The mode of interfragmentary movement affects bone formation and revascularization after callus distraction.

Callus distraction is sometimes associated with a delay in the maturation process and serious complications. It is believed that these complications are often caused by instability of the bone segment fixation. Typical fixation devices, such as ring-fixators, show significant deformations in all directions under external loading and muscle forces. This leads to axial compression and tension as well as shear movements in the healing area. Herein we investigated the hypothesis that the direction of interfragmentary movement after callus distraction affects the bone formation and revascularization during the maturation process. Two custom fixator systems were designed to apply a protocol of lateral callus distraction and subsequent cyclic stimulation of the regenerate tissue. One fixator system was used to apply either compressive or tensile stimulation while the other was used to apply shearing stimulation. The fixators were applied to the tibial surface of the right hind leg of sheep specimens. During lateral callus distraction, a titanium plate was elevated by 0.275 mm perpendicular to the long axis of the bone twice daily, resulting in a 5.5 mm gap at the end of the ten-day distraction phase. Following a seven-day consolidation phase, the regenerate in the gap between tibial cortex and titanium plate was stimulated once daily by cyclic movement for 120 cycles. The stimulation was applied for 18 days with amplitudes of 0.6 mm in compression (Group C) or tension (Group T), or a 1.0 mm shear amplitude (Group S). Seven weeks postoperatively the specimens were analyzed for quantity of bone formation, the presence of cartilage and fibrous tissue, and blood vessel density. There was a significantly higher blood vessel density (4.6 ± 1.6%) in Group C than in Group T (1.2 ± 0.4%) or Group S (1.0 ± 0.5%) (p < 0.01). The amount of bone was significantly higher in Group C (25.6% ± 13.0%) than in Group T (13.5 ± 4.9%) (p < 0.05). Group S showed a similar amount of bone (14.0 ± 10.7%) to Group T. The results show that bone formation and revascularization are dependent on the direction of interfragmentary movement and that the cyclic compression best stimulates the healing process.

Evolution of callus tissue behavior during stable distraction osteogenesis.

Multiple studies have sought to characterize the mechanical behavior of callus tissue in vivo during distraction osteogenesis. The aims of such studies are to understand the mechanobiology of distraction and elucidate the complex viscoelasticity and evolution of the tissue. The former objective has direct clinical relevance to surgical technique and process control while the latter is necessary for the calibration and validation of the predictive healing models. Such models seek to reduce the researcher's dependence on animal studies and prospectively allow improved surgical planning. To date, no study has been capable of controlling the mechanical conditions sufficiently enough to decouple the distraction process from the secondary mechanical stimulation associated with the finite stiffness of the fixation constructs employed. It is the goal of this work to understand the mechanobiology of pure distraction as well as characterize viscoelastic tissue behavior under precisely defined mechanical conditions. This is achieved using a novel lateral distraction model. The structural integrity of the bone is maintained, allowing the collection of force relaxation data due to a stepwise distraction process without the superimposed influence of secondary mechanical stimulation. The average instantaneous modulus increases from approximately 2 kPa to approximately 1100 kPa while the equilibrium modulus increases from approximately 0 kPa to 200 kPa over the distraction period.

Novel systems for the application of isolated tensile, compressive, and shearing stimulation of distraction callus tissue.

BACKGROUND: Distraction osteogenesis is a procedure widely used for the correction of large bone defects. However, a high complication rate persists, likely due to insufficient stability during maturation. Numerical fracture healing models predict bone regeneration under different mechanical conditions allowing fixation stiffness optimization. However, most models apply a linear elastic material law inappropriate for the transient stresses/strains present during limb lengthening or segment transport. They are also often validated using in vivo osteotomy models lacking precise mechanical regulation due to the unavoidable stimulation of secondary interfragmentary motion during ambulation under finitely stiff fixation. Therefore, in order to create a robust numerical model of distraction osteogenesis, it is necessary to both characterize the new tissue's viscoelasticity during distraction and determine the influence of strictly isolated stimulation in each loading mode (tension, compression, and shear) to account for potential differences in mechanical and histological response. AIM: Two electromechanical fixators with integrated load cells were designed to precisely perform and monitor in vivo lateral distraction and isolated stimulation in sheep tibiae using a mobile, hydroxyapatite-coated titanium plate. The novel surgical procedure circumvents osteotomy, eliminating the undesirable and unquantifiable mechanical stimulation during ambulation. METHODS: After a 10-day post-surgery latency period, two 0.275 mm distraction steps were performed daily for 10 days. The load cell collected data before, during, and after each distraction step and was terminated after no less than one minute from the time of distraction. A 7-day consolidation period separated the distraction phase and 18-day stimulation phase. Stimulation was carried out in isolated tension, compression, or shear while recording force/time data. Each stimulation session consisted of 120 cycles with a magnitude of either 0.1 mm or 0.6 mm in the tension and compression groups and 1.0 mm in the shear group. The animals were euthanized after a 3-day holding period following stimulation. RESULTS: Our initial results show that the tissue progressively stiffens and maintains an increasingly large residual traction. The force curves during compressive stimulation show a progressive drift from compression toward tension. We hypothesize that this behavior may be due to the preferential flow of fluid outward from the tissue and a greater resistance to reabsorption during the plate's return to the starting position.