Faster Detection of Ischemia in Free Muscle Transfer When Using Microdialysis.

BACKGROUND: Microdialysis is a clinical method used to detect ischemia after microvascular surgery. Microdialysis is easy to use and reliable, but its value in most clinical settings is hampered by a 1- to 2-h delay in the delivery of patient data. This study evaluated the effectiveness of an increase in the microdialysis perfusion rate from 0.3 to 1.0 µL/min on the diagnostic delay in the detection of ischemia. METHODS: In eight pigs, two symmetric pure muscle transfers were dissected based on one vascular pedicle each. In each muscle, two microdialysis catheters were placed. The two microdialysis catheters were randomized to a perfusion rate of 0.3 or 1.0 µL/min, and the two muscle transfers were randomized to arterial or venous ischemia, respectively. After baseline monitoring, arterial and venous ischemia was introduced by the application of vessel clamps. Microdialysis sampling was performed throughout the experiment. The ischemic cutoff values were based on clinical experience set as follows: CGlucose < 0.2 mmol/L, CLactate > 7 mmol/L, and the lactate/pyruvate ratio > 50. RESULTS: The delay for the detection of 50% of arterial ischemia was reduced from 60 to 25 minutes, and for the detection of all cases of arterial ischemia, the delay was reduced from 75 to 40 minutes when the perfusion rate was increased from 0.3 to 1.0 µL/min. After the same increase in perfusion, the detection of 50% of venous ischemia was reduced from 75 to 40 minutes, and for all cases of venous ischemia, a reduction from 135 to 95 minutes was found. CONCLUSION: When using microdialysis for the detection of ischemia in pure muscle transfers, an increase in the perfusion rate from 0.3 to 1.0 µL/min can reduce the detection delay of ischemia.

Cerebral Effects of Targeted Temperature Management Methods Assessed by Diffusion-Weighted Magnetic Resonance Imaging.

The aim of this randomized porcine study was to compare surface targeted temperature management (TTM) to endovascular TTM evaluated by cerebral diffusion-weighted magnetic resonance imaging (MRI): apparent diffusion coefficient (ADC), and by intracerebral/intramuscular microdialysis. It is well known that alteration in the temperature affects ADC, but the relationship between cerebral ADC values and the cooling method per se has not been established. Eighteen anesthetized 60-kg female swine were hemodynamically and intracerebrally monitored and subsequently subjected to a baseline MRI. The animals were then randomized into three groups: (1) surface cooling (n = 6) at 33.5°C using EMCOOLSpad®, (2) endovascular cooling (n = 6) at 33.5°C using an Icy® cooling catheter with the CoolGard 3000®, or (3) control (n = 6) at 38.5°C using a Bair Hugger™. The swine were treated with TTM for 6 hours followed by a second MRI examination, including ADC. Blood and microdialysate were sampled regularly throughout the experiment, and glucose, lactate, pyruvate, glycerol, and the lactate/pyruvate ratio did not differ among groups, neither intracerebrally nor intramuscularly. Surface cooling yielded a significantly lower median ADC than endovascular cooling: 714 (634; 804) × 10-6 mm2/s versus 866 (828; 927) × 10-6 mm2/s, (p < 0.05). The surface cooling ADC was lowered to a range usually attributed to cytotoxic edema and these low values could not be explained solely by the temperature effect per se. To what extent the ADC is fully reversible at rewarming is unknown and the clinical implications should be further investigated in clinical studies.