X-ray absorption spectroscopy of the nucleotide bases at the carbon, nitrogen, and oxygen K-edges.

Near-edge X-ray absorption fine structure spectra of three pyrimidine (viz., cytosine, uracil, and thymine) and two purine (viz., adenine and guanine) nucleobases, which are the key constituents of DNA and RNA, were measured at the C, N, and O K-edges using the self-absorption-free partial electron yield mode. The nucleobase samples were prepared as highly pure native polycrystalline powder films. The spectra are analyzed in terms of the electronic structure of the nucleobases. Subtle chemical effects related to the molecular structures of these heterocyclic compounds with extended pi-electron systems are considered and discussed.

A spectroscopic study of self-assembled monolayer of porphyrin-functionalized oligo(phenyleneethynylene)s on gold: the influence of the anchor moiety.

Porphyrin-functionalized oligo(phenyleneethynylene)s (OPE) are promising molecules for molecular electronics applications. Three such molecules (1-3) with the common structure P-OPE-AG (P and AG are a porphyrin and anchor group, respectively) and different anchor groups, viz. an acetyl protected thiol, -S-COCH3 (1), an acetyl protected thiol with methylene linker, -CH2-S-COCH3 (2), and a trimethylsilylethynyl group, -C(triple bond)C-Si(CH3)3 (3) have been synthesized and the corresponding self-assembled monolayers (SAMs) on Au(111) substrates have been prepared. The integrity and structural properties of these films were studied by X-ray photoelectron spectroscopy and near-edge X-ray absorption fine structure spectroscopy. The results suggest that the films formed from 1 have a high orientational order with an almost upright orientation and dense packing of the molecular constituents, i.e. represent a high quality SAM. In contrast, molecule 2 formed disordered molecular layers on Au, even though the molecule-surface bonding (thiolate) is the same as in the case of molecule 1. This suggests that the methylene linker in molecule 2 has a strong impact on the quality of the resulting film, so that a well-ordered SAM cannot be formed. The silane system, 3, is also able to bind to the gold surface but the resulting SAM has a poor quality, being significantly disordered and/or comprised of strongly inclined molecules. The above results suggest that the nature of the anchor group along with a possible linker is an important parameter which, to a high extent, predetermines the entire quality of OPE-based molecular layers.

Is X-ray absorption spectroscopy sensitive to the amino acid composition of functional proteins?

We report, compare, and analyze near-edge X-ray absorption fine structure (NEXAFS) spectra of powder samples of four different functional proteins, namely, lysozyme, ovalbumin, bovine serum albumin, and type-I collagen, at all relevant absorption edges. The spectra of all of the above proteins were found to be quite similar and to exhibit minor differences only. Nevertheless, despite the general similarity, the spectra of the individual proteins are distinguishable, and some of the respective differences clearly correlate with their amino acid compositions. Further factors affecting the NEXAFS spectra of proteins beyond the building block approach are discussed.

NEXAFS spectroscopy of homopolypeptides at all relevant absorption edges: polyisoleucine, polytyrosine, and polyhistidine.

Carefully calibrated high-resolution low-noise near-edge X-ray absorption fine structure spectra of three homopolypetides, viz., polyisoleucine, polytyrosine, and polyhistidine at the C, N, and O K-edges, are compared with the respective spectra of parent amino acids and glycine-derived cyclic dipeptide, 2,5-diketopiperazine. An assignment of the spectral features related to the nitrogen and oxygen atoms constituting the peptide bond is suggested on the basis of a comparative analysis of the experimental spectra as well as theoretical calculations for 2,5-diketopiperazine within the real-space multiple-scattering formalism. A splitting of the pi*-feature in the N K-edge spectra is identified, which is probably sensitive to the dominant conformation type of the peptide molecule (i.e., alpha-helix vs beta-sheet).

Characterization of self-assembled monolayers of oligo(phenyleneethynylene) derivatives of varying shapes on gold: effect of laterally extended pi-systems.

Fully conjugated organic molecules, such as the oligo(phenyleneethynylene) (OPE) systems, are of growing interest within the field of molecular electronics, as is the self-assembly of well-defined molecular thin films with predefined functions. The structure and function of such films are intimately related and governed by the structures of their molecular constituents, through the intermolecular interactions and the interactions between the molecules and the substrate, onto which the film is assembled. Here we report on the synthesis of a series of three OPE derivatives, with the general structure phenylethynylene-aryl-ethynylenephenylene-headgroup, and the structural investigation of the self-assembled monolayers (SAMs) formed from them on Au(111) surfaces. The SAMs were characterized by infrared reflection-absorption spectroscopy, spectroscopic ellipsometry, high-resolution X-ray photoemission spectroscopy, and near-edge X-ray absorption fine structure spectroscopy. The effective thickness of the SAMs was observed to decrease as the pi-system of the aryl moiety of the OPE adsorbate was extended perpendicular to its molecular long axis. Changing the aryl moiety from benzene to naphthalene to anthracene resulted in lower molecular surface densities and larger molecular inclination. The average tilt angles for the benzene, naphthalene, and anthracene SAMs were found to be about 30 degrees , 40 degrees , and 42 degrees from the surface normal, respectively. For the largest adsorbate, the anthracene derivative, there is spectroscopic evidence suggesting the existence of nonequivalent binding sites. The differences observed between the SAMs are rationalized in terms of the shape of the adsorbates and the strength of the pi-pi interactions between them.

Monomolecular films of phthalocyanines: formation, characterization, and expelling by alkanethiols.

Adsorption of aluminum-2,3-naphthalocyanine (Al-PC) onto gold (111) substrate from the pure and mixed (with alkanethiols) solutions of the target molecules in ethanol was studied. The resulting films were characterized by X-ray photoelectron spectroscopy and near-edge X-ray absorption fine structure spectroscopy. The adsorption from the pure solution resulted in formation of an Al-PC monolayer composed of the strongly inclined molecules. However, a presence of only one molar percent of a thiolated compound (alkanethiol) in the primary solution led to the complete expelling of the Al-PC molecules from the substrate and formation of a one-component alkylthiolate monolayer. The results indicate that an equilibrium formation of mixed monolayers of rodlike thiolated molecules and relatively large planar-geometry molecules, whose interaction with the metal surface is mainly provided by the pi-electron system, is difficult to achieve or is in most cases even impossible under equilibrium conditions and requires an introduction of additional anchor moieties (e.g., thiols) into these molecules, as has been demonstrated by successful coadsorption of hexadecanethiol and thiolated tetraphenylporphyrin.

Self-assembled monolayers of ferrocene-substituted biphenyl ethynyl thiols on gold.

Homogeneous and mixed [with biphenylthiol (BPT)] self-assembled monolayers (SAMs) of ferrocene-substituted biphenyl ethynyl thiols (Fc) were prepared on Au(111) substrates and characterized by several complementary spectroscopic techniques. The mixed films were fabricated either by subsequent immersion of the substrates into the BPT and Fc solutions or by immersion of the substrate into a mixed solution of BPT and Fc. The first procedure resulted in the preparation of high-quality mixed SAMs, in which the Fc molecules were stochastically distributed in the BPT matrix and well-separated from each other. The portion of these molecules in such films could be precisely varied from ca. 7 to 42% by selection of the immersion time in the BPT solution. The films prepared from the mixed solution exhibited a phase separation between the Fc and BPT constituents. These films contained mostly the Fc molecules ( approximately 80-90%), showing, thus, a significant deviation from the relative content of the target molecules in the primary solution (a 1:1 ratio). This finding shows that the Fc molecules, when competing with BPT, preferably adsorb onto Au(111) substrate, suggesting a significant impact of the ferrocene groups onto the structure-building interactions responsible for molecular self-assembly.

Novel tripod ligands for prickly self-assembled monolayers.

The new tridentate thioether ligands PhSi(CH2SMe)3 (1) and Ph-p-C6H4Si(CH2SMe)3 (2) have been synthesised and used for the preparation of the chelates fac-[W(kappa3-1)(CO)3] and fac-[W(kappa3-2)(CO)3], which were characterised by single-crystal X-ray diffraction. 1 and 2 were used as tripodal adsorbate molecules for the fabrication of self-assembled monolayers (SAMs) on gold. Film formation from solution was investigated in situ by second harmonic generation (SHG) and ellipsometry, which revealed a two-stepped process (fast adsorption, followed by slow film ordering). SAMs of 2 on gold were further investigated by ex situ methods, viz. high-resolution X-ray photoelectron spectroscopy (HRXPS), Fourier transform infrared reflection absorption spectroscopy (FTIRRAS), and scanning tunneling microscopy (STM). The latter two methods indicated dense packing of the tripodal anchor groups on the surface, with a substantially lower density of the biphenyl pricks. HRXPS showed three different binding states of sulfur, including a standard thiolate-type and a coordination-type state.

Molecular self-assembly at bare semiconductor surfaces: preparation and characterization of highly organized octadecanethiolate monolayers on GaAs(001).

Through rigorous control of preparation conditions, organized monolayers with a highly reproducible structure can be formed by solution self-assembly of octadecanethiol on GaAs (001) at ambient temperature. A combination of characterization probes reveal a structure with conformationally ordered alkyl chains tilted on average at 14 +/- 1 degrees from the surface normal with a 43 +/- 5 degrees twist, a highly oleophobic and hydrophobic ambient surface, and direct S-GaAs attachment. Analysis of the tilt angle and film thickness data shows a significant mismatch of the average adsorbate molecule spacings with the spacings of an intrinsic GaAs(001) surface lattice. The monolayers are stable up to approximately 100 degrees C and exhibit an overall thermal stability which is lower than that of the same monolayers on Au[111] surfaces. A two-step solution assembly process is observed: rapid adsorption of molecules over the first several hours to form disordered structures with molecules lying close to the substrate surface, followed by a slow densification and asymptotic approach to final ordering. This process, while similar to the assembly of alkanethiols on Au[111], is nearly 2 orders of magnitude slower. Finally, despite differences in assembly rates and the thermal stability, exchange experiments with isotopically tagged molecules show that the octadecanethiol on GaAs(001) monolayers undergo exchange with solute thiol molecules at roughly the same rate as the corresponding exchanges of the same monolayers on Au[111].

Self-assembled monolayers from biphenyldithiol derivatives: optimization of the deprotection procedure and effect of the molecular conformation.

A series of biphenyl-derived dithiol (BDDT) compounds with terminal acetyl-protected sulfur groups and different structural arrangements of both phenyl rings have been synthesized and fully characterized. The different arrangements were achieved by introducing hydrocarbon substituents in the 2 and 2' positions of the biphenyl backbone. The presented model compounds enable the investigation of the correlation between the intramolecular conformation and other physical properties of interest, like, e.g., molecular assembly or electronic transport properties. Here, the ability of these model compounds to form self-assembled monolayers (SAMs) on Au(111) and Ag(111) is investigated in details. The deprotection of the target molecules was performed in situ using either NH4OH or triethylamine (TEA) deprotection agent. The fabricated films were characterized by synchrotron-based high-resolution photoelectron spectroscopy and near-edge absorption fine structure spectroscopy. Whereas the deprotection by NH4OH was found to result in the formation of multilayer films, the deprotection by TEA allowed the preparation of densely packed BDDT SAMs with a noticeably higher orientational order and smaller molecular inclination on Ag than on Au. Introduction of the alkyl bridge between the individual rings of the biphenyl backbone did not lead to a noticeable change in the structure and packing density of the BDDT SAMs as long as the molecule had a planar conformation in the respective SAM. The deviation from this conformation resulted in the deterioration of the film quality and a decrease of the orientational order.

Solid-state near-edge X-ray absorption fine structure spectra of glycine in various charge states.

The experimental solid-state near-edge X-ray absorption fine structure spectra for a series of glycine-related samples including alpha-glycine, beta-glycine, glycinium chloride, glycinium trifluoroacetate, and sodium glycinate at the C, N, and O K-edges measured under identical conditions are reported and compared. An assignment of spectral features for alpha-glycine is proposed on the basis of extended theoretical simulations of polarization-dependent spectra performed within the real-space multiple-scattering formalism explicitly taking into account the intermolecular environment of a glycine molecule in a crystal.

Innershell absorption spectroscopy of amino acids at all relevant absorption edges.

The C, N, and O K-edge near-edge X-ray absorption fine structure spectra of the 22 most common proteinogenic alpha-amino acids in the zwitterionic form collected from solvent-free polycrystalline powder films in the partial electron yield mode are reported. Spectral features common to all amino acids, as well as distinctive fingerprints of specific subgroups of these compounds, are presented and discussed.

Effect of irradiation dose in making an insulator from a self-assembled monolayer.

A combination of functionalization and irradiation-induced cross-linking allows fabrication of stable metal film on top of an aromatic self-assembled monolayer, [1,1';4',1' '-terphenyl]-4,4' '-dimethanethiol (TPDMT) on Au. Using X-ray photoelectron spectroscopy, near-edge X-ray absorption fine structure spectroscopy, and ion-scattering spectroscopy the optimal irradiation dose for producing a stable metal overlayer was estimated to be 40-45 mC/cm2. This dose is necessary for complete 2D-polymerization and closure of transient channels, which would otherwise allow metal penetration into the SAM. What is also important, the majority of the thiol tail groups, responsible for 2D growth and chemical adherence of the metal film, remains intact even at this high dose. The optimal dose corresponds to a crossover in the response of the TPDMT film to ionizing radiation: the irradiation-induced processes progress fast at lower doses and saturate at higher doses.