ABSTRACT
A numerical evaluation is conducted to assess the impact of distributing radio frequency (RF) signals through optical fiber links on the performance of a coherent multi-band multiple-input multiple-output (MIMO) radar system. The analysis focuses on scenarios where the antennas are widely separated in comparison to the employed signal wavelengths. The development of a model to quantify the phase noise (PN) induced on each RF band due to the signal transmission through optical fiber links between the centralized base station and each radar peripheral is described. Monte Carlo simulation results are collected to estimate the key performance indicators (KPIs) for varying standard single-mode fiber (SSMF) length and different PN contributions. The main contributors to the PN are revealed to be chromatic dispersion (CD), double Rayleigh scattering (DRS), and mechanical vibrations. In a shipborne scenario, a significant performance degradation occurs only when the length of the fiber links reaches approximately 20â km. Further, the PN impact has also been studied in a shipborne scenario to analyze the robustness of the system for worse phase noise level assumptions. The results reveal excellent robustness of the proposed centralized acquisition and processing approach in the presence of both very long fiber links and economically employed RF oscillators.
ABSTRACT
The higher capability of optical vortex beams of penetrating turbid media (e.g., biological fluids) with respect to the conventional Gaussian beams is, for the first time to our knowledge, demonstrated in the 1.3 µm wavelength range which is conventionally used for optical coherence tomography procedures in endoscopic intravascular scenarios. The effect has been demonstrated by performing transmittance measurements through suspensions of polystyrene microspheres in water with various particulate concentrations and, in reflection, by using samples of human blood with different thicknesses. The reduced backscattering/increased transmittance into such highly scattering media of Laguerre-Gaussian beams with respect to Gaussian ones, in the near infrared wavelength region, could be potentially exploited in clinical applications, leading to novel biomedical diagnoses and/or procedures.
Subject(s)
Infrared Rays , Tomography, Optical Coherence/methods , Blood/metabolism , Humans , Microspheres , Normal Distribution , Polystyrenes/chemistry , Water/chemistryABSTRACT
A silicon-on-insulator microring with three superimposed gratings is proposed and characterized as a device enabling 3×3 optical switching based on orbital angular momentum and wavelength as switching domains. Measurements show penalties with respect to the back-to-back of <1 dB at a bit error rate of 10-9 for OOK traffic up to 20 Gbaud. Different switch configuration cases are implemented, with measured power penalty variations of less than 0.5 dB at bit error rates of 10-9. An analysis is also carried out to highlight the dependence of the number of switch ports on the design parameters of the multigrating microring.
ABSTRACT
We propose a novel architecture for implementing a dual-frequency lidar (DFL) exploiting differential Doppler shift measurement. The two frequency tones, needed for target velocity measurements, are selected from the spectrum of a mode-locked laser operating in the C-band. The tones' separation is easily controlled by using a programmable wavelength selective switch, thus allowing for a dynamic trade-off among robustness to atmospheric turbulence and sensitivity. Speed measurements for different tone separations equal to 10, 40, 80, and 160 GHz are demonstrated, proving the system's capability of working in different configurations. Thanks to the acquisition system based on an analog-to-digital converter and digital-signal processing, real-time velocity measurements are demonstrated. The MLL-based proposed architecture enables the integration of the DFL with a photonic-based radar that exploits the same laser for generating and receiving radio-frequency signal with high performance, thus allowing for simultaneous or complementary target observations by exploiting the advantages of both radar and lidar.
ABSTRACT
We propose and demonstrate a technique for the generation of a coherent optical comb, with tunable line spacing in a periodically poled lithium niobate (PPLN) waveguide. A single continuous wave laser is modulated to generate three phase-locked seed lines, which are injected into a PPLN waveguide, to obtain line multiplication. The line spacing is set acting on the frequency of the electrical signal driving the modulator. The quality of the comb is verified measuring the autocorrelation, the phase noise, and the linewidth of the generated lines. With the same scheme, we demonstrate optical multicasting. From a single quadrature phase shift keying signal, modulated at 12.5 and 25 GBaud, five replicas are generated, with spacing 25 and 37.5 GHz. The performance of each signal replica is measured after transmission through 80 km of a single-mode fiber, demonstrating operation with a bit error rate value lower than the forward error correction threshold.
ABSTRACT
We propose and demonstrate a technique for the generation of an optical comb with tunable line spacing in a periodically poled lithium niobate (PPLN) waveguide. The technique is implemented with four input continuous waves (CWs), which generate a 19-line comb tuned to the spacing of 25 and 20 GHz. We show that each additional CW switched on out of the quasi phase-matching band at the PPLN waveguide input generates the growth of six new lines. The performance of the comb is tested modulating the lines with a 40 Gb/s differential quadrature phase shift keying data, demonstrating error-free operation. Nonuniform spacing of the input seed CWs improves the efficiency of the line generation process.
ABSTRACT
The next generation of radar (radio detection and ranging) systems needs to be based on software-defined radio to adapt to variable environments, with higher carrier frequencies for smaller antennas and broadened bandwidth for increased resolution. Today's digital microwave components (synthesizers and analogue-to-digital converters) suffer from limited bandwidth with high noise at increasing frequencies, so that fully digital radar systems can work up to only a few gigahertz, and noisy analogue up- and downconversions are necessary for higher frequencies. In contrast, photonics provide high precision and ultrawide bandwidth, allowing both the flexible generation of extremely stable radio-frequency signals with arbitrary waveforms up to millimetre waves, and the detection of such signals and their precise direct digitization without downconversion. Until now, the photonics-based generation and detection of radio-frequency signals have been studied separately and have not been tested in a radar system. Here we present the development and the field trial results of a fully photonics-based coherent radar demonstrator carried out within the project PHODIR. The proposed architecture exploits a single pulsed laser for generating tunable radar signals and receiving their echoes, avoiding radio-frequency up- and downconversion and guaranteeing both the software-defined approach and high resolution. Its performance exceeds state-of-the-art electronics at carrier frequencies above two gigahertz, and the detection of non-cooperating aeroplanes confirms the effectiveness and expected precision of the system.
ABSTRACT
A compact device with a two-level transfer function (TF) implemented with two semiconductor optical amplifier (SOA)-based stages is proposed and characterized. Each stage exploits nonlinear polarization rotation and self-phase modulation. The obtained improved TF with very flat top and bottom levels makes the scheme suitable for working as a reshaper in all-optical regeneration. The effectiveness of the device is verified in regenerating both nonreturn-to-zero (NRZ) and return-to-zero (RZ) data signals up to 40 Gb/s. Bit error rate measurements demonstrate increased threshold margin and extinction ratio improvement.
ABSTRACT
A colorless all-optical scheme performing the subtraction and addition of phases between phase-shift keying (PSK) signals exploiting cascaded sum and difference frequency generation in a periodically poled lithium niobate waveguide is introduced and experimentally demonstrated. The subtraction of phases of two 40 Gb/s differential quadrature PSK signals has been experimentally tested and performances have been analyzed in terms of bit error rate measurements.
ABSTRACT
We propose and experimentally demonstrate single-shot, real-time ultrashort pulse intensity and phase characterization using a self-referenced and highly sensitive (linear) technique. The proposed method is based on a direct reconstruction of the spectral phase of the pulse-under-test (PUT) from three different measured spectra, two of which are obtained by a suitable time-synchronized electro-optic intensity modulation of the PUT. The required set of spectra are temporally interleaved and mapped along the time domain by linear dispersion for single-shot acquisition using a real-time scope. A dynamic nonlinear compression experiment of a picosecond pulse is fully monitored in real time using the proposed method.
ABSTRACT
A self-reference, single-shot characterization technique is proposed and demonstrated for simultaneously measuring the instantaneous frequencies and phases of multi-wavelength optical signals using a single processing and detection platform. The technique enables direct real-time optical sampling of the instantaneous frequencies of amplitude and/or phase modulated signals simultaneously at different wavelengths without requiring the use of any optical reference. Simultaneous real-time instantaneous frequency and phase measurements of a chirped 1 GHz-sinusoid intensity modulation signal and a 3 Gbps-PRBS (pseudo-random binary sequence) phase-modulated signal at two different wavelength channels have been performed for the proof-of-concept demonstration.
