ABSTRACT
Strengthening of alloys can be efficiently attained by the creation of harmonic structures: bimodal microstructures generated by controlled milling of the particulate precursors, which consist of coarse-grained cores embedded in a continuous fine-grained matrix. Here, we extend the concept of harmonic structures to metal matrix composites and analyze the effectiveness of such bimodal microstructures for strengthening composites consisting of a pure Al matrix reinforced with Fe3Al particles. Preferential microstructural refinement limited to the surface of the particles, where the Fe3Al phase is progressively fragmented, occurs during ball milling of the Al-Fe3Al composite powder mixtures. The refined surface becomes the continuous fine-grained matrix that encloses macro-regions with coarser reinforcing particles in the harmonic composites synthesized during subsequent powder consolidation. The generation of the bimodal microstructure has a significant influence on the strength of the harmonic composites, which exceeds that of the conventional material by a factor of 2 while retaining considerable plastic deformation. Finally, modeling of the mechanical properties indicates that the strength of the harmonic composites can be accurately described by taking into account both the volume fraction of reinforcement and the characteristic microstructural features describing the harmonic structure.
ABSTRACT
We have investigated the phase changes in CdTiO3 nanofibers as the annealing temperature of nanofibers was increased from 600 to 1200 °C. The nanofibers annealed at 600 °C were ilmenite with a very small amount of CdO. Upon annealing at 950 °C, CdO was completely removed. Annealing at 1000 °C yielded pure perovskite nanofibers, and at temperatures above 1100 °C rutile TiO2 nanofibers were obtained. Brunauer-Emmett-Teller (BET) analysis showed that with increase in annealing temperature the surface area of nanofibers was decreased. The nanofibers annealed at 600 °C have the higher surface area of â¼9.41 m(2)/g. Then oxygen sensors using CdTiO3 nanofibers annealed at 600 °C (ilmenite) and 1000 °C (perovskite) were fabricated. The sensitivity of the ilmenite nanofibers sensor was 2 times than that of the perovskite nanofibers sensor. The response and recovery times were 120 and 23 s, respectively, for the ilmenite nanofibers sensor, whereas response and recovery times were 156 and 50 s, respectively, for the perovskite nanofibers sensor. Better oxygen characteristics of ilmenite nanofibers are attributed to their large surface area and porosity. Therefore, we believe that ilmenite CdTiO3 nanofibers are potential candidates to develop practical oxygen sensors.
