Single element Raman thermometry.

Despite a larger sensitivity to temperature as compared to other microscale thermometry methods, Raman based measurements typically have greater uncertainty. In response, a new implementation of Raman thermometry is presented having lower uncertainty while also reducing the time and hardware needed to perform the experiment. Using a modulated laser to excite the Raman response, the intensity of only a portion of the total Raman signal is leveraged as the thermometer by using a single element detector monitored with a lock-in amplifier. Implementation of the lock-in amplifier removes many sources of noise that are present in traditional Raman thermometry where the use of cameras preclude a modulated approach. To demonstrate, the portion of the Raman spectrum that is most advantageous for thermometry is first identified by highlighting, via both numerical prediction and experiment, those spectral windows having the largest linear dependence on temperature. Using such windows, the new technique, termed single element Raman thermometry (SERT), is utilized to measure the thermal profile of an operating microelectromechanical systems (MEMS) device and compared to results obtained with a traditional Raman approach. The SERT method is shown to reduce temperature measurement uncertainty by greater than a factor of 2 while enabling 3 times as many data points to be taken in an equal amount of time as compared to traditional Raman thermometry.

Reduction in the thermal conductivity of single crystalline silicon by phononic crystal patterning.

Phononic crystals (PnCs) are the acoustic wave equivalent of photonic crystals, where a periodic array of scattering inclusions located in a homogeneous host material causes certain frequencies to be completely reflected by the structure. In conjunction with creating a phononic band gap, anomalous dispersion accompanied by a large reduction in phonon group velocities can lead to a massive reduction in silicon thermal conductivity. We measured the cross plane thermal conductivity of a series of single crystalline silicon PnCs using time domain thermoreflectance. The measured values are over an order of magnitude lower than those obtained for bulk Si (from 148 W m(-1) K(-1) to as low as 6.8 W m(-1) K(-1)). The measured thermal conductivity is much smaller than that predicted by only accounting for boundary scattering at the interfaces of the PnC lattice, indicating that coherent phononic effects are causing an additional reduction to the cross plane thermal conductivity.

Invited Article: Simultaneous mapping of temperature and stress in microdevices using micro-Raman spectroscopy.

Analysis of the Raman Stokes peak position and its shift has been frequently used to estimate either temperature or stress in microelectronics and microelectromechanical system devices. However, if both fields are evolving simultaneously, the Stokes shift represents a convolution of these effects, making it difficult to measure either quantity accurately. By using the relative independence of the Stokes linewidth to applied stress, it is possible to deconvolve the signal into an estimation of both temperature and stress. Using this property, a method is presented whereby the temperature and stress were simultaneously measured in doped polysilicon microheaters. A data collection and analysis method was developed to reduce the uncertainty in the measured stresses resulting in an accuracy of +/-40 MPa for an average applied stress of -325 MPa and temperature of 520 degrees C. Measurement results were compared to three-dimensional finite-element analysis of the microheaters and were shown to be in excellent agreement. This analysis shows that Raman spectroscopy has the potential to measure both evolving temperature and stress fields in devices using a single optical measurement.