ABSTRACT
INTRODUCTION: The results and complications using a palmar plate system with the possibility of multidirectional fixed-angle screw fixation (Aptus® Radius 2.5 mm by Medartis®) for the treatment of unstable distal radius fractures were evaluated in a single cohort study including 62 patients. PATIENTS: Patients with extra- and intraarticular fractures were evaluated separately. The mean follow-up was 14.7 months. Active wrist motion averaged 60.1° extension, 52.0° flexion, 86.3° pronation, and 84.6° supination. Grip strength averaged 89% of the contralateral wrist. RESULTS: There was no loss of the initial reduction with bony union in all cases. The mean DASH-score was 12.6 points. Postoperative complications included two extensor pollicis longus tendon ruptures, two median nerve compression syndromes, one complex regional pain syndrome, and one postoperative haematoma. In our series the results of the intraarticular fracture group were similar to the extraarticular fracture group. The complication rate, however, was substantially higher in the intraarticular fracture group. CONCLUSION: We conclude that palmar plating with multidirectional fixed-angle screw insertion is an effective and useful treatment option, especially for complex intraarticular distal radius fractures.
Subject(s)
Fracture Fixation, Internal/methods , Radius Fractures/surgery , Wrist Joint , Adult , Aged , Aged, 80 and over , Bone Plates , Cohort Studies , Female , Humans , Male , Middle Aged , Wrist Injuries/surgery , Young AdultABSTRACT
Plate osteosynthesis is one treatment option for the stabilization of long bones. It is widely accepted to achieve bone healing with a dynamic and biological fixation where the perfusion of the bone is left intact and micromotion at the fracture gap is allowed. The indications for a dynamic plate osteosynthesis include distal tibial and femoral fractures, some midshaft fractures, and adolescent tibial and femoral fractures with not fully closed growth plates. Although many lower limb shaft fractures are managed successfully with intramedullary nails, there are some important advantages of open-reduction-and-plate fixation: the risk of malalignment, anterior knee pain, or nonunion seems to be lower. The surgeon performing a plate osteosynthesis has the possibility to influence fixation strength and micromotion at the fracture gap. Long plates and oblique screws at the plate ends increase fixation strength. However, the number of screws does influence stiffness and stability. Lag screws and screws close to the fracture site reduce micromotion dramatically.DYNAMIC PLATE OSTEOSYNTHESIS CAN BE ACHIEVED BY APPLYING SOME SIMPLE RULES: long plates with only a few screws should be used. Oblique screws at the plate ends increase the pullout strength. Two or three holes at the fracture site should be omitted. Lag screws, especially through the plate, must be avoided whenever possible. Compression is not required. Locking plates are recommended only in fractures close to the joint. When respecting these basic concepts, dynamic plate osteosynthesis is a safe procedure with a high healing and a low complication rate.
