ABSTRACT
We demonstrate the detection of dipicolinic acid, (DPA), a biomarker of bacterial spores for Bacillus anthracis, 2,4-Dinitrotoluene (DNT) and picric acid (PA) nitroaromatic hazardous chemicals on ultra-sensitive, reusable femtosecond laser textured Au nanostructures decorated with hierarchical AuNPs as a SERS substrate. The AuNPs were achieved by ablating an Au sheet using two different laser scan speeds (1 and 0.1 mm/s) in linear and crossed patterns. The morphological studies revealed dense hierarchical nanostructures decorated with spherical AuNPs possessing 30-40 nm in size in 0.1 mm/s laser scan. The limits of detection (LOD) of the sensor were determined from the detailed SERS measurements and were estimated to be 0.83 pg/L, 3.6 pg/L and 2.3 pg/L for DPA, DNT, and PA, respectively. To the best of our knowledge, the achieved sensitivity is nearly 2 orders improved for DPA when compared with the currently reported LODs using other techniques and 1 order in the case of SERS. Moreover, for DNT and PA the LODs were found to be either superior or comparable with recent reports. We have also demonstrated the competence of our SERS substrates by testing a few real samples (water spiked with these analytes) and again obtained very good sensitivity.
ABSTRACT
We demonstrate an ultrafast laser-ablated hierarchically patterned silver nanoparticle/graphene oxide (AgNP/GO) hybrid surface-enhanced Raman scattering (SERS) substrate for highly sensitive and reproducible detection of an explosive marker 2,4-dinitrotoluene (2,4-DNT). A hierarchical laser-patterned silver sheet (Ag-S) is achieved by ultrafast laser ablation in air with pulse energies of 25, 50, and 100 µJ. Multiple laser pulses at a wavelength of 800 nm and a pulse repetition rate of 50 fs at 1 kHz are directly focused on Ag-S to produce and deposit AgNPs onto Ag-S. The surface morphology of ablated Ag-S was evaluated using atomic force microscopy, optical profilometry, and field emission scanning electron microscopy (FESEM). A rapid increase in the ablation rate with increasing laser energy was observed. Selected area Raman mapping is performed to understand the intensity and size distribution of AgNPs on Ag-S. Further, GO was spin-coated onto the AgNPs produced by ultrafast ablation on Ag-S. The hierarchical laser-patterned AgNP/GO hybrid structure was characterized using FESEM, high-resolution transmission electron microscopy, X-ray diffraction, Fourier transform infrared spectroscopy, and Raman spectroscopy. Further, hierarchical laser-patterned AgNP/GO hybrid structures have been utilized as SERS-active substrates for the selective detection of 2,4-DNT, an explosive marker. The developed SERS-active sensor shows good stability and high sensitivity up to picomolar (pM) concentration range with a Raman intensity enhancement of â¼1010 for 2,4-DNT. The realized enhancement of SERS intensity is due to the cumulative effect of GO coated on Ag-S as a proactive layer and AgNPs produced by ultrafast ablation.
ABSTRACT
Polyaniline (PAni)/Se nanocomposites have been synthesized in different compositions employing chemical route and shown excellent field emission behaviour. Detailed studies on the field emission for all composites with different concentrations of dopant are performed in an indigenously fabricated set up in a vacuum chamber with a base pressure of 10(-6) Torr at room temperature and analysed with current density versus Electric field (J-E) and Fowler-Nordheim (FN) plots. Comparative field emission results showed that 10% (w/w) doped PAni/Se nanocomposite depicts highest emission characteristics, current density and field enhancement factor with turn-on field as low as 1.2 V/µm in comparison with other composites, while pure PAni shows no field emission characteristics. These composites have also been characterized by Scanning Electron Microscope (SEM) and Fourier Transform Infrared Spectrometry (FTIR). FTIR results supply the evidence for the occurrence of the polymer in its conducting state. The ease of synthesis route and interesting field emission properties recommend these composites as a promising material for field emission based applications in vacuum micro-nanoelectronic devices and also for plastic display industry.
