ABSTRACT
We report here in the fabrication of enhanced thermal conductive pathway nanocomposites of boron nitride (BN)-coated polymethylsilsesquioxane (PMSQ) composite beads using isopropyl alcohol (IPA) as a mixing medium. Exfoliated and size-reduced boron nitride particles were successfully coated on the PMSQ beads and explained by surface charge differences. A homogeneous dispersion and coating of BN on the PMSQ beads using IPA medium was confirmed by SEM. Each condition of the composite powder was carried into the stainless still mould and then hot pressed in an electrically heated hot press machine. Three-dimensional percolation networks and conductive pathways created by exfoliated BN were precisely formed in the nanocomposites. The thermal conductivity of nanocomposites was measured by multiplying specific gravity, specific heat, and thermal diffusivity, based upon the laser flash method. Densification of the composite resulted in better thermal properties. For an epoxy reinforced composite with 30 vol% BN and PMSQ, a thermal conductivity of nine times higher than that of pristine PMSQ was observed.
Subject(s)
Boron Compounds/chemistry , Nanostructures/chemistry , Nanostructures/ultrastructure , Organosilicon Compounds/chemistry , Polymers/chemistry , Adsorption , Macromolecular Substances/chemistry , Materials Testing , Molecular Conformation , Particle Size , Specific Gravity , Surface Properties , Thermal ConductivityABSTRACT
This paper describes fabrication of a poly(dimethyl siloxane) (PDMS)-based chip to analyze multiple protein interactions utilizing glycidyl methacrylate (GMA) photopolymer for a site-specific immobilization of capture proteins in a closed system. First, using one direction channels of a PDMS mold having cross-channels, GMA micropads were prepared by photopolymerizing GMA solution by 365 nm light irradiation at predetermined positions. After the first mold was replaced with a second mold having higher height or directly without mold changing, capture proteins were allowed to be covalently immobilized onto the surface of the epoxide-activated GMA pads. Following immobilization, poly(ethylene glycol) diacrylate (PEG-DA) precursor was photopolymerized at specific regions to generate plugs for prevention of mixing between different sample injection channels, diminishing the need of a mold changing for sample injections. Final chip was assembled by connecting separated sample injection channels using a connector mold. The viability of this strategy was successfully demonstrated by simultaneous detection of two different antigen-antibody interactions.
