Critical Evaluation of the Methods for the Characterization of the Degree of Sulfonation for Electron Beam Irradiated and Non-Irradiated Sulfonated Poly(ether ether ketone) Membranes.

Sulfonated poly(ether ether ketone) (SPEEK) materials are promising candidates for replacing Nafion™ in applications such as proton exchange membrane (PEM) and direct methanol fuel cells. SPEEK membranes have several advantages such as low cost, thermal and radiation stability and controllable physicochemical and mechanical properties, which depend on the degree of sulfonation (DS). Commercial PEEK was homogenously sulfonated up to a DS of 60-90% and the membranes were prepared using a solvent casting method. Part of the samples were irradiated with a 10 MeV electron beam up to a 500 kGy dose to assess the ionizing radiation-induced effects. Both non-irradiated and irradiated membranes were characterized by Fourier Transformation infrared (FT-IR) spectroscopy, thermogravimetric analysis (TGA), proton nuclear magnetic resonance (1H-NMR) spectroscopy, electrochemical impedance analysis and, for the first time for non-irradiated membranes, by spectrophotometric analysis with Cr(III). The above-mentioned methods for application for DS assessment were compared. The aim of this study is to compare different methods used for the determination of the DS of SPEEK membranes before and after high-dose irradiation. It was observed that irradiated membranes presented a higher value of DS. The appearance of different new signals in 1H-NMR and FT-IR spectra of irradiated membranes indicated that the effects of radiation induced changes in the structure of SPEEK materials. The good correlation of Cr(III) absorption and SPEEK DS up to 80% indicates that the spectrophotometric method is a comparable tool for the characterization of SPEEK membranes.

Impact of Helium Ion Implantation Dose and Annealing on Dense Near-Surface Layers of NV Centers.

The implantation of diamonds with helium ions has become a common method to create hundreds-nanometers-thick near-surface layers of NV centers for high-sensitivity sensing and imaging applications; however, optimal implantation dose and annealing temperature are still a matter of discussion. In this study, we irradiated HPHT diamonds with an initial nitrogen concentration of 100 ppm using different implantation doses of helium ions to create 200-nm thick NV layers. We compare a previously considered optimal implantation dose of ∼1012 He+/cm2 to double and triple doses by measuring fluorescence intensity, contrast, and linewidth of magnetic resonances, as well as longitudinal and transversal relaxation times T1 and T2. From these direct measurements, we also estimate concentrations of P1 and NV centers. In addition, we compare the three diamond samples that underwent three consequent annealing steps to quantify the impact of processing at 1100 °C, which follows initial annealing at 800 °C. By tripling the implantation dose, we have increased the magnetic sensitivity of our sensors by 28±5%. By projecting our results to higher implantation doses, we demonstrate that it is possible to achieve a further improvement of up to 70%. At the same time, additional annealing steps at 1100 °C improve the sensitivity only by 6.6 ± 2.7%.

Evaluation of Physicochemical Properties of Amphiphilic 1,4-Dihydropyridines and Preparation of Magnetoliposomes.

This study was focused on the estimation of the targeted modification of 1,4-DHP core with (1) different alkyl chain lengths at 3,5-ester moieties of 1,4-DHP (C12, C14 and C16); (2) N-substituent at position 1 of 1,4-DHP (N-H or N-CH3); (3) substituents of pyridinium moieties at positions 2 and 6 of 1,4-DHP (H, 4-CN and 3-Ph); (4) substituent at position 4 of 1,4-DHP (phenyl and napthyl) on physicochemical properties of the entire molecules and on the characteristics of the obtained magnetoliposomes formed by them. It was shown that thermal behavior of the tested 1,4-DHP amphiphiles was related to the alkyl chains length, the elongation of which decreased their transition temperatures. The properties of 1,4-DHP amphiphile monolayers and their polar head areas were determined. The packing parameters of amphiphiles were in the 0.43-0.55 range. It was demonstrated that the structure of 1,4-DHPs affected the physicochemical properties of compounds. "Empty" liposomes and magnetoliposomes were prepared from selected 1,4-DHP amphiphiles. It was shown that the variation of alkyl chains length or the change of substituents at positions 4 of 1,4-DHP did not show a significant influence on properties of liposomes.