In Vitro Evaluation of Colistin Conjugated with Chitosan-Capped Gold Nanoparticles as a Possible Formulation Applied in a Metered-Dose Inhaler.

Inhaled colistin is used to treat pneumonia and respiratory infections through nebulization or dry powder inhalers. Nevertheless, the development of a metered-dose inhaler (MDI) for colistin, which could enhance patient convenience and treatment efficacy, has not yet been developed. Colistin is known for its ability to induce cellular toxicity. Gold nanoparticles (AuNPs) can potentially mitigate colistin toxicity. Therefore, this study aimed to evaluate the antimicrobial effectiveness of colistin conjugated with chitosan-capped gold nanoparticles (Col-CS-AuNPs) and their potential formulation for use with MDIs to deliver the aerosol directly to the deep lung. Fourier-transform infrared spectroscopy, nuclear magnetic resonance, and elemental analysis were used to characterize the synthesized Col-CS-AuNPs. Drug release profiles fitted with the most suitable release kinetic model were evaluated. An MDI formulation containing 100 µg of colistin per puff was prepared. The aerosol properties used to determine the MDI performance included the fine particle fraction, mass median aerodynamic diameter, and geometric standard deviation, which were evaluated using the Andersen Cascade Impactor. The delivered dose uniformity was also determined. The antimicrobial efficacy of the Col-CS-AuNP formulation in the MDI was assessed. The chitosan-capped gold nanoparticles (CS-AuNPs) and Col-CS-AuNPs had particle sizes of 44.34 ± 1.02 and 174.50 ± 4.46 nm, respectively. CS-AuNPs effectively entrapped 76.4% of colistin. Col-CS-AuNPs exhibited an initial burst release of up to 60% colistin within the first 6 h. The release mechanism was accurately described by the Korsmeyer-Peppas model, with an R2 > 0.95. The aerosol properties of the Col-CS-AuNP formulation in the MDI revealed a high fine particle fraction of 61.08%, mass median aerodynamic diameter of 2.34 µm, and geometric standard deviation of 0.21, with a delivered dose uniformity within 75-125% of the labeled claim. The Col-CS-AuNP MDI formulation completely killed Escherichia coli at 5× and 10× minimum inhibitory concentrations after 6 and 12 h of incubation, respectively. The toxicity of CS-AuNP and Col-CS-AuNP MDI formulations in upper and lower respiratory tract cell lines was lower than that of free colistin. The stability of the Col-CS-AuNP MDI formulation was maintained for at least 3 months. The Col-CS-AuNP MDI formulation effectively eradicated bacteria over a 12-h period, showing promise for advancing lung infection treatments.

Development of nanodispersion-based sildenafil metered-dose inhalers stabilized by poloxamer 188: a potential candidate for the treatment of pulmonary arterial hypertension.

Objectives: This study aims to formulate nanodispersion-based sildenafil metered-dose inhalers (MDIs) by using poloxamer 188 (P188) as a stabilizer; to evaluate their stability, aerosol characteristics, cytotoxicity, and inflammatory effects; and to investigate the effects of P188 on stability and aerosol characteristics of the MDIs. Methods: The stability and uniformity of the formulations were evaluated by high-performance liquid chromatography method. The aerosol characteristics were evaluated by the Next Generation Impactor. The cytotoxicity and inflammatory effects on respiratory epithelial cells and alveolar macrophages were evaluated by MTT assay and TNF-α, IL-1ß, and NO assay, respectively. Results: The optimal formulation was stable and well-uniform after 6 months. The fine particle fraction and mass median aerodynamic diameter (MMAD) of the formulation were 61.9% ± 2.5% and 1.69 ± 0.06 µm, respectively. The formulation was found to be nontoxic to respiratory epithelial cells and did not induce the inflammatory responses of alveolar macrophages. A positive correlation between P188 concentration and MMAD of the MDIs was observed. P188 possesses an ability to prevent the growth of sildenafil citrate monohydrate crystals in the formulations. Conclusions: The findings provided a basis for the development of sildenafil MDI as a potential candidate for the treatment of pulmonary arterial hypertension.

Mupirocin at Subinhibitory Concentrations Induces Biofilm Formation in Staphylococcus aureus.

OBJECTIVES: Mupirocin is a useful antibiotic against superficial skin infections. We compared the impact of mupirocin with a cephalosporin, a fluoroquinolone, an aminoglycoside, and a macrolide on planktonic cell growth and biofilm formation of methicillin-susceptible Staphylococcus aureus (MSSA) and methicillin-resistant S. aureus (MRSA). MATERIALS AND METHODS: Minimum inhibitory concentration (MIC) of mupirocin was determined against S. aureus strains used in this study. Biofilm formation of S. aureus strains exposed to mupirocin was quantified by crystal violet staining assay. Moreover, biofilm structure and viability of the biofilm cells were visualized by Live/Dead staining assay. Biofilm-related gene expression was investigated by quantitative real-time PCR. RESULTS: MRSA USA300 clone was resistant to mupirocin with MIC of 1,024 mg/L, while MRSA ATCC-43300 and MSSA ATCC-29213 were susceptible with MICs of 0.03 mg/L. Planktonic cell growth of the S. aureus strains was inhibited by mupirocin in a dose-dependent manner. However, some of the low concentrations of mupirocin less than the MICs promoted biofilm formation. Confocal laser scanning microscopy of the biofilm structures and cell viabilities showed established biofilms of slightly higher cell density in the mupirocin treated groups, especially in the MRSA USA300 clone. Gene expression of RNAIII in planktonic cells and biofilms of MRSA USA300 clone showed the highest upregulation after initial exposure to sub-MIC of mupirocin followed by downregulation, whereas the other antibiotics showed various fluctuations. CONCLUSION: The results showed that subinhibitory concentrations of mupirocin promoted biofilm formation of S. aureus, in particular the MRSA USA300 clone.

Anti-biofilm properties of a mupirocin spray formulation against Escherichia coli wound infections.

Mupirocin ointment is a widely used topical drug for the treatment of bacterial skin infections. However, ointments have some limitations which motivated the development of a film forming spray of mupirocin. Mupirocin spray (2%) was formulated with Eudragit E100 as a film forming agent and tested for its antibacterial and anti-biofilm activities against Escherichia coli, a skin pathogen causing wound and surgical site infections. Treatment with mupirocin spray resulted in significant antibacterial and anti-biofilm activities (inhibition and disruption) with single spray and sub-actual dose concentrations at par with the commercial ointment concentration. The spray formulation was found to be non-toxic to fibroblast cells and greatly resisted removal from the site of application upon washing, in contrast to the ointment which was significantly removed after a single wash. This is the first study to develop and evaluate a spray formulation for mupirocin that forms a stable thin film for sustained release of the drug.

Quantitative analysis of povidone-iodine thin films by X-ray photoelectron spectroscopy and their physicochemical properties.

In this study, povidone-iodine (PVP-I) has been formulated as a topical spray to produce a thin film for the controlled release of I2. By means of experimental design, 27 formulations containing glycerol, ethanol, PEG 400, copovidone and HFA 134a as a propellant were prepared. The pH values of all formulations were in the range of 6-7. The viscosity was within the range of 11.9-85.9 mPa s. The surface tensions were 20.3 to 24.6 mN m-1 and the contact angles were between 19.3 and 38.7°. The assays for the iodine contents were within acceptable range (80-120 %). X-ray photoelectron spectroscopy analysis revealed the ionized form of iodine was much higher than the unionized form. The MIC and MBC values of the PVP-I sprays against Staphylococcus aureus, S. epidermidis and Pseudomonas aeruginosa were higher than that of commercial PVP-I solution. The cytotoxicity study confirmed that the PVP-I spray had lower toxic effects on keratinocytes and fibroblasts compared to the commercial PVP-I solution. The formulation containing 59 % ethanol, 18 % copovidone and 12 % PEG 400 showed good antibacterial activity.

Development of a topical mupirocin spray for antibacterial and wound-healing applications.

OBJECTIVE: The aim of this study was to develop mupirocin topical spray using Eudragit E100 as a film-forming agent for the treatment of bacterial skin infections as well as to promote wound healing. MATERIALS AND METHODS: Twenty-seven of mupirocin formulations were formulated containing Eudragit E100 and other excipients. Mupirocin spray was prepared by aerosol crimping and filling machine using HFA-134a as a propellant. The formulations were evaluated for their stability and physicochemical properties. The factorial study was applied to evaluate the effects of glycerol and PEG400 on mupirocin-loaded Eudragit E100 films. The optimized formulation was assessed of drug release, antibacterial activities and in vitro cell line studies in comparison to the ointment formulation. RESULTS AND DISCUSSION: Mupirocin sprays were formulated and optimized to obtain the formulation with excellent physicochemical and mechanical properties of the dressing film. The formulation had an excellent stability up to a year with more than 80% of mupirocin content. Mupirocin was released from the film up to 90% within 2 h. The formulation had a potent antibacterial effect against S. aureus and S. epidermidis. The formulation was safe to use as a topical formulation that had no toxicity to keratinocytes, fibroblasts and monocytes. The formulation also had an antiendotoxin effect without stimulating the production of NO and inflammatory cytokines (IL-1ß and TNF-α). CONCLUSIONS: Mupirocin topical spray was successful developed as a topical formulation and can be used instead of the ointment formulation. Animal experiments are warranted to further emphasize the safe use in the human skin.

Evidences for salbutamol metabolism by respiratory and liver cell lines.

This study aimed to investigate the enantiomeric biotransformation of salbutamol in the human respiratory and liver cells. The cells from the different cell growth cycles were treated with various concentrations of salbutamol sulfate. Salbutamol and its metabolites were analyzed using chiral liquid chromatography and mass spectrometry. There were no metabolites of salbutamol found in the extracellular medium, intracellular, and cell lysate of respiratory cell lines. The S/R ratios of salbutamol were found to be 0.99-1.10 in all cell lines, cell cycles, and salbutamol concentrations in this study. Salbutamol metabolites were found only in intracellular HepG2 cells. The S/R ratios of the salbutamol inside the liver cells were 10 times greater than the S/R ratios of the salbutamol in the liver extracellular medium (0.99-1.10). It is important to note that the S/R ratios of salbutamol in liver cell lysate enzyme were 0.99-1.10 whereas the S/R salbutamol metabolites inside the liver cell were around 1.91-2.14. Both salbutamol and sulfate conjugation metabolites were detected in MS chromatograms with an m/z of 239.2 and 317.6, respectively. Hence, the delivery of salbutamol directly to the respiratory system is a right target that can avoid first-pass metabolism.