Evaluation of lead desorption from cement matrices.

Desorption of lead immobilized into cement and concrete matrices was evaluated in the pH range between 4 and 8 within a period of 2 h to 15 days. Lead-desorbed content in aqueous milieu was monitored by Graphite Furnace Atomic Absorption Spectroscopy, while matrices were directly analyzed by X-ray photoelectronic spectroscopy or Rutherford Backscattering spectrometry. For low pH, higher Pb desorption was observed, about 5-7 times higher than that measured in the case of concrete matrices. The inclusion of polyvinyl alcohol as a matrix modifier was evaluated through a factorial design. Polymer inclusion yielded a reduction in Pb desorption, but its effect cannot be justified in terms of the ability of this polymer to chelate the metal. The resulting modified matrices did not present toxicity to Daphnia magna.

Determination of titanium and vanadium in Ziegler-Natta catalysts by inductively coupled plasma atomic emission spectrometry.

A method for the determination of Ti and V using inductively coupled plasma atomic emission spectrometry (ICP OES) in Ziegler-Natta polymerization catalysts is proposed. The concentrations of both Ti and V are efficiently determined after catalyst acid digestion with a mixture of HNO3 + HCl + HF and heating (160 degrees C for 6 h) or with 10% (v/v) H2SO4 and heating (160 degrees C for 6 h) or with 10% (v/v) H2SO4 and sonication (during 2 min). The V and Ti detection limits are 0.002% and 0.08%, respectively, using 0.20 g of catalyst sample in 50 ml. The method is validated by a comparison with the Rutherford backscattering spectrometry (RBS) technique. In this case, catalyst samples are only pressed as pellets before analyte determination. Despite the fact that both the V and Ti concentrations cannot be determined individually by means of RBS, because the atomic numbers of Ti and V are very close, the sum of the V and Ti contents is in accordance with that attained by means of ICP OES. According to scanning electron microscopy-energy dispersive X-ray analysis (SEM-EDX) it is observed that the Ti distribution on the catalyst grain is not homogenous.

Evaluation of zirconocene-based silica phases in organochloride pesticides preconcentration.

Silica was chemically modified with zirconocenes, namely Cp(2)ZrCl(2), (MeCp)(2)ZrCl(2), (iBuCp)(2)ZrCl(2) and (nBuCp)(2)ZrCl(2) by grafting. Hybrid silica bearing surface indene groups was synthesized by the sol-gel method, followed by metallation with ZrCl(4)2THF. According to RBS measurements, metal content was 0.2-0.3 wt% Zr/SiO(2) for the grafted systems and 4.5 wt% Zr/SiO(2) for the phase prepared by the sol-gel method. The solid phases were evaluated in the adsorption/preconcentration of organochloride (hexachlorobenzene, lindane, heptachlor, heptachlor epoxide, dieldrin and endrin) pesticides from aqueous solution. For comparative reasons, commercial LC-18 phase was also evaluated. Analyte concentration was monitored by GC-ECD. For the grafted phases, the coordination sphere around the metal center seems not to influence the adsorption/desorption properties of these phases vis-à-vis the studied analytes. Recoveries results for both analytes were comparable to those observed in the case of LC-18 in the case of the phases prepared by the sol-gel method. Experiments using ZrO(2) and ZrO(2)/SiO(2) phases led to lower recovery results.