Analysis of the lipid extraction performance in a cascade process for Scenedesmus almeriensis biorefinery.

BACKGROUND: Microalgae have attracted considerable interest due to their ability to produce a wide range of valuable compounds. Pulsed Electric Fields (PEF) has been demonstrated to effectively disrupt the microalgae cells and facilitate intracellular extraction. To increase the commercial viability of microalgae, the entire biomass should be exploited with different products extracted and valorized according to the biorefinery scheme. However, demonstrations of multiple component extraction in series are very limited in literature. This study aimed to develop an effective lipid extraction protocol from wet Scenedesmus almeriensis after PEF-treatment with 1.5 MJ·kgDW-1. A cascade process, i.e., the valorization of several products in row, was tested with firstly the collection of the released carbohydrates in the water fraction, then protein enzymatic hydrolysis and finally lipid extraction. Biomass processed with high pressure homogenization (HPH) on parallel, served as benchmark. RESULTS: Lipid extraction with ethanol:hexane (1:0.41 vol/vol) offered the highest yields from the different protocols tested. PEF-treatment promoted extraction with almost 70% of total lipids extracted against 43% from untreated biomass. An incubation step after PEF-treatment, further improved the yields, up to 83% of total lipids. Increasing the solvent volume by factor 2 offered no improvement. In comparison, extraction with two other systems utilizing only ethanol at room temperature or elevated at 60 °C were ineffective with less than 30% of total lipids extracted. Regarding cascade extraction, carbohydrate release after PEF was detected albeit in low concentrations. PEF-treated samples displayed slightly better kinetics during the enzymatic protein hydrolysis compared to untreated or HPH-treated biomass. The yields from a subsequent lipid extraction were not affected after PEF but were significantly increased for untreated samples (66% of total lipids), while HPH displayed the lowest yields (~ 49% of total lipids). CONCLUSIONS: PEF-treatment successfully promoted lipid extraction from S. almeriensis but only in combination with a polar:neutral co-solvent (ethanol:hexane). After enzymatic protein hydrolysis in cascade processing; however, untreated biomass displayed equal lipid yields due to the disruptive effect of the proteolytic enzymes. Therefore, the positive impact of PEF in this scheme is limited on the improved reaction kinetics exhibited during the enzymatic hydrolysis step.

Ensilicated tetanus antigen retains immunogenicity: in vivo study and time-resolved SAXS characterization.

Our recently developed ensilication approach can physically stabilize proteins in silica without use of a pre-formed particle matrix. Stabilisation is done by tailor fitting individual proteins with a silica coat using a modified sol-gel process. Biopharmaceuticals, e.g. liquid-formulated vaccines with adjuvants, frequently have poor thermal stability; heating and/or freezing impairs their potency. As a result, there is an increase in the prevalence of vaccine-preventable diseases in low-income countries even when there are means to combat them. One of the root causes lies in the problematic vaccine 'cold chain' distribution. We believe that ensilication can improve vaccine availability by enabling transportation without refrigeration. Here, we show that ensilication stabilizes tetanus toxin C fragment (TTCF), a component of the tetanus toxoid present in the diphtheria, tetanus and pertussis (DTP) vaccine. Experimental in vivo immunization data show that the ensilicated material can be stored, transported at ambient temperatures, and even heat-treated without compromising the immunogenic properties of TTCF. To further our understanding of the ensilication process and its protective effect on proteins, we have also studied the formation of TTCF-silica nanoparticles via time-resolved Small Angle X-ray Scattering (SAXS). Our results reveal ensilication to be a staged diffusion-limited cluster aggregation (DLCA) type reaction. An early stage (tens of seconds) in which individual proteins are coated with silica is followed by a subsequent stage (several minutes) in which the protein-containing silica nanoparticles aggregate into larger clusters. Our results suggest that we could utilize this technology for vaccines, therapeutics or other biopharmaceuticals that are not compatible with lyophilization.

Conducting and permeable states of cell membrane submitted to high voltage pulses: mathematical and numerical studies validated by the experiments.

The aim of this paper is to present a new model of in vitro cell electropermeabilization, which describes separately the conducting state and the permeable state of the membrane submitted to high voltage pulses. We first derive the model based on the experimental observations and we present the numerical methods to solve the non-linear partial differential equations. We then present numerical simulations that corroborate qualitatively the experimental data dealing with the uptake of propidium iodide (PI) after millipulses. This tends to justify the validity of our modeling. Forthcoming work will be to calibrate the parameters of the model for quantitative description of the uptake.

Comparison of the effects of the repetition rate between microsecond and nanosecond pulses: electropermeabilization-induced electro-desensitization?

BACKGROUND: Applications of cell electropermeabilization are rapidly growing but basic concepts are still unclear. In particular, the impact of electric pulse repetition rate in the efficiency of permeabilization has not yet been understood. METHODS: The impact of electric pulse repetition rate in the efficiency of permeabilization was analyzed in experiments performed on potato tissue and partially transposed on mice liver. On potato tissue, pulses with durations of 100µs or 10ns are applied. The intensity of permeabilization was quantified by means of bioimpedance changes and electric current measurements and a new index was defined. RESULTS: For the two pulse durations tested, very low repetition rates (below 0.1Hz) are much more efficient to achieve cell permeabilization in potato tissue. In mice liver, using 100µs pulses, the influence of the repetition rate is more complex. Indeed, repetition rates of 1Hz and 10Hz are more efficient than 100Hz or 1kHz, but not the repetition rate of 0.1Hz for which there is an impact of the living mice organism response. CONCLUSIONS: We propose that the effects reported here might be caused by an electroporation-induced cell membrane 'electro-desensitization' which requires seconds to dissipate due to membrane resealing. GENERAL SIGNIFICANCE: This study not only reinforces previous observations, but moreover it sustains a new concept of 'electro-desensitization' which is the first unifying mechanism enabling to explain all the results obtained until now both in vitro and in vivo, with long and short pulses.