ABSTRACT
A straightforward method for visualization and quantification of surfactant effectiveness within different electrolyte environments based on using reconfigurable Janus emulsions as novel optical probes is reported. More specifically, we investigated the effect of different types and concentrations of salt counter-ions on the surfactant surface excess of commercial ionic and non-ionic surfactants, namely sodium dodecyl sulfate (SDS) and Tween 80 via in situ monitoring the morphological reconfigurations of biphasic Janus emulsions comprising hydrocarbon and fluorocarbon oils. We find that significant variations in interfacial tensions of SDS-stabilized interfaces (up to 15 mN·m-1) can be evoked by titrating mono-, di-, and trivalent cationic counter-ions, which is coherent with the lyotropic (Hofmeister) series. In contrast, the salt counter-ion effect on the surfactant effectiveness was less pronounced for the non-ionic surfactant Tween 80 (â¼3 mN·m-1). Our results reveal a facile in situ method for monitoring the central role of electrolyte type and concentration on surfactant effectiveness and, more broadly, illustrate that Janus emulsions serve as powerful optical probes to dynamically study the properties of surfactants at liquid interfaces. We demonstrate the utility of our findings for an electro-induced morphological reconfiguration of Janus droplet morphologies by dynamically tuning Cu2+ concentration in solution using an electrode setup. The latter provides a unique platform for liquid-phase, real-time, and continuous tuning of Janus droplet morphologies, e.g., for their application in sensing and dynamic optical device platforms.
ABSTRACT
The cationic content of water represents a major quality control parameter that needs to be followed by a rapid, on-site, and low-cost method. Herein, we report a novel method for a facile monitoring of the mineral content of drinking water by making use of responsive complex emulsions. The morphology of biphasic oil-in-water droplets solely depends on the balance of interfacial tensions, and we demonstrate that changes in the surfactant effectiveness, caused by variations in the mineral content inside the continuous phase, can be visualized by monitoring internal droplet shapes. An addition of metal cations can significantly influence the surfactant critical micelle concentrations and the surface excess values and therefore induce changes in the effectiveness of ionic surfactants, such as sodium dodecyl sulfate. The morphological response of Janus emulsions droplets was tracked via a simple microscopic setup. We observed that the extent of the droplet response was dependent on the salt concentration and valency, with divalent cations (responsive for water hardness), resulting in a more pronounced response. In this way, Ca2+ and Mg2+ levels could be quantitatively measured, which we showcased by determination of the mineral content of commercial water samples. The herein demonstrated device concept may provide a new alternative rapid monitoring of water hardness levels in a simple and cost-effective setup.
Subject(s)
Surface-Active Agents , Water , Emulsions , Hardness , Sodium Dodecyl SulfateABSTRACT
Ideal monitoring devices should enjoy a combination of characteristics, e.g. high sensitivity, multiplexing, portability, short time-to-result (TTR). Typically, no device meets all of these demands since some of them are contradictory, to some extent. Herein, we present a miniaturized platform based on fluorescent detection, which is sensitive, readily allows multiplexing, and allows real-time monitoring of the signal, thus allowing extraction of kinetic information as well as drastic reduction of TTR. This is achieved via miniaturization of active spots, integration with microfluidics, and algorithmic approaches. We validate its performance by comparing with evanescent field excitation, which obtains similar results, however without the addition of the necessary complex hardware.
