Probe Heating Method for the Analysis of Solid Samples Using a Portable Mass Spectrometer.

We previously reported on the development of a portable mass spectrometer for the onsite screening of illicit drugs, but our previous sampling system could only be used for liquid samples. In this study, we report on an attempt to develop a probe heating method that also permits solid samples to be analyzed using a portable mass spectrometer. An aluminum rod is used as the sampling probe. The powdered sample is affixed to the sampling probe or a droplet of sample solution is placed on the tip of the probe and dried. The probe is then placed on a heater to vaporize the sample. The vapor is then introduced into the portable mass spectrometer and analyzed. With the heater temperature set to 130°C, the developed system detected 1 ng of methamphetamine, 1 ng of amphetamine, 3 ng of 3,4-methylenedioxymethamphetamine, 1 ng of 3,4-methylenedioxyamphetamine, and 0.3 ng of cocaine. Even from mixtures consisting of clove powder and methamphetamine powder, methamphetamine ions were detected by tandem mass spectrometry. The developed probe heating method provides a simple method for the analysis of solid samples. A portable mass spectrometer incorporating this method would thus be useful for the onsite screening of illicit drugs.

Development of a portable mass spectrometer characterized by discontinuous sample gas introduction, a low-pressure dielectric barrier discharge ionization source, and a vacuumed headspace technique.

The present study has attempted to downscale a mass spectrometer in order to make it portable and enable onsite analysis with it. The development of a small mass spectrometer required the use of a compact pump whose displacement was small, decreasing the sensitivity of that spectrometer. To get high sensitivity with a small mass spectrometer, we have integrated novel techniques: a highly sensitive ionization source and efficient extraction of sample vapor. The low-pressure dielectric barrier discharge ionization (LP-DBDI) source made it possible to increase the conductance between the source and the mass analyzer, compared with ambient ionization sources, enhancing the efficiency of the ion transfer from the ionization source to the mass analyzer. We have also developed a vacuumed headspace method efficiently transporting the sample vapor to the ionization source. The sensitivity was further enhanced by also using a discontinuous sample gas introduction technique. A prototype portable mass spectrometer using those novel techniques was found to be sensitive enough to detect 0.1 ppm methamphetamine, 1 ppm amphetamine, 1 ppm 3,4-methylenedioxymethamphetamine, and 10 ppm cocaine in liquid.

Sensitive low-pressure dielectric barrier discharge ion source.

RATIONALE: We developed a novel highly sensitive soft ionization method: a low-pressure dielectric barrier discharge ionization (LP-DBDI) source. In this configuration, samples pass through the inside of a dielectric barrier discharge (DBD). Since samples pass through a DBD and its plasma jet, high ionization efficiency is expected. Furthermore, high transmission efficiency from the ion source to the mass spectrometer is also expected since the ion source is placed in a vacuum. METHODS: Mass spectrometric detection was carried out in positive ion mode using an ion trap mass spectrometer. The LP-DBDI source or a conventional atmospheric pressure chemical ionization (APCI) source was attached to the mass spectrometer. Samples were vaporized and sent to ion sources with air flowing at a constant flow rate of 1.5 L/min. The LP-DBDI source was compared with a conventional APCI source. RESULTS: Mass spectra of methyl salicylate, 2-undecanone and methamphetamine were acquired using the LP-DBDI source. Protonated molecules were mainly observed in the mass spectra. The sensitivities for methyl salicylate and 2-undecanone obtained using the LP-DBDI source were 44 times and 39 times higher, respectively, than those obtained using an APCI source. CONCLUSIONS: LP-DBDI is a soft ionization method characterized by only minor fragmentation, similar to APCI. The sensitivity of the LP-DBDI source was found to be about 40 times higher than that of the conventional APCI source.

High-throughput walkthrough detection portal for counter terrorism: detection of triacetone triperoxide (TATP) vapor by atmospheric-pressure chemical ionization ion trap mass spectrometry.

With the aim of improving security, a high-throughput portal system for detecting triacetone triperoxide (TATP) vapor emitted from passengers and luggage was developed. The portal system consists of a push-pull air sampler, an atmospheric-pressure chemical ionization (APCI) ion source, and an explosives detector based on mass spectrometry. To improve the sensitivity of the explosives detector, a novel linear ion trap mass spectrometer with wire electrodes (wire-LIT) is installed in the portal system. TATP signals were clearly obtained 2 s after the subject under detection passed through the portal system. Preliminary results on sensitivity and throughput show that the portal system is a useful tool for preventing the use of TATP-based improvised explosive devices by screening persons in places where many people are coming and going.

Mass-selective axial ejection from a linear ion trap with a direct current extraction field.

We have developed a new mass-selective axial ejection method from a linear ion trap (LIT). In this method, a set consisting of a trap wire lens and an extraction wire lens positioned orthogonally to each other was placed between quadrupole rods. The trap wire lens confines the ions inside the trap, and the extraction wire axially extracts ions from the trap. Ions introduced into the LIT are trapped between the inlet lens and the trap wire lens. In addition to the wire lenses, a set of excitation lenses, which are aligned orthogonally to the trap wire lens, are inserted between rods. The ions are resonantly excited in the direction perpendicular to the trap wire lens by applying a supplemental alternating current (AC) to the excitation lenses. Excited ions with a large motion pass over the trap wire lens, while unexcited ions remain trapped inside. Ions that have passed over the trap wire lens are then extracted by the extraction wire lens. The characteristics of the mass-selective ejection with a direct current (DC) extraction field were investigated by both simulation and experiment. A mass resolving power of m/Deltam = 1300 was achieved at a scan rate of 500 Th/s. The dependence of the ejection efficiency on trap wire lens bias was measured, and an ejection efficiency of 20% at a scan rate of 500 Th/s was achieved by optimizing the DC bias on the trap wire lens.

Solvent reorientation process in the "twisted" intramolecular charge-transfer process of cyanophenyldisilane-(H2O)2 cluster investigated by transient infrared spectroscopy.

The solvent reorientation process of the intramolecular charge-transfer (ICT) process of the (p-cyanophenyl)pentamethyldisilane-(H2O)2 (CPDS-(H2O)2) cluster in the excited-state was investigated by transient infrared (IR) absorption spectroscopy. It was found that there are at least two isomers in the charge-transfer (CT) state: one of the isomers exhibits a band of a pi-hydrogen-bonded OH stretch of the water moiety. Analyses of the IR spectra in the dominant isomers revealed that water molecules are hydrogen-bonded with each other in the CT state. This indicates that the reorientation process of the water molecules takes place to form such a dimer structure during the ICT process.

Direct observation of the solvent reorientation dynamics in the "twisted" intramolecular charge-transfer process of cyanophenyldisilane-water cluster by transient infrared spectroscopy.

The solvent reorientation dynamics of the intramolecular charge-transfer (ICT) process of the (p-cyanophenyl)pentamethyldisilane-H(2)O (CPDS-H(2)O) cluster was investigated by transient infrared (IR) absorption spectroscopy. Transient IR bands of two distinct charge-transfer (CT) states appeared in both the OH and the CN-stretching vibration regions. Analyses of the IR spectra and the time profiles of the transient bands revealed that the ICT process of the CPDS-H(2)O cluster proceeds in two steps. The first step is a transition from a photo-prepared locally excited (LE) state to the CT state, which is accompanied by a minor reorientation of the H(2)O moiety. In contrast, the second step is an extensive reorientation process of the H(2)O molecule in the CT state. These two reorientation processes exhibit very distinct pico- and nano-second time scales. In the latter case, a relatively slow time constant of 2 ns was related to a large geometric change in the orientation.

First observation of a dihydrogen bond involving the Si-H group in phenol-diethylmethylsilane clusters by infrared-ultraviolet double-resonance spectroscopy.

We have experimentally identified a dihydrogen bond involving the Si-H group in phenol-diethylmethylsilane (DEMS) clusters for the first time by IR-UV double-resonance spectroscopy. Vibrational shifts to lower frequency of 21-29 cm(-1) were found for the OH stretching vibration of three isomers of the phenol-DEMS clusters. Spectral simulations based on the MP2 calculations also support our observation. In addition to these clusters, dihydrogen bonds were also observed in the phenol-H(2)O-DEMS and (phenol)(2)-DEMS clusters, which exhibited much stronger interactions than the phenol-DEMS clusters.

Determination of the equilibrium structure of the charge-transfer state of (p-Cyanophenyl)pentamethyldisilane by means of transient infrared spectroscopy.

An equilibrium structure of the charge-transfer (CT) state of (p-cyanophenyl)pentamethyldisilane was determined by transient infrared absorption spectroscopy of its CH stretching vibration region, and by the spectral simulation with quantum chemical calculations. It was found that a pattern of the CH stretching vibration bands of the CT state is substantially different from that of the S0 state. This band feature of the CT state was well reproduced assuming the planar sigma(Si-Si)pi* state, where the disilanyl group and the phenyl ring lie in the same plane. Considering that the disilanyl group in the S0 and the locally excited pipi* states lie in the plane perpendicular to the phenyl ring, an occurrence of a twisting-type structural change during the ICT process was experimentally identified in the present study.

Intramolecular charge-transfer process of jet-cooled (p-cyanophenyl)pentamethyldisilane: roles of the torsional motion and the Si-Si bond change.

To investigate the intramolecular charge-transfer (ICT) process of (p-cyanophenyl)pentamethyldisilane (CPDS), laser-induced fluorescence, dispersed fluorescence, and two-color resonance enhanced two-photon ionization spectra were measured in a jet-cooled isolated condition. Dual fluorescence of CPDS was observed from a ground vibrational level in the locally excited pipi state. Similar to an emission from the charge-transfer (CT) state in solution, one of the dual emissions of the isolated molecule in the jet was assigned as the CT emission. A significant vibrational dependence on the ICT process was found as exciting vibronic levels of the molecule. It was identified that the promoting mode of the ICT process is a torsional motion of the disilanyl group with respect to the phenyl ring. It was also revealed that an effective appearance energy of the CPDS cation via the CT state is much lower than that via the locally excited pipi state suggesting that the electronic configuration of the CT state is similar to that of the cation. On the basis of an electronic configuration of the cationic state, that of the CT state was suggested to be of the (sigma(Si)(-)(Si), 2ppi) type.