Quantifying the Primary Emissions and Photochemical Formation of Isocyanic Acid Downwind of Oil Sands Operations.

Isocyanic acid (HNCO) is a known toxic species and yet the relative importance of primary and secondary sources to regional HNCO and population exposure remains unclear. Off-road diesel fuel combustion has previously been suggested to be an important regional source of HNCO, which implies that major industrial facilities such as the oil sands (OS), which consume large quantities of diesel fuel, can be sources of HNCO. The OS emissions of nontraditional toxic species such as HNCO have not been assessed. Here, airborne measurements of HNCO were used to estimate primary and secondary HNCO for the oil sands. Approximately 6.2 ± 1.1 kg hr-1 was emitted from off-road diesel activities within oil sands facilities, and an additional 116-186 kg hr-1 formed from the photochemical oxidation of diesel exhaust. Together, the primary and secondary HNCO from OS operations represent a significant anthropogenic HNCO source in Canada. The secondary HNCO downwind of the OS was enhanced by up to a factor of 20 relative to its primary emission, an enhancement factor significantly greater than previously estimated from laboratory studies. Incorporating HNCO emissions and formation into a regional model demonstrated that the HNCO levels in Fort McMurray (∼10-70 km downwind of the OS) are controlled by OS emissions; > 50% of the monthly mean HNCO arose from the OS. While the mean HNCO levels in Fort McMurray are predicted to be below the 1000 pptv level associated with potential negative health impacts, (∼25 pptv in August-September), an order of magnitude increase in concentration is predicted (250-600 pptv) when the town is directly impacted by OS plumes. The results here highlight the importance of obtaining at-source HNCO emission factors and advancing the understanding of secondary HNCO formation mechanisms, to assess and improve HNCO population exposure predictions.

Differences between measured and reported volatile organic compound emissions from oil sands facilities in Alberta, Canada.

Large-scale oil production from oil sands deposits in Alberta, Canada has raised concerns about environmental impacts, such as the magnitude of air pollution emissions. This paper reports compound emission rates (E) for 69-89 nonbiogenic volatile organic compounds (VOCs) for each of four surface mining facilities, determined with a top-down approach using aircraft measurements in the summer of 2013. The aggregate emission rate (aE) of the nonbiogenic VOCs ranged from 50 ± 14 to 70 ± 22 t/d depending on the facility. In comparison, equivalent VOC emission rates reported to the Canadian National Pollutant Release Inventory (NPRI) using accepted estimation methods were lower than the aE values by factors of 2.0 ± 0.6, 3.1 ± 1.1, 4.5 ± 1.5, and 4.1 ± 1.6 for the four facilities, indicating underestimation in the reported VOC emissions. For 11 of the combined 93 VOC species reported by all four facilities, the reported emission rate and E were similar; but for the other 82 species, the reported emission rate was lower than E The median ratio of E to that reported for all species by a facility ranged from 4.5 to 375 depending on the facility. Moreover, between 9 and 53 VOCs, for which there are existing reporting requirements to the NPRI, were not included in the facility emission reports. The comparisons between the emission reports and measurement-based emission rates indicate that improvements to VOC emission estimation methods would enhance the accuracy and completeness of emission estimates and their applicability to environmental impact assessments of oil sands developments.

Simulating organic aerosol formation during the photooxidation of toluene/NOx mixtures: comparing the equilibrium and kinetic assumption.

Organic compounds contribute an appreciable mass to particulate matter and thus impact the hygroscopic and radiative properties of an aerosol distribution. Being able to predict the chemical and physical properties of aerosols based on their size and composition is critical to assessing their impact on air quality, visibility, and climate change. In this study, a comparison was performed between an equilibrium and a kinetic model for simulating organic aerosol formation during the photooxidation of toluene/NO/isopropyl nitrite mixtures. Both models used an explicit gas-phase toluene scheme (University of Leeds Master Chemical Mechanism version 3.0) and provided a prediction of individual products partitioned to the aerosol phase. After incorporating a heterogeneous wall reaction scheme regenerating NOx from HNO3 and HNO2, the gas-phase scheme was able to simulate the observed toluene decay within 5% and NO decay within 30% for all of the chamber experiments. The models reproduced the general magnitude of the aerosol yields but suggest a weaker trend dependence on aerosol mass loading. A few nonvolatile compounds were predicted to compose the majority of the aerosol-phase mass with multifunctional organic nitrates being the dominant organic aerosol functional group. The hygroscopic diameter growth factor for the organic phase was predicted to be 1.1 at a relative humidity of 79%. We conclude with a list of recommended laboratory experiments to help constrain and validate aerosol process models.