ABSTRACT
Dental restorations made from alloys corrode during their service time. In cases of suspected toxic or allergic reactions to the corrosion products, the composition of the intraoral dental restorations has to be determined. The sample materials can be obtained intra-orally in a non-destructive manner using the chipping test. Metallic shavings are extracted with the aid of a dental stone and graphite carrier platelet, which is then transferred to an electron microscope for electro dispersive X-ray (EDX) analysis. The chipping test suffers from a rather complicated and error-prone procedure of obtaining and transferring the samples. OBJECTIVE: The objective of the present study was the validation of a simplified method for non-destructive in-situ extraction of dental alloy samples, using a newly developed dental bur made from carbon fiber reinforced polyether ether ketone (PEEK), which at the same time serves as an electrically conductive sample carrier for EDX analysis. METHODS: Fifteen burs for dental hand pieces were manufactured from carbon fiber reinforced PEEK, using two formulations. The burs were passed over precious and non-precious dental alloys with different rotation speeds. The alloy samples embedded in the burs were analyzed using EDX and compared to a control. RESULTS: The burs manufactured from PEEK containing 30% short carbon fibers proved sufficiently robust for sample extraction even from the harder non-precious metals. The results of EDX analysis were in accordance with the control,no statistical significant differences, free of contamination, and were not affected by rotation speed,higher as 20%. SIGNIFICANCE: The proposed method is valid, practical and constitutes an improvement over the traditional chipping test.
Subject(s)
Dental Alloys , Dental Materials , Corrosion , Dental High-Speed Equipment , KetonesABSTRACT
Dental implants are mostly fabricated of titanium. Potential problems associated with these implants are discussed in the literature, for example, overloading of the jawbone during mastication due to the significant difference in the elastic moduli of titanium (110 GPa) and bone (≈1-30 GPa). Therefore poly-ether-ether-ketone (PEEK) could represent an alternative biomaterial (elastic modulus 3-4 GPa). Endolign(®) represents an implantable carbon fiber reinforced (CFR)-PEEK including parallel oriented endless carbon fibers. According to the manufacturer it has an elastic modulus of 150 GPa. PEEK compounds filled with powders show an elastic modulus around 4 GPa. The aim of the present finite element analysis was to point out the differences in the biomechanical behavior of a dental implant of Endolign(®) and a commercial powder-filled PEEK. Titanium served as control. These three materials were used for a platform-switched dental implant-abutment assembly, whereas Type 1 completely consisted of titanium, Type 2 of a powder-filled PEEK and Type 3 of Endolign(®). A force of 100 N was applied vertically and of 30° to the implant axis. All types showed a minimum safety factor regarding the yield strength of cortical bone. However, within the limits of this study the Type 2 implant showed higher stresses within the adjacent cortical bone than Type 1 and Type 3. These implant assemblies showed similar stress distributions. Endless carbon fibers give PEEK a high stability. Further investigations are necessary to evaluate whether there is a distinct amount of endless carbon fibers causing an optimal stress distribution behavior of CFR-PEEK.
