ABSTRACT
MnxOy coated over TiO2 nanotube array substrate was doped with Mo and polyaniline (PANI) and applied for electrochemical desulfurization of concentrated sulfide (HS-) solutions at basic pH, typical of biogas scrubbing solutions and industrial wastewater. Mo and PANI co-dopants significantly enhanced the anode activity towards sulfide oxidation and ensured its complete stability even in highly corrosive sulfide solutions (e.g., 200 mM HS-). This was due to the increased electrochemically active surface area, improved coating conductivity and reduced charge transfer resistance. The (electro)catalytic oxidation of HS- demonstrated robust performance with very limited impact of different operational parameters (e.g., dissolved oxygen, anode potential, HS- concentration). Due to the formation of elemental sulfur (S0) layer at the anode surface at basic pH, longer term anode usage requires its periodic removal. Chemical dissolution of S0 with toluene allows its rapid removal without affecting the anode activity, and easy recrystallization and recovery of pure sulfur.
ABSTRACT
The experimental group included 68 children over 6 years of age who had recovered from COVID-19. The control group included 22 children over 6 years of age who have never had COVID-19. Research methods included neurological examination, verification of cognitive status, examination by an otolaryngologist, and smell and taste assessment. The examination was performed 6-8 weeks after COVID-19 recovery and after 1 year in some patients. Children who recovered from COVID-19 had a reduction in their ability to smell compared to children who had never had COVID-19. The olfactory thresholds and taste identification scores after recovery from COVID-19 were identical, whether the parents had reported anosmia in their children during COVID-19 or not, and irrespective of hyperthermia level and the presence or absence of headache and hyperhidrosis during COVID-19. Analysis of correlation with neuropsychiatric symptoms showed no differences in the olfactory thresholds in children irrespective of the presence of neuropsychiatric symptoms (tics, tremors, enuresis, compulsive movements, seizures, speech disorders, attention deficit, and easy fatigability) both in general, and in particular among subjects performing or not any compulsive movements, and experiencing or not a combination of easy fatigability and daytime sleepiness. Evidence suggests that in children and adolescents, partial hyposmia is associated with depressive symptoms, varying in severity from low to high, but symptoms of depression were not caused by COVID-19 infection itself. Analysis in subgroups with different degrees of state and trait anxiety did not reveal any significant differences in the olfactory threshold. A re-examination of 21 children was performed after 1 year. An objective olfactometric examination showed that the sensitivity to odorants increased significantly. In 1 year, we compared the thresholds of smell in children who had COVID-19 and those who did not have this disease: olfactory sensitivity after COVID-19 in children is restored to normal values. Schulte correction test showed that none of 14 children with asthenic manifestations in the form of fluctuations or exhaustion when performing the test immediately after COVID-19 had these manifestations after 1 year. Thus, asthenization of cognitive activity was recorded within the next 1.5 months after suffering from COVID-19 but was absent after 1 year.
ABSTRACT
Electrochemical oxidation of hydrogen sulfide and its separation from the waste stream in the form of sulfur was studied at low-cost carbon-based porous materials, activated carbon felt (ACF) and graphite felt (GF). Both materials were capable of selective HS- oxidation to elemental sulfur in low-conductivity solutions (i.e., <1 mS cm-1), as well as in raw sewage. The HS- removal rate was ten times faster at ACF compared with GF electrode due to the higher surface area and chemisorption of HS-. To address the electrode passivation with the electrodeposited sulfur, different electrochemical recovery strategies were tested. GF could be only partially regenerated (i.e., 30% efficiency) using cathodic polarization. Also, both anodic and cathodic polarization improved the sulfide removal in the subsequent working cycle due to the introduction of new redox-active oxygen containing functional groups. Sulfur deposited at the ACF electrode could not be recovered by any of the investigated strategies. Thus, sulfur was incorporated into the carbon matrix and strongly bonded with the carbon functional groups at both GF and ACF electrodes. Although carbon-based electrodes have been widely investigated for electrochemical sulfide removal, this study demonstrates that their application is limited by low regeneration efficiency of the electrodeposited sulfur.
ABSTRACT
The aim of this work was to study the performance of a compost/ceramic bead biofilter (6:4 v/v) for the removal of gas-phase toluene and xylene at different inlet loading rates (ILR). The inlet toluene (or) xylene concentrations were varied from 0.1 to 1.5gm-3, at gas flow rates of 0.024, 0.048 and 0.072m3h-1, respectively, corresponding to total ILR varying between 7 and 213gm-3h-1. Although there was mutual inhibition, xylene removal was severely inhibited by the presence of toluene than toluene removal by the presence of xylene. The biofilter was also exposed to transient variations such as prolonged periods of shutdown (30days) and shock loads to envisage the response and recuperating ability of the biofilter. The maximum elimination capacity (EC) for toluene and xylene were 29.2 and 16.4gm-3h-1, respectively, at inlet loads of 53.8 and 43.7gm-3h-1.
Subject(s)
Composting , Toluene , Xylenes , Air Pollutants , Biodegradation, Environmental , FiltrationABSTRACT
In the present paper, we describe a new and original method to obtain transparent, siloxane-based composites, with high refractive index (up to 1.68). The method is based on the decomposition of Zn-siloxane, mixed with a poly-(dimethyl)-block-(phenyl)siloxane matrix in different ratios. It was found that after treatment of such mixed metal-containing polymer blend with H2S, the nanoparticles of ZnS are formed, with the size in a 1- to 5-nm range, which allow effective increase of the refractive index of the nanocomposite mixture with poly-(dimethyl)-block-(phenyl)siloxane without loss of film transparency. We succeded to increase the refractive index from 1.54 (pure matrix) up to 1.68 (composite with a ZnS content of 4.6 vol.%). The siloxane-based compositions are optically transparent, which makes it possible to use them as light-emitting diodes or solar cell sealants or adhesives.
