Obesity and Meniscal Transplant Failure: A Retrospective Cohort Study.

The purpose of this study was to analyze the effect of obesity and other clinical factors on the outcome of meniscal allograft transplantation (MAT) with transosseous fixation. A retrospective cohort study was performed on patients who underwent a MAT between 2002 and 2017. All the participants had a minimum follow-up period of 24 months. The variables assessed were age at the time of the transplant, side, sex, transplanted meniscus (lateral/medial), body mass index (BMI), smoking status, and previous surgeries. Lysholm, Tegner, and International Knee Documentation Committee (IKDC) test outcomes, and patient satisfaction were recorded. Image assessment was performed using plain standing X-rays and a follow-up magnetic resonance imaging scan. Thirty-five patients fulfilled the inclusion criteria. The mean follow-up time was of 75.7 standard deviation (SD) 43.4 months. Patients with a BMI ≥ 30 underwent medial meniscal transplants (88.9 vs. 42.3%, p = 0.022, respectively) more frequently. Obese patients had a significantly lower IKDC (48.6 SD 19.9 vs. 61.7 SD 13.1, p = 0.038, power: 57.5%) and Lysholm (60.3 SD 19.2 vs. 79.4 SD 14.3, p = 0.004, power: 88.7%) scores compared with nonobese patients. The satisfaction and Tegner scores were also lower in obese patients (55.6 vs. 80.7%, p = 0.136, and 2.8 SD 1.0 vs. 4.0 SD 1.9, p = 0.104, respectively); however, these differences were not statistically significant. Obese patients had higher rates of meniscal transplant failure compared with nonobese patients (adjusted hazard ratio: 11.8 [95% confidence interval: 1.5-91.4]). No differences were observed between obese and nonobese patients regarding age, sex, side, smoking status, and follow-up time. In this study, a BMI ≥ 30 kg/m2 resulted in higher MAT failure rates. Nonobese patients had better knee functional results compared with obese individuals.

Outcomes after repair of chronic bucket-handle tears of medial meniscus.

PURPOSE: The purpose of this study was to determine the outcomes after repair of chronic bucket-handle medial meniscal tears by use of magnetic resonance imaging, clinical examination, and patient-reported outcomes. METHODS: A retrospective review of patients with chronic bucket-handle medial meniscal tears that had been repaired with meniscal sutures was undertaken. The following criteria for inclusion were adopted: minimum tear length of 2 cm and chronic medial meniscal tear identified at the time of arthroscopy. The tears were susceptible to dislocation with probing. Data collected included demographic, clinical, radiologic, and surgical data. Postoperative healing was assessed with the clinical criteria of Barrett et al. The International Knee Documentation Committee rating, Lysholm score, and Tegner activity level were determined, and postoperative magnetic resonance imaging was used to evaluate healing in accordance with the criteria of Henning et al. RESULTS: Twenty-four patients fulfilled the inclusion criteria. The mean time from injury to surgery was 10 months (range, 2 to 60 months). Sixteen patients underwent anterior cruciate ligament reconstruction, 1 patient underwent posterior cruciate ligament reconstruction, and 6 patients underwent meniscus repair only. A median of 5 sutures (range, 3 to 6 sutures) were used for repair. Four cases (all of which had undergone meniscus repair only) required revision. Complete healing was achieved in 83% of cases according to the criteria of Barrett et al. The mean follow-up time was 48 months (range, 24 to 112 months). An International Knee Documentation Committee rating of A or B was achieved in the 20 patients who did not require revision. The median Lysholm score was 95 (range, 92 to 100). The median Tegner activity level before injury was 7, and it remained unchanged after surgery in all cases. CONCLUSIONS: This study showed that repair of chronic bucket-handle meniscal tears can lead to good clinical outcomes and a relatively low (17%) failure rate. In addition, repairs of isolated meniscal tears had a significantly higher risk of failure than repairs performed in conjunction with anterior cruciate ligament reconstruction. LEVEL OF EVIDENCE: Level IV, therapeutic case series.

Close-looped graft suturing improves mechanical properties of interference screw fixation in ACL reconstruction.

PURPOSE: In anterior cruciate ligament reconstruction with looped soft-tissue grafts, an interference screw is frequently used for tibial fixation. This study compared three alternatives thought to improve the initial mechanical properties of direct bioabsorbable interference screw fixation: suturing the graft to close the loop, adding a supplementary staple, or increasing the oversize of the screw diameter relative to the bone tunnel from 1 to 2 mm. METHODS: Twenty-eight porcine tibiae and porcine flexor digitorum profundus tendons were randomized into four testing groups: a base fixation using 10-mm-diameter screw with open-looped graft, base fixation supplemented by an extracortical staple, base fixation but closing the looped graft by suturing its ends, and base fixation but using an 11-mm screw. Graft and bone tunnel diameters were 9 mm in all specimens. Constructs were subjected to cyclic tensile load and finally pulled to failure to determine their structural properties. RESULTS: The main mode of failure in all groups was pull-out of tendon strands after slippage past the screw. The sutured graft group displayed significantly lower residual displacement (mean value reduction: 47-67 %) and higher yield load (mean value increase: 38-54 %) than any alternative tested. No other statistical differences were found. CONCLUSIONS: Suturing a soft-tissue graft to form a closed loop enhanced the initial mechanical properties of tibial fixation with a bioabsorbable interference screw in anterior cruciate ligament reconstructions using a porcine model, and thus, this may be an efficient means to help in reducing post-operative laxity and early clinical failure. No mechanical improvement was observed for an open-looped tendon graft by adding an extracortical staple to supplement the screw fixation or by increasing the oversize of the screw to tunnel diameter from 1 to 2 mm.

Augmentation technique for partial ACL ruptures using semitendinosus tendon in the over-the-top position.

The aim of this study is to present a surgical augmentation technique for partial ACL ruptures in which an isolated, autologous, double-bundle semitendinosus tendon graft is passed over the top of the femur, thus fully preserving the still-intact fibers of the ligament remnant. Between 1992 and 2006, 24 patients underwent ACL semitendinosus autograft reconstruction and were followed up for at least 2 years. The median follow-up was 6.2 years (2-15.6). At the last follow-up examination, the patients were evaluated using the International Knee Documentation Committee scale. Subjective and functional parameters were assessed using the Tegner activity scale and the Lysholm scale. Instrumental evaluation was carried out using the KT-1000 instrument. Sixteen of the 24 patients achieved an IKDC score of A. Of the remaining eight patients, six achieved an IKDC score of B, one an IKDC score of C, and one an IKDC score of D. According to the Tegner activity scale, the median pre-injury sports activity level was seven (5-9) and the median post-injury level was six (4-9), while the mean Lysholm scale score was 95 (90-100). Clinical and biomechanical studies have shown that reconstruction techniques that address both bundles of the ACL provide better rotational stability than techniques that address only a single bundle. Therefore, it seems logical than in patients with a partial rupture of the ACL, the intact bundle could be preserved and only the torn bundle would need to be reconstructed.

Anatomic double-bundle ACL reconstruction with femoral cortical bone bridge support using hamstrings.

While ACL reconstruction using single-tunnel and single-bundle techniques generally yields good clinical results, more and more studies are now reporting results that are not entirely satisfactory, as this type of reconstruction only exerts control over forward tibial shifting, not tibial rotation, when activities that exert high functional demands are undertaken. As a result, recent years have seen the appearance of numerous techniques for anatomic ACL reconstruction that reproduce both the anteromedial and posterolateral bundles of the ligament and therefore offer potentially improved rotational control. This article outlines a technique for anatomic ACL reconstruction. Said technique uses central and anteromedial portals, which afford a better perspective of the intercondylar notch. The main features of this technique are: (1) Double bone tunnels in the femur and tibia. The femoral tunnels are created using the out-in technique. (2) Double bundles with hamstring tendon grafts. (3) Tibial fixation by means of interference screws. (4) Femoral fixation in which the graft is supported by a cortical bone bridge and an interference screw in one of the tunnels. We feel that the main advantage of this technique is precisely that it introduces a new feature (a cortical femoral bone bridge) and is not necessarily dependent on specific double-bundle instrumentation, using only regular drill guides to create out-in femoral tunnels. This enables said tunnels to be located with ease and precision. The femoral fixation model itself, with the support provided by the cortical bone bridge, potentially guarantees a level of resistance that can be further increased with the aid of one or two interference screws, thus avoiding the need for post fixation techniques that require the use of screws or buttons.