Nanostructured Oxide (SnO2, FTO) Thin Films for Energy Harvesting: A Significant Increase in Thermoelectric Power at Low Temperature.

Previous studies have shown that undoped and doped SnO2 thin films have better optical and electrical properties. This study aims to investigate the thermoelectric properties of two distinct semiconducting oxide thin films, namely SnO2 and F-doped SnO2 (FTO), by the nebulizer spray pyrolysis technique. An X-ray diffraction study reveals that the synthesized films exhibit a tetragonal structure with the (200) preferred orientation. The film structural quality increases from SnO2 to FTO due to the substitution of F- ions into the host lattice. The film thickness increases from 530 nm for SnO2 to 650 nm for FTO films. Room-temperature electrical resistivity decreases from (8.96 ± 0.02) × 10-2 Ω·cm to (4.64 ± 0.01) × 10-3 Ω·cm for the SnO2 and FTO thin films, respectively. This is due to the increase in the carrier density of the films, (2.92 ± 0.02) × 1019 cm-3 (SnO2) and (1.63 ± 0.03) × 1020 cm-3 (FTO), caused by anionic substitution. It is confirmed that varying the temperature (K) enhances the electron transport properties. The obtained Seebeck coefficient (S) increases as the temperature is increased, up to 360 K. The synthesized films exhibit the S value of -234 ± 3 µV/K (SnO2) and -204 ± 3 µV/K (FTO) at 360 K. The estimated power factor (PF) drastically increases from ~70 (µW/m·K2) to ~900 (µW/m·K2) for the SnO2 and FTO film, respectively.

A microfluidic chip for geoelectrical monitoring of critical zone processes.

We miniaturize geoelectrical acquisition using advanced microfabrication technologies to investigate coupled processes in the critical zone. We focus on the development of the complex electrical conductivity acquisition with the spectral induced polarization (SIP) method on a microfluidic chip equipped with electrodes. SIP is an innovative detection method that has the potential to monitor biogeochemical processes. However, due to the lack of microscale visualization of the processes, the interpretation of the SIP response remains under debate. This approach at the micrometer scale allows working in well-controlled conditions, with real-time monitoring by high-speed and high-resolution microscopy. It enables direct observation of microscopic reactive transport processes in the critical zone. We monitor the dissolution of pure calcite, a common geochemical reaction studied as an analog of the water-mineral interactions. We highlight the strong correlation between SIP response and dissolution through image processing. These results demonstrate that the proposed technological advancement will provide a further understanding of the critical zone processes through SIP observation.

Effect of Nanographene Coating on the Seebeck Coefficient of Mesoporous Silicon.

Nanographene-mesoporous silicon (G-PSi) composites have recently emerged as a promising class of nanomaterials with tuneable physical properties. In this study, we investigated the impact of nanographene coating on the Seebeck coefficient of mesoporous silicon (PSi) obtained by varying two parameters: porosity and thickness. To achieve this, an electrochemical etching process on p + doped Si is presented for the control of the parameters (thicknesses varying from 20 to 160 µm, and a porosity close to 50%), and for nanographene incorporation through chemical vapor deposition. Raman and XPS spectroscopies confirmed the presence of nanographene on PSi. Using a homemade ZT meter, the Seebeck coefficient of the p + doped Si matrix was evaluated at close to 100 ± 15 µV/K and confirmed by UPS spectroscopy analysis. Our findings suggest that the Seebeck coefficient of the porous Si can be measured independently from that of the substrate by fitting measurements on samples with a different thickness of the porous layer. The value of the Seebeck coefficient for the porous Si is of the order of 750 ± 40 µV/K. Furthermore, the incorporation of nanographene induced a drastic decrease to approximately 120 ± 15 µV/K, a value similar to that of its silicon substrate.

Laser-based setup for simultaneous measurement of the Seebeck coefficient and electrical conductivity for bulk and thin film thermoelectrics.

In this paper, an original homemade system is presented in detail for the electrical and thermoelectrical characterizations of several types of materials from bulk to thin films. This setup was built using a modulated CO2 laser beam to probe the thermoelectric properties at different depths below the surface. It allows a simultaneous measurement of the electrical conductivity (σ) and the Seebeck coefficient (S), from room temperature up to 250 °C. A commercial sample of Bi2Te3 was first used to validate the Seebeck coefficient measurement. Single crystalline silicon (sc-Si) was used for the uncertainty quantification during the simultaneous measurement of the Seebeck coefficient and the electrical conductivity. At the micrometer scale, thermoelectric characterization of the mesoporous Si (50 µm thickness) was achieved and results gave very promising values (S ≈ 700 µV K-1) for micro-thermo-generator fabrication. In the case of thin film materials, metals (copper and constantan) and oxide thin films (titanium oxide) were also characterized in the in-plane configuration in order to determine the metrology limits of our thermoelectric setup. In this case, a typical sensitivity of about 2µV K-1 was achieved.

[Management of idiopathic membranous nephropathy: evaluation of a standardized strategy in a Lorraine health network]. / Évaluation d'une stratégie standardisée de prise en charge de la glomérulonéphrite extramembraneuse idiopathique au sein d'un réseau de santé en Lorraine (Néphrolor).

INTRODUCTION: The evolution of idiopathic membranous membranous (MNi) is variable, treatment is discussed. Our work's main objective was to evaluate the results of a standardized management strategy proposed in 2006 in Lorraine (Nephrolor health network). The secondary objective was to evaluate the professional practices. PATIENTS ET METHODS: This study compared the evolution of incident MNi between 2002 and 2005 (Before) and between 2007 and 2010 (After), the respective dates point to 31/12/2011 and 31/12/2006. In nephrotics patients without renal failure, the risk assessment of end stage renal disease based on urinary ß2-microglobulin (uß2 m, threshold to 0,5 µg/min). Patients at high risk should receive immunosuppressive therapy (IS). RESULTS: Seventy-four biopsy-proven MNi were diagnosed with 50 nephrotic (22 Before and 28 After) of which 20 had normal renal function. In these nephrotic, there was no significant difference in the probability and the average time of remission between the two groups (P=0.26). Dosage of uß2m was performed in 35% of cases. Fifty percent were treated with IS respecting strategy. CONCLUSION: Despite differences between the strategy and practices, which may explain these non-significant results, we observed changes in thinking and therapeutic attitude of the clinician. The implementation of this strategy tends to standardize and improve practices about MNi in Lorraine, which seems to improve results in remission. We encourage to generalize the application of this strategy and to continue this cohort follow.

Nonlinear photon-assisted tunneling transport in optical gap antennas.

We introduce strongly coupled optical gap antennas to interface optical radiation with current-carrying electrons at the nanoscale. The transducer relies on the nonlinear optical and electrical properties of an optical gap antenna operating in the tunneling regime. We discuss the underlying physical mechanisms controlling the conversion involving d-band electrons and demonstrate that a simple two-wire optical antenna can provide advanced optoelectronic functionalities beyond tailoring the electromagnetic response of a single emitter. Interfacing an electronic command layer with a nanoscale optical device may thus be facilitated by the optical rectennas discussed here.

Evaluating plasmonic transport in current-carrying silver nanowires.

Plasmonics is an emerging technology capable of simultaneously transporting a plasmonic signal and an electronic signal on the same information support. In this context, metal nanowires are especially desirable for realizing dense routing networks. A prerequisite to operate such shared nanowire-based platform relies on our ability to electrically contact individual metal nanowires and efficiently excite surface plasmon polaritons in this information support. In this article, we describe a protocol to bring electrical terminals to chemically-synthesized silver nanowires randomly distributed on a glass substrate. The positions of the nanowire ends with respect to predefined landmarks are precisely located using standard optical transmission microscopy before encapsulation in an electron-sensitive resist. Trenches representing the electrode layout are subsequently designed by electron-beam lithography. Metal electrodes are then fabricated by thermally evaporating a Cr/Au layer followed by a chemical lift-off. The contacted silver nanowires are finally transferred to a leakage radiation microscope for surface plasmon excitation and characterization. Surface plasmons are launched in the nanowires by focusing a near infrared laser beam on a diffraction-limited spot overlapping one nanowire extremity. For sufficiently large nanowires, the surface plasmon mode leaks into the glass substrate. This leakage radiation is readily detected, imaged, and analyzed in the different conjugate planes in leakage radiation microscopy. The electrical terminals do not affect the plasmon propagation. However, a current-induced morphological deterioration of the nanowire drastically degrades the flow of surface plasmons. The combination of surface plasmon leakage radiation microscopy with a simultaneous analysis of the nanowire electrical transport characteristics reveals the intrinsic limitations of such plasmonic circuitry.

Aldosterone-to-renin ratio for diagnosing aldosterone-producing adenoma: a multicentre study.

BACKGROUND: Biological diagnostic criteria for diagnosing aldosterone-producing adenoma (APA) are not well-established. AIM: The aim of the study was to establish the best biological predictors of APA. METHODS: A prospective register was implemented in 17 secondary or tertiary hypertension centres. The inclusion criterion was one of the following: onset of hypertension before 40 years of age; history of hypokalaemia; drug-resistant hypertension (resistant to three drugs); or spironolactone efficiency on BP. RESULTS: Among the 338 collected cases, 192 patients had two aldosterone-to-renin ratio (ARR) determinations (after 1 hour supine and at least 1 hour upright) on the same occasion. Twenty-five patients (8.2%) had biological hyperaldosteronism and an adrenal adenoma identified by computed tomography. APA was histologically confirmed in all 12 patients who underwent surgery. Histologically proven APAs were used as the 'gold standard' in receiver operating characteristic (ROC) curve analysis. ARRs were computed with a minimum renin value set at 5 ng/L to avoid misclassification of so-called 'low-renin hypertension'. To predict an APA, the ARR area under the ROC curve was 0.93. A supine ARR cut-off value of 32ng/ng provided the highest sum of sensitivity (92%) plus specificity (92%). On the basis of an ARR≥32 ng/ng in the supine and/or upright position, sensitivity reached 100%. CONCLUSION: The proposed cut-off value of 32 ng/ng for ARR (minimum renin value set at 5 ng/L) in one of two determinations had 100% sensitivity and 72% specificity with 20% positive and 100% negative predictive values for diagnosing APA.

Gallium-nitride-based plasmonic multilayer operating at 1.55 µm.

In this Letter, we have designed and fabricated a III-V semiconductor multilayer based on surface plasmon resonance (SPR) operating at the telecom wavelength. Optimization of the optogeometrical parameters and the metal/semiconductor layers required for this novel structure was conducted accurately by theoretical tools using the Maxwell equations. Technological fabrication of the device and its experimental characterizations using an evanescent coupling configuration was performed: the results have confirmed the existence of SPR associated to a sharp width response. This study could be a first step in the design of new plasmonic-semiconductor-based optical devices such as modulators and switches.

Effect of varying pore size of AAO films on refractive index and birefringence measured by prism coupling technique.

Anodic aluminum oxide (AAO) films with different pore sizes were prepared to modulate the effective refractive index and birefringence. To investigate the relationship between the refractive index and the pore size of the AAO film, optical constants were obtained using a prism coupler with various lasers. With experimental results, the dispersion curve of alumina itself without pores was extracted using a theoretical anisotropic model. We demonstrated that AAO films could offer a wide range of refractive index and birefringence values for optical device applications. Furthermore, index profiles as a function of the thickness of the AAO films were obtained by inverse Wentzel-Kramer-Brillouin approximation to examine the optical homogeneity.

Evaluation of sample bias for measuring plasma iohexol clearance in kidney transplantation.

BACKGROUND: Plasma clearance of iohexol (PCI) is becoming a commonly used standard tool in many clinical trials to evaluate the glomerular filtration rate (GFR). However, most studies performing PCI use only early plasma samples (2, 3, and 4 hr). This study aims to evaluate the role of early and late plasma sampling in the precision of PCI calculation in transplant recipients. METHODS: We evaluated 342 renal transplant recipients for both renal clearance (RC) and plasma clearance, using iohexol and six blood samples (2, 3, 4, 5, 6, and 24 hr). Patients were divided into three subgroups according to RC: <30, 30 to 60, and >60 mL/min/1.75 m(2). RESULTS: A simplified technique using early plasma samples overestimated GFR with a mean difference between plasma clearance and RC of 53.3%, 25.7%, and 12.5% for the three subgroups, respectively. This difference decreased to 8.8%, 6.3%, and 5.5%, respectively, when the 24-hr sample was included in plasma clearance calculation. CONCLUSION: These results demonstrate that GFR evaluation by PCI in renal transplant recipients requires a late plasma sample.

Improved removal of small proteins using continuous venovenous hemofiltration to treat acute renal failure.

Continuous venovenous hemodialysis (CVVHD) or hemofiltration conducted with pre- (CVVHpre) or post- (CVVHpost) dilution modes are recommended to treat patients with acute renal failure (ARF) and cardiovascular instability. The efficiency of the three techniques was compared in a study including 18 critically ill patients with ARF. Their mean age was 62.1 +/- 16.7 years, and their mean SAPS II score was 59.5 +/- 14.3. They were treated sequentially with the three techniques for periods of 24 hours each (randomized assignment to one technique the first 24 hours followed by the two others). The PRISMA device and M 100 (AN69S) membrane were used in all instances. Blood and replacement (or dialysis) flow rates were kept at 150 and 25 ml/min, respectively. Urea, creatinine, uric acid, inorganic phosphorus, beta2 microglobulin (beta2m), and retinol binding protein (RBP) were measured every 12 hours in plasma and in 12 hours filtrate collection for 3 days. The results are expressed as filtrate/mean plasma (F/P) ratio for the 12 hour period. Removal of small molecules was 16% higher using CVVHD and CVVHpost than CVVHpre. For beta2m and RBP, CVVHpre was, respectively, 43% and 26% more efficient than CVVHD. CVVHpost gave higher but statistically different removal than CVVHpre only for beta2m. CVVHpost was the most efficient technique for removal of small proteins, but this advantage could be easily counterbalanced using higher volume substitution.