Determination of elemental distribution in green micro-algae using synchrotron radiation nano X-ray fluorescence (SR-nXRF) and electron microscopy techniques--subcellular localization and quantitative imaging of silver and cobalt uptake by Coccomyxa actinabiotis.

The newly discovered unicellular micro-alga Coccomyxa actinabiotis proves to be highly radio-tolerant and strongly concentrates radionuclides, as well as large amounts of toxic metals. This study helps in the understanding of the mechanisms involved in the accumulation and detoxification of silver and cobalt. Elemental distribution inside Coccomyxa actinabiotis cells was determined using synchrotron nano X-ray fluorescence spectroscopy at the ID22 nano fluorescence imaging beamline of the European Synchrotron Radiation Facility. The high resolution and high sensitivity of this technique enabled the assessment of elemental associations and exclusions in subcellular micro-algae compartments. A quantitative treatment of the scans was implemented to yield absolute concentrations of each endogenous and exogenous element with a spatial resolution of 100 nm and compared to the macroscopic content in cobalt and silver determined using inductively coupled plasma-mass spectrometry. The nano X-ray fluorescence imaging was complemented by transmission electron microscopy coupled to X-ray microanalysis (TEM-EDS), yielding differential silver distribution in the cell wall, cytosol, nucleus, chloroplast and mitochondria with unique resolution. The analysis of endogenous elements in control cells revealed that iron had a unique distribution; zinc, potassium, manganese, molybdenum, and phosphate had their maxima co-localized in the same area; and sulfur, copper and chlorine were almost homogeneously distributed among the whole cell. The subcellular distribution and quantification of cobalt and silver in micro-alga, assessed after controlled exposure to various concentrations, revealed that exogenous metals were mainly sequestered inside the cell rather than on mucilage or the cell wall, with preferential compartmentalization. Cobalt was homogeneously distributed outside of the chloroplast. Silver was localized in the cytosol at low concentration and in the whole cell excluding the nucleus at high concentration. Exposure to low concentrations of cobalt or silver did not alter the localization nor the concentration of endogenous elements within the cells. To our knowledge, this is the first report on element co-localization and segregation at the sub-cellular level in micro-algae by means of synchrotron nano X-ray fluorescence spectroscopy.

Direct determination of phosphate esters in concentrated nitrate media by capillary zone electrophoresis.

The potential of capillary zone electrophoresis (CZE) for the determination of dibutyl phosphate (DBP) and monobutyl phosphate (MBP), two degradation products of the tributyl phosphate extractant used in the nuclear fuel reprocessing industry, was evaluated. Analysis conditions were optimised, taking particularly into account that many determinations had to be performed in concentrated aqueous nitrate or nitric acid solutions. Separations were therefore carried out using the counter-electroosmotic mode with cathodic detection in a pH 8.3 electrolyte containing a suitably selected chromophore, salicylate, to ensure the indirect UV detection of the analytes. Various aspects of the method, including its sensitivity, working range, repeatability, and rapidity, were examined. Quantification of both phosphate esters was achieved in less than 3 min at concentrations ranging from 2 x 10(-6) to 10(-3) mol l(-1) in samples containing no macro-component. The lower end of this range increased to 5 x 10(-6) mol l(-1) for MBP and 1.5 x 10(-5) mol l(-1) for DBP in samples containing 5 x 10(-2) mol l(-1) of sodium nitrate, thus enabling their determination in solutions containing nitrate or nitric acid at concentrations up to, respectively, 10,000 and 3000 times higher than the target analyte concentration. This simple, fast and reliable method is routinely applicable to aqueous samples with no other preliminary treatment than a proper dilution; analysis was also performed in organic matrices after a prior extraction. The method was validated by an excellent correlation with the standard DBP analysis technique, gas chromatography (GC). In order to develop appropriate chemical treatments to destroy these compounds, the method was applied to the monitoring of DBP and MBP degradation by hydrogen peroxide in 1 mol l(-1) nitric acid solutions.

Determination of C4-C14 carboxylic acids by capillary zone electrophoresis. Application to the identification of diamide degradation products and partitioning studies.

Capillary zone electrophoresis (CZE) was investigated for the determination of linear saturated carboxylic acid homologues ranging from C4 to C14. Separation conditions were optimised to overcome the problems of decreasing solubility and decreasing selectivity between successive homologues with increasing chain length. Separations were performed at 20 degrees C, using a 20 kV separation voltage and a pH 8 electrolyte containing 30% methanol. A suitable chromophore (4-aminobenzoate) was added to ensure indirect UV detection of the analytes. Calibration curves and repeatability were established. Minimum detectable concentrations of 3 x 10(-6) mol l(-1) were achieved. Resolution between successive homologues was better than 2. The electrophoretic mobility of each homologue (n=7-14) was assessed and a quasi-linear relationship between the mobility value and 1/n was observed. The quantitative analysis of a diamide degradation solution was performed and compared to potentiometric results. The CZE method was also applied to the determination of C7-C14 partitioning between an organic medium containing tributylphosphate in n-dodecane and different basic solutions. Their behaviour was established according to the chain length and the pH of the aqueous phase. For C10-C14 compounds, results were validated by comparison with gas chromatographic analysis of the organic phases.

Determination of some physicochemical parameters of microcystins (cyanobacterial toxins) and trace level analysis in environmental samples using liquid chromatography.

Some physicochemical parameters of three microcystin standards, known to be potent hepatotoxins produced by cyanobacteria, were determined using well defined chromatographic measurements. The logarithm of their retention factor on octadecylsilica (ODS) with water as the eluent, which is an estimation of the hydrophobicity of a molecule, was assessed at pH 7 at 3.9, 4.2 and 4.4 for microcystins-YR, -LR and -RR, respectively. Though being rather hydrophobic, microcystins also possess polar functions, namely carboxylic acids, amino and amido groups. The ionization of carboxylic groups occurs at pH values of 3.3-3.4. In environmental waters, microcystins are neutral or anionic. They are readily soluble in water, the solubility of microcystin-LR being higher than 1 g/l. Owing to their hydrophobicity and their polar functions, microcystins remain in the aqueous phase rather than being adsorbed on sediments or on suspended particulate matter. In a river water spiked with microcystins at 5 micrograms/l, only 10% was adsorbed on particles and 7% on the sandy sediment after three days. A method using solid-phase extraction on ODS followed by high-performance--or micro--liquid chromatography was optimized to detect microcystins at trace level in water. A clean-up was introduced to eliminate part of the interfering compounds coextracted during the sample percolation. Good recoveries (75-80%) were obtained. The method was linear, reproducible (with relative standard deviations ranging from 5 to 8%) and enabled the determination of microcystins at levels as low as 30 ng/l in drinking water and 100-200 ng/l in surface waters. The production of toxins by two strains of cyanobacteria was evaluated. Variations in the microcystin-LR content in the cells and in the medium of Microcystis aeruginosa PCC7806 were recorded over a five-week period. Toxin production was not correlated to the biomass but depended on the growth stage and was maximal at the end of the exponential growth phase. The release of toxin in water occurred essentially in old cultures where microcystin-LR was determined at concentrations of 170 and 280 micrograms/l in the media of M. aeruginosa PCC7806 and M. aeruginosa PCC7813, respectively. Other microcystins are likely to be synthesized by these strains. But owing to the lack of standards, mass spectrometric detection is required for further identification. This study points out the need of having other standards for water quality monitoring.

Detection of cyanobacterial toxins (microcystins) in cell extracts by micellar electrokinetic chromatography.

A micellar electrokinetic chromatography (MEKC) method with UV detection is described for the rapid and efficient separation of three microcystins: microcystin-YR (MCYST-YR), microcystin-LR (MCYST-LR) and microcystin-RR (MCYST-RR). A detection limit of 7.5 pg for each toxin was achieved. The UV intensities of these toxins measured at 200 nm showed good linearity in the range 7.5-150 pg. The production of MCYST-LR in three cultured strains of cyanobacteria, namely Microcystis aeruginosa strain IP7806, Microcystis aeruginosa strain IP7813 and Oscillatoria agardhii strain IP7805, was evaluated.