ABSTRACT
Surface modification technique of secondary electron emission (SEE) characteristics of materials, which is utilized to suppress or promote the SEE from material surface under electron bombardment, has extensive applications in a variety of fields. Measurement of the secondary electron yield (SEY) and the secondary electron spectrum (SES) before and after surface modification is essential for the evaluation of effectiveness and the investigation of mechanism of material modification. A SEY and SES measurement system is reported in this article. The comparative measurements of the total SEY, the true SEY, the backscattered electron yield, and the SES of nickel and free-standing vertical graphene, which was grown in situ on the surface of nickel substrate by plasma enhanced chemical vapor deposition, were performed using this system. The measurement results demonstrate that this system could facilitate the study of surface modification on the SEE characteristics of conductive materials.
ABSTRACT
A pulsed synchronous linear accelerator (PSLA), based on the solid-state pulse forming line, photoconductive semiconductor switch, and high gradient insulator technologies, is a novel linear accelerator. During the prototype PSLA commissioning, the energy gain of proton beams was found to be much lower than expected. In this paper, the degradation of the energy gain is explained by the circuit and cavity coupling effect of the accelerating units. The coupling effects of accelerating units are studied, and the circuit topologies of these two kinds of coupling effects are presented. Two methods utilizing inductance and membrane isolations, respectively, are proposed to reduce the circuit coupling effects. The effectiveness of the membrane isolation method is also supported by simulations. The decoupling efficiency of the metal drift tube is also researched. We carried out the experiments on circuit decoupling of the multiple accelerating cavity. The result shows that both circuit decoupling methods could increase the normalized voltage.
ABSTRACT
Lens focused proton radiograph on thin objects is demonstrated using an 11-MeV proton cyclotron at China Academy of Engineering Physics. The proton beam exiting from the tested objects is focused onto the image plane by a magnetic lens system mitigating image blur caused by multiple Coulomb scattering. Both simulations and experiments show that clear images can be obtained with a lens system for the objects with thickness up to 2.7 × 10-2 g/cm2 and the error for the areal density measurement is measured to be less than 2.3%. For the objects with thickness between 2.7 × 10-3 g/cm2 and 2.7 × 10-2 g/cm2, 100-200 µm of spatial resolution is achieved.
ABSTRACT
Compact solid-state system is the main development trend in pulsed power technologies. A compact solid-state high-voltage nanosecond pulse generator with output voltage of 300 kV amplitude, 10 ns duration (FWHM), and 3 ns rise-time was designed for a dielectric wall accelerator. The generator is stacked by 15 planar-plate Blumlein pulse forming lines (PFL). Each Blumlein PFL consists of two solid-state planar transmission lines, a GaAs photoconductive semiconductor switch, and a laser diode trigger. The key components of the generator and the experimental results are reported in this paper.
ABSTRACT
Some research has been done on making a compact, portable pulse forming line. A kind of ceramic based on SrTiO(3) is used as the dielectric of the planar pulse forming line. The ceramic's dielectric constant is around 300 and can store more energy than water with the same volume. However, it is not easy to manufacture the large ceramic bulk but we did successfully manufacture 80 x 10 x 6 cm(3) ceramic bulks. Using this kind of ceramic bulk as the dielectric, we successfully made a compact, portable line that generated a voltage pulse up to 150 kV with a duration of about 92 ns.
