Smoke-water obtained via different biotics: a cost-effective and safer approach to biochemically sound banana ripening with prolonged shelf-life.

This study was conducted to investigate the efficacy of smoke-water obtained from biotics, for example coconut shells, rice husk, and pine cones on banana ripening, and compared with calcium carbide. Bio-chemical composition and remarkable bactericidal effect towards ATCC cultures of Escherichia coli, Staphylococcus aureus, and Bacillus cereus discovered the biological safety of the smoke-water in all collected smoke-water samples. Further, inductively coupled plasma mass spectrometry (ICP-MS) was carried out to investigate heavy metals; however, no traces were found in all collected samples. Consequently, it is proposed that heavy metal-free smoke-water obtained from various biotics series might be employed as ultrasafe fruit ripening as compared to calcium carbide (CaC2) that was found with heavy metal traces.

Correlation between antibiotic resistance and phylogenetic types among multidrug-resistant Escherichia coli isolated from urinary tract infections.

OBJECTIVES: Emergence of multidrug resistance has reduced the choice of antimicrobial regimens for UTIs. To understand the association of phenotype and genotype among uropathogens. MATERIALS AND METHODS: Six hundred and twenty-eight (628) urine samples were collected and analyzed. Antibiotic sensitivity pattern was determined by the Kirby-Bauer Disc Diffusion Method and minimum inhibitory concentration (MIC) was tested by the E test. Fluoroquinolone resistant mutations in QRDR of gyrA and ParC, phylogenetic groups, and PAIusp subtype were detected by PCR. RESULTS: Most prevalent uropathogens were Escherichia coli (53.2%) followed by Klebsiella pneumoniae (21%). Multidrug- resistance was observed in > 50% cases for third-generation cephalosporins and ciprofloxacin and lowest in meropenem. E. coli (66.2%) and K. pneumonia (64.4%) were extended-spectrum ß-lactamases (ESBLs) producers. MIC to trimethoprim-sulfamethoxazole was highest in E. coli (>1024 µg/ml). In 80 (24%) of the 334 E. coli isolates analyzed in detail, 54 fluoroquinolones (FQ) resistant isolates carried mutations (S83L, D87N, S80I, E84V) in QRDR of gyrA and ParC. Out of 54 FQ-resistant isolates, 43 (79.6%) isolates belonged to the phylogenetic group B2, and 11(20.4%) belonged to group D. Isolates belonged to group B2, 38 (88.4%) of the 43 isolates carried PAIusp subtype IIa and high frequency of mutation E84V in ParC was detected in 37 (97.4%). Other mutations, such as S80I, S83L in gyrA and D87N in ParC were found in all resistant isolates. CONCLUSION: Correlations between phenotype and genotype provided a basis to understand the resistance development in uropathogens, and PAIusp subtyping indicated that E. coli belonged to the B2 group.

Biosorption characteristics of Aspergillus fumigatus for the decolorization of triphenylmethane dye acid violet 49.

This study focuses on the possible use of Aspergillus fumigatus to remove acid violet 49 dye (AV49) from aqueous solution. In batch biosorption experiments, the highest biosorption efficiency was achieved at pH 3.0, with biosorbent dosage of 3.0 gL(-1) within about 30 min at 40 °C. The Langmuir and Freundlich models were able to describe the biosorption equilibrium of AV49 onto fungal biomass with maximum dye uptake capacity 136.98 mg g(-1). Biosorption followed a pseudo-second-order kinetic model with high correlation coefficients (R (2) > 0.99), and the biosorption rate constants increased with increasing temperature. Thermodynamic parameters indicated that the biosorption process was favorable, spontaneous, and endothermic in nature, with insignificant entropy changes. Fourier transform infrared spectroscopy strongly supported the presence of several functional groups responsible for dye-biosorbent interaction. Fungal biomass was regenerated with 0.1 M sodium hydroxide and could be reused a number of times without significant loss of biosorption activity. The effective decolorization of AV49 in simulated conditions indicated the potential use of biomass for the removal of color contaminants from wastewater.

The possible role of selenium concentration in hepatitis B and C patients.

BACKGROUND/AIM: The compelling evidence reported that selenium is an essential trace mineral for human beings. Selenium plays a pivotal role in the restoration of immune functions. High rates of hepatitis B and C are present in Pakistan. Epidemiologic surveys demonstrated an inverse association between selenium (Se) level and regional cancer incidence, as well as viral infection. The present study was designed to evaluate the concentration of selenium in the serum of patients suffering from hepatitis B and C. PATIENTS AND METHODS: In this cross-sectional descriptive analytical study, serum selenium concentration of 150 patients suffering from hepatitis B and C, along with 26 healthy controls, was determined by atomic absorption spectrophotometer equipped with hydride generation system, model Analytic Jena (Vario III). RESULTS: The mean and standard deviation of serum selenium concentration observed in male and female patients with hepatitis C were 101.60 ± 0.55 and 77.43 ± 0.47 µ g/L, respectively, whereas the mean and standard deviation of serum selenium concentration observed in male and female patients with hepatitis B were 107.58 ± 0.44 and 137.8 ± 0.36 µg/L. Analysis of t test showed significant difference between C and B (P<0.001) patients in serum selenium concentration, when compared with the control. CONCLUSION: The obtained results indicate that serum selenium concentration of hepatitis B and C patients is less than serum selenium concentration of healthy individuals. However, serum selenium decline is relative to severity of disease. Based on findings of this study, it is proposed that selenium should be supplemented in such patients in order to optimize nutritional support and to get better treatment response.

Serum selenium concentration in liver cirrhotic patients suffering from hepatitis B and C in Pakistan.

High rates of hepatitis B and C are present in Pakistan. Epidemiological surveys demonstrated an inverse association between selenium (Se) level and regional cancer incidence, as well as viral infection. In this cross-sectional descriptive analytical study, serum selenium concentration of 150 patients suffering from hepatitis B and C patients, along with 26 healthy controls, was determined by atomic absorption spectrophotometer equipped with hydride generation system. The mean and standard deviation of serum selenium concentration observed in male and female patients with hepatitis C were 101.60 ± 0.55 and 77.43 ± 0.47 µg/l, respectively, while the mean and standard deviation of serum selenium concentration observed in male and female patients with hepatitis B was 107.58 ± 0.44 and 137.8 ± 0.36 µg/l. Analysis of t test showed significant difference between hepatitis C and B (P < 0.001) patients in serum selenium concentration when compared with control.

Removal of a cationic dye from aqueous solutions by adsorption onto bentonite clay.

The ability of bentonite to remove malachite green from aqueous solutions has been studied for different adsorbate concentrations by varying the amount of adsorbent, temperature, pH and shaking time. Maximum adsorption of the dye, i.e. >90% has been achieved in aqueous solutions using 0.05 g of bentonite at a pH of 9. Thermodynamic parameters such as DeltaH degrees, DeltaS degrees and DeltaG degrees were calculated from the slope and intercept of the linear plots of lnK(D) against 1/T. Analysis of adsorption results obtained at 298, 308, 318 and 328 K showed that the adsorption pattern on bentonite seems to follow the Langmuir, Freundlih and D-R isotherms. The temperature increase reduces adsorption capacity by bentonite, due to the enhancement of the desorption step in the mechanism. The numerical values of sorption free energy (E(a)) of 1.00-1.12 kJ mol(-1) indicated physical adsorption. The kinetic data indicated an intraparticle diffusion process with sorption being first order. The rate constant k was 0.526 min(-1). The concentration of malachite green oxalate was measured before and after adsorption by using UV-Vis spectrophotometer.

Removal of Fe(II) from the wastewater of a galvanized pipe manufacturing industry by adsorption onto bentonite clay.

Bentonite clay has been used for the adsorption of Fe(II) from aqueous solutions over a concentration range of 80-200 mg/l, shaking time of 1-60 min, adsorbent dosage from 0.02 to 2 g and pH of 3. The process of uptake follows both the Langmuir and Freundlich isotherm models and also the first-order kinetics. The maximum removal (>98%) was observed at pH of 3 with initial concentration of 100 mg/l and 0.5 g of bentonite. The efficiency of Fe(II) removal was also tested using wastewater from a galvanized pipe manufacturing industry. More than 90% of Fe(II) can be effectively removed from the wastewater by using 2.0 g of the bentonite. The effect of cations (i.e. zinc, manganese, lead, cadmium, nickel, cobalt, chromium and copper) on the removal of Fe(II) was studied in the concentration range of 10-500 mg/l. All the added cations reduced the adsorption of Fe(II) at high concentrations except Zn. Column studies have also been carried out using a certain concentration of wastewater. More than 99% recovery has been achieved by using 5 g of the bentonite with 3M nitric acid solution.