ABSTRACT
Steel automotive wheel rims are subject to wear and tear, down to the end of their service life. Manufacturers use standard destructive tests to determine the probable lifetime of the car wheel rim. With this approach, to predict the remaining use time, it is necessary to know the initial parameters of the wheel rim, actual mileage, and its use characteristics, which is difficult information to obtain in the real world. Moreover, this work shows that a vehicle's technical condition can affect the rim's remaining service time. This work describes a new method of precise binary identification of the technical condition of steel car wheel rims using the dispersion of damping factors which result from experimental modal analysis. This work also proposes a new method of indicating the approaching end of wheel rim service life with limited parameters: run-out, average of damping factors, and dispersion of damping factors. The proposed procedure requires two sequential examinations of the rim in standard periods related to the average annual mileage of the vehicle. On this basis, it is possible to indicate the approaching end of the life of the steel rims about 10,000 km in advance.
ABSTRACT
Petrochemical plants use on-stream inspection often to detect and monitor the corrosion on the equipment and piping system. Compared to ultrasonic thickness gauging and pulse-echo A-scan, phased array corrosion mapping has better coverability and can scan a large area to detect general and localized corrosion. This paper's objective is to obtain documentary evidence for the accuracy of corrosion detection from 30 °C to 250 °C on A36 low-carbon steel by carrying out simulation experiments every 10 °C step. A minimum of three sets of phased array corrosion mapping data in each temperature were collected to study and evaluate the detectability. The data evidence could enhance the confidence level of the plant's end users in using phased array mapping in the future during inspections. The experiments were found to be insufficiently thorough despite addressing the initial concerns, leaving more area for discussion in further studies, such as expanding the investigation to thicker carbon steel, stainless steel, and wedge materials.
ABSTRACT
Damages of different kinds that can be inflicted to a parked car. Among them, loosening of the car wheel bolts is difficult to detect during normal use of the car and is at the same time very dangerous to the health and life of the driver. Moreover, in patents and publications, only little information is presented about electronic sensors available for activation from inside of the car to inform the driver about the mentioned dangerous situation. Thus, the main aim of this work is the proposition and examination of a sensing device using of a wireless accelerometer head to detect loosening of wheel fixing bolts before ride has been started. The proposed sensing device consists of a wireless accelerometer head, an assembly interface and a receiver unit. The assembly interface between the head and the inner part of the rim enables the correct operation of the system. The data processing algorithm developed for the receiver unit enables the proper detection of the unscrewing of bolts. Moreover, the tested algorithm is resistant to the interference signals generated in the accelerometer head by cars and men passing in close distance.
