ABSTRACT
Additive manufacturing (AM) of metals, also known as metal 3D printing, typically leads to the formation of columnar grain structures along the build direction in most as-built metals and alloys. These long columnar grains can cause property anisotropy, which is usually detrimental to component qualification or targeted applications. Here, without changing alloy chemistry, we demonstrate an AM solidification-control solution to printing metallic alloys with an equiaxed grain structure and improved mechanical properties. Using the titanium alloy Ti-6Al-4V as a model alloy, we employ high-intensity ultrasound to achieve full transition from columnar grains to fine (~100 µm) equiaxed grains in AM Ti-6Al-4V samples by laser powder deposition. This results in a 12% improvement in both the yield stress and tensile strength compared with the conventional AM columnar Ti-6Al-4V. We further demonstrate the generality of our technique by achieving similar grain structure control results in the nickel-based superalloy Inconel 625, and expect that this method may be applicable to other metallic materials that exhibit columnar grain structures during AM.
ABSTRACT
Powder sintering at 1200 °C for 180 min was used to produce Fe-Mn based alloys with tensile properties and an elastic modulus suitable for biodegradable implant applications. The effect of the addition of manganese on the microstructure, tensile properties and fracture behaviour of the Fe-Mn alloys was investigated. The Fe-35Mn alloy with a microstructure dominated by the Austenite phase showed the best set of tensile properties, including ultimate tensile strength and Young's modulus, suitable for orthopaedic implant applications. The fracture surface of the Fe-35Mn alloy showed signs of complex multimode fracture behaviour, consisting of interconnected pores and large segments with signs of ductile fracture, including the presence of dimples as well as micro-voids.
ABSTRACT
The present study investigates the influence of ultrasonic treatment on the grain refinement of commercial purity aluminium with a range of Al3Ti1B master alloy additions. When the aluminium contains the smallest amount of added master alloy, ultrasonics caused significant additional grain refinement compared to that provided by the master alloy alone. However, the influence of ultrasonics on grain size reduces with increasing addition of the master alloy which adds additional TiB2 particles and Ti solute with each incremental addition. Applying the Interdependence model to analyse the experimentally measured grain sizes revealed that the results of this study and those from similar experiments on an Al-2Cu alloy were consistent when the alloy compositions are converted to their growth restriction factors (Q) and that increasing Q had a major effect on reducing grain size and increasing grain number density. Compared with the application of ultrasonic treatment where an order of magnitude increase in the grain number density is achieved, an increase in the Ti content over the range of master alloy additions, causes the grain number density to increase by approximately three times.
