSTRACT
Nanocrystalline thin films of PbS are obtained in a straightforward reaction by precipitation at the interface between toluene (containing a Pb precursor) and water (containing Na2S). Lead thiobiuret [Pb(SON(CN(i)Pr2)2)2] and lead diethyldithiocarbamate [Pb(S2CNEt2)2] precursors are used. The films are characterized by X-ray diffraction and electron microscopy, revealing typical particle sizes of 10-40 nm and preferred (200) orientation. Synchrotron-excited depth-profiling X-ray photoelectron spectroscopy (XPS) is used to determine the depth-dependent chemical composition as a function of surface aging in air for periods of up to 9 months. The as-synthesized films show a 1:1 Pb/S composition. Initial degradation occurs to form lead hydroxide and small quantities of surface-adsorbed -SH species. A lead-deficient Pb1-xS phase is produced as the aging proceeds. Oxidation of the sulfur occurs later to form sulfite and sulfate products that are highly localized at the surface layers of the nanocrystals. These species show logarithmic growth kinetics, demonstrating that the sulfite/sulfate layer acts to passivate the nanocrystals. Our results demonstrate that the initial reaction of the PbS nanocrystals (forming lead hydroxide) is incongruent. The results are discussed in the context of the use of PbS nanocrystals as light-harvesting elements in next-generation solar technology.
ABSTRACT
Colloidal quantum dots (CQDs) are promising materials for novel light sources and solar energy conversion. However, trap states associated with the CQD surface can produce non-radiative charge recombination that significantly reduces device performance. Here a facile post-synthetic treatment of CdTe CQDs is demonstrated that uses chloride ions to achieve near-complete suppression of surface trapping, resulting in an increase of photoluminescence (PL) quantum yield (QY) from ca. 5% to up to 97.2 ± 2.5%. The effect of the treatment is characterised by absorption and PL spectroscopy, PL decay, scanning transmission electron microscopy, X-ray diffraction and X-ray photoelectron spectroscopy. This process also dramatically improves the air-stability of the CQDs: before treatment the PL is largely quenched after 1 hour of air-exposure, whilst the treated samples showed a PL QY of nearly 50% after more than 12 hours.
ABSTRACT
The adsorption of p-aminobenzoic acid (pABA) on the anatase TiO2(101) surface has been investigated using synchrotron radiation photoelectron spectroscopy, near edge X-ray absorption fine structure (NEXAFS) spectroscopy, and density functional theory (DFT). Photoelectron spectroscopy indicates that the molecule is adsorbed in a bidentate mode through the carboxyl group following deprotonation. NEXAFS spectroscopy and DFT calculations of the adsorption structures indicate the ordering of a monolayer of the amino acid on the surface with the plane of the ring in an almost upright orientation. The adsorption of pABA on nanoparticulate TiO2 leads to a red shift of the optical absorption relative to bare TiO2 nanoparticles. DFT and valence band photoelectron spectroscopy suggest that the shift is attributed to the presence of the highest occupied molecular orbitals in the TiO2 band gap region and the presence of new molecularly derived states near the foot of the TiO2 conduction band.
