Particulate matter chemical component concentrations and sources in settings of household solid fuel use.

Particulate matter (PM) air pollution derives from combustion and non-combustion sources and consists of various chemical species that may differentially impact human health and climate. Previous reviews of PM chemical component concentrations and sources focus on high-income urban settings, which likely differ from the low- and middle-income settings where solid fuel (ie, coal, biomass) is commonly burned for cooking and heating. We aimed to summarize the concentrations of PM chemical components and their contributing sources in settings where solid fuel is burned. We searched the literature for studies that reported PM component concentrations from homes, personal exposures, and direct stove emissions under uncontrolled, real-world conditions. We calculated weighted mean daily concentrations for select PM components and compared sources of PM determined by source apportionment. Our search criteria yielded 48 studies conducted in 12 countries. Weighted mean daily cooking area concentrations of elemental carbon, organic carbon, and benzo(a)pyrene were 18.8 µg m-3 , 74.0 µg m-3 , and 155 ng m-3 , respectively. Solid fuel combustion explained 29%-48% of principal component/factor analysis variance and 41%-87% of PM mass determined by positive matrix factorization. Multiple indoor and outdoor sources impacted PM concentrations and composition in these settings, including solid fuel burning, mobile emissions, dust, and solid waste burning.

The impact of biogas and fuelwood use on institutional kitchen air quality in Kampala, Uganda.

Experts have suggested that microscale biogas systems offer a source of renewable energy that improves indoor air quality, but such impacts have not been directly measured. This study documented cooking behaviors and measured 2.5-µm particulate matter (PM2.5 ), carbon monoxide (CO), and sulfur dioxide (SO2 ) concentrations within 14 institutional kitchens in Kampala, Uganda, that prepare meals using biogas (n=5), a mixture of biogas and fuelwood (n=3), and fuelwood (n=6). Small institutions (10-30 people) with biogas kitchens had 99% lower concentrations of PM2.5 (21 µg/m3 ) than fuelwood kitchens (3100 µg/m3 ). Larger institutions (>100 people) had biogas systems that produced insufficient gas and relied on fuelwood to meet over 90% of their energy needs. PM2.5 concentrations in these biogas-firewood kitchens were equivalent to concentrations in fuelwood kitchens. Although concentrations of hydrogen sulfide (H2 S) in biogas were as high as 2000 ppm, 75% of systems had undetectable H2 S levels (<100 ppm) in the biogas. Kitchens using biogas with high H2 S had correspondingly higher SO2 concentrations in the kitchen air. However, even the highest SO2 concentration in biogas kitchens (150 µg/m3 ) was lower than SO2 concentration in fuelwood kitchens (390 µg/m3 ). The results suggest that biogas systems can offer air quality improvements if sized properly for energy demands.

Sources, evolution and impacts of EC and OC in snow on sea ice: a measurement study in Barrow, Alaska.

Based on the field measurements in Barrow, Alaska within the period of April-May 2015, we investigate the sources and variations of elemental carbon (EC) and organic carbon (OC) in the surface layer of snowpack on sea ice, and estimate their effects on the sea ice albedo. Results show that the snow OC in Barrow are from natural sources (e.g. terrestrial higher plants and micro-organisms) mainly, as well as biomass burning (e.g. forest fires and straw combustion) as an important part. Both EC and OC can accumulate at the snow surface with snow melt. The variations in EC and OC and liquid water content in the snow layer are well consistent during the snow-melting period. A higher rate of snow melt implied a more efficient enrichment of EC and OC. In the last phase of snow melt, the concentration increased to a maximum of 16.2 ng/g for EC and 128 ng/g for OC, which is ∼10 times larger than those before snow melt onset. Except for the dominant influence of melt amplification mechanism, the variation in concentrations of EC and OC could be disturbed by the air temperature fluctuation and snowfall. Our study indicates that the light-absorbing impurities contributed 1.6%-5.1% to the reduction in sea ice albedo with melt during the measurement period. The significant period of light-absorbing impurities influencing on sea ice albedo begins with the rapid melting of overlying snow and ends before the melt ponds formed widely, which lasted for about 10 days in Barrow, 2015.

The discoloration of the Taj Mahal due to particulate carbon and dust deposition.

The white marble domes of the Taj Mahal are iconic images of India that attract millions of visitors every year. Over the past several decades the outer marble surfaces of the Taj Mahal have begun to discolor with time and must be painstakingly cleaned every several years. Although it has been generally believed that the discoloration is in some way linked with poor air quality in the Agra region, the specific components of air pollution responsible have yet to be identified. With this in mind, ambient particulate matter (PM) samples were collected over a one-year period and found to contain relatively high concentrations of light absorbing particles that could potentially discolor the Taj Mahal marble surfaces, that include black carbon (BC), light absorbing organic carbon (brown carbon, BrC), and dust. Analyses of particles deposited to marble surrogate surfaces at the Taj Mahal indicate that a large fraction of the outer Taj Mahal surfaces are covered with particles that contain both carbonaceous components and dust. We have developed a novel approach that estimates the impact of these deposited particles on the visible light surface reflectance, which is in turn used to estimate the perceived color by the human eye. Results indicate that deposited light absorbing dust and carbonaceous particles (both BC and BrC from the combustion of fossil fuels and biomass) are responsible for the surface discoloration of the Taj Mahal. Overall, the results suggest that the deposition of light absorbing particulate matter in regions of high aerosol loading are not only influencing cultural heritage but also the aesthetics of both natural and urban surfaces.

Patterns and predictors of personal exposure to indoor air pollution from biomass combustion among women and children in rural China.

UNLABELLED: Indoor air pollution (IAP) from domestic biomass combustion is an important health risk factor, yet direct measurements of personal IAP exposure are scarce. We measured 24-h integrated gravimetric exposure to particles < 2.5 µm in aerodynamic diameter (particulate matter, PM2.5) in 280 adult women and 240 children in rural Yunnan, China. We also measured indoor PM2.5 concentrations in a random sample of 44 kitchens. The geometric mean winter PM2.5 exposure among adult women was twice that of summer exposure [117 µg/m³ (95% CI: 107, 128) vs. 55 µg/m³ (95% CI: 49, 62)]. Children's geometric mean exposure in summer was 53 µg/m³ (95% CI: 46, 61). Indoor PM2.5 concentrations were moderately correlated with women's personal exposure (r=0.58), but not for children. Ventilation during cooking, cookstove maintenance, and kitchen structure were significant predictors of personal PM2.5 exposure among women primarily cooking with biomass. These findings can be used to develop exposure assessment models for future epidemiologic research and inform interventions and policies aimed at reducing IAP exposure. PRACTICAL IMPLICATIONS: Our results suggest that reducing overall PM pollution exposure in this population may be best achieved by reducing winter exposure. Behavioral interventions such as increasing ventilation during cooking or encouraging stove cleaning and maintenance may help achieve these reductions.

Organic compound characterization and source apportionment of indoor and outdoor quasi-ultrafine particulate matter in retirement homes of the Los Angeles Basin.

UNLABELLED: Quasi-ultrafine (quasi-UF) particulate matter (PM(0.25)) and its components were measured in indoor and outdoor environments at four retirement communities in Los Angeles Basin, California, as part of the Cardiovascular Health and Air Pollution Study (CHAPS). The present paper focuses on the characterization of the sources, organic constituents and indoor and outdoor relationships of quasi-UF PM. The average indoor/outdoor ratios of most of the measured polycyclic aromatic hydrocarbons (PAHs), hopanes, and steranes were close to or slightly lower than 1, and the corresponding indoor-outdoor correlation coefficients (R) were always positive and, for the most part, moderately strong (median R was 0.60 for PAHs and 0.74 for hopanes and steranes). This may reflect the possible impact of outdoor sources on indoor PAHs, hopanes, and steranes. Conversely, indoor n-alkanes and n-alkanoic acids were likely to be influenced by indoor sources. A chemical mass balance model was applied to both indoor and outdoor speciated chemical measurements of quasi-UF PM. Among all apportioned sources of both indoor and outdoor particles, vehicular emissions was the one contributing the most to the PM(0.25) mass concentration measured at all sites (24-47% on average). PRACTICAL IMPLICATIONS: Although people (particularly the elderly retirees of our study) generally spend most of their time indoors, a major portion of the PM(0.25) particles they are exposed to comes from outdoor mobile sources. This is important because, an earlier investigation, also conducted within the Cardiovascular Health and Air Pollution Study (CHAPS), showed that indoor-infiltrated particles from mobile sources are more strongly correlated with adverse health effects observed in the elderly subjects living in the studied retirement communities compared with other particles found indoors (Delfino et al., 2008).

Atmospheric mercury speciation in Yellowstone National Park.

Atmospheric concentrations of elemental mercury (Hg(0)), reactive gaseous Hg (RGM), and particulate Hg (pHg) concentrations were measured in Yellowstone National Park (YNP), U.S.A. using high resolution, real time atmospheric mercury analyzers (Tekran 2537A, 1130, and 1135). A survey of Hg(0) concentrations at various locations within YNP showed that concentrations generally reflect global background concentrations of 1.5-2.0 ng m(-3), but a few specific locations associated with concentrated geothermal activity showed distinctly elevated Hg(0) concentrations (about 9.0 ng m(-3)). At the site of intensive study located centrally in YNP (Canyon Village), Hg(0) concentrations did not exceed 2.5 ng m(-3); concentrations of RGM were generally below detection limits of 0.88 pg m(-3) and never exceeded 5 pg m(-3). Concentrations of pHg ranged from below detection limits to close to 30 pg m(-3). RGM and pHg concentrations were not correlated with any criteria gases (SO(2), NO(x), O(3)); however pHg was weakly correlated with the concentration of atmospheric particles. We investigated three likely sources of Hg at the intensive monitoring site: numerous geothermal features scattered throughout YNP, re-suspended soils, and wildfires near or in YNP. We examined relationships between the chemical properties of aerosols (as measured using real time, single particle mass spectrometry; aerosol time-of-flight mass spectrometer; ATOFMS) and concentrations of atmospheric pHg. Based on the presence of particles with distinct chemical signatures of the wildfires, and the absence of signatures associated with the other sources, we concluded that wildfires in the park were the main source of aerosols and associated pHg to our sampling site.

ACE-Asia intercomparison of a thermal-optical method for the determination of particle-phase organic and elemental carbon.

A laboratory intercomparison of organic carbon (OC) and elemental carbon (EC) measurements of atmospheric particulate matter samples collected on quartz filters was conducted among eight participants of the ACE-Asia field experiment The intercomparison took place in two stages: the first round of the intercomparison was conducted when filter samples collected during the ACE-Asia experiment were being analyzed for OC and EC, and the second round was conducted after the ACE-Asia experiment and included selected samples from the ACE-Asia experiment Each participant operated ECOC analyzers from the same manufacturer and utilized the same analysis protocol for their measurements. The precision of OC measurements of quartz fiber filters was a function of the filter's carbon loading but was found to be in the range of 4-13% for OC loadings of 1.0-25 microg of C cm(-2). For measurements of EC, the precision was found to be in the range of 6-21% for EC loadings in the range of 0.7-8.4 microg of C cm(-2). It was demonstrated for three ambient samples, four source samples, and three complex mixtures of organic compounds that the relative amount of total evolved carbon allocated as OC and EC (i.e., the ECOC split) is sensitive to the temperature program used for analysis, and the magnitude of the sensitivity is dependent on the types of aerosol particles collected. The fraction of elemental carbon measured in wood smoke and an extract of organic compounds from a wood smoke sample were sensitive to the temperature program used for the ECOC analysis. The ECOC split for the three ambient samples and a coal fly ash sample showed moderate sensitivity to temperature program, while a carbon black sample and a sample of secondary organic aerosol were measured to have the same split of OC and EC with all temperature programs that were examined.

Highly polar organic compounds present in wood smoke and in the ambient atmosphere.

Fine particulate matter emitted during wood combustion is known to contribute a significant fraction of the total fine aerosol concentration in the atmosphere of both urban and rural areas. In the present study, additional organic compounds that may act as wood smoke tracers in the atmosphere are sought. Polar organic compounds in wood smoke fine particulate matter are converted to their trimethylsilyl derivatives and analyzed by gas chromatography/mass spectrometry. Silylation enables the detection of n-alkanols, plant sterols, and a number of compounds derived from wood lignin that have not previously been reported in wood smoke samples, as well as levoglucosan and related sugar anhydrides formed during the combustion of cellulose. The concentrations of these compounds measured in source emissions are compared to the concentrations in atmospheric fine particle samples collected at a rural background site and at two urban sites in California's San Joaquin Valley. On the basis of this analysis, the sugar anhydrides galactosan and mannosan can be listed along with levoglucosan as being among the most abundant organic compounds detected in all samples.

Measurement of emissions from air pollution sources. 3. C1-C29 organic compounds from fireplace combustion of wood.

Organic compound emission rates for volatile organic compounds (VOC), gas-phase semivolatile organic compounds, and particle-phase organic compounds are measured from residential fireplace combustion of wood. Firewood from a conifer tree (pine) and from two deciduous trees (oak and eucalyptus) is burned to determine organic compound emissions profiles for each wood type including the distribution of the alkanes, alkenes, aromatics, polycyclic aromatic hydrocarbons (PAH), phenol and substituted phenols, guaiacol and substituted guaiacol, syringol and substituted syringols, carbonyls, alkanoic acids, resin acids, and levoglucosan. Levoglucosan is the major constituent in the fine particulate emissions from all three wood types, contributing 18-30% of the fine particulate organic compound emissions. Guaiacol (2-methoxyphenol), and guaiacols with additional substituents at position 4 on the molecule, and resin acids are emitted in significant quantities from pine wood combustion. Syringol (2,6-dimethoxyphenol) and syringols with additional substituents at position 4 on the molecule are emitted in large amounts from oak and eucalyptus firewood combustion, but these compounds are not detected in the emissions from pine wood combustion. Syringol and most of the substituted syringols are found to be semivolatile compounds that are present in both the gas and particle phases, but two substituted syringols that have not been previously quantified in wood smoke emissions, propionylsyringol and butyrylsyringol, are found exclusively in the particle phase and can be used to help trace hardwood smoke particles in the atmosphere. Benzene, ethene, and acetylene are often used as tracers for motor vehicle exhaust in the urban atmosphere. The contribution of wood smoke to the ambient concentrations of benzene, ethene, and acetylene could lead to an overestimate of the contribution of motor vehicle tailpipe exhaust to atmospheric VOC concentrations.