A Free-Standing Polyaniline/Silicon Nanowire Forest as the Anode for Lithium-ion Batteries.

Despite its high theoretical capacity, silicon anode has limited intrinsic conductivity and experiences significant volume changes during charge-discharge. To overcome these issues, facile metal-assisted chemical etching and in-situ polymerization of aniline are employed to produce a dense 1D polyaniline/silicon nanowire forest without noticeable agglomeration as a free-standing anode for lithium-ion batteries. This hybrid electrode possesses high cycling performance, delivering a stable capacity capped at 2 mAh cm-2 for 346 cycles of charge-discharge. Maximum capacity of 2 mAh cm-2 is also achievable at high-rate cell testing of 2 mA cm-2 , which cannot be obtained by the anode with plain silicon wafer and silicon nanowire only. The introduction of polyaniline on the silicon nanowire is shown to reduce the solid electrolyte interface (SEI) resistance, stabilize the SEI layer, further alleviate the effect of volume changes, and boost the conductivity of the hybrid anode, resulting in the high electrochemical performance of the anode.

Piezoelectric MEMS Resonators for Cigarette Particle Detection.

In this work, we demonstrate the potential of a piezoelectric resonator for developing a low-cost sensor system to detect microscopic particles in real-time, which can be present in a wide variety of environments and workplaces. The sensor working principle is based on the resonance frequency shift caused by particles collected on the resonator surface. To test the sensor sensitivity obtained from mass-loading effects, an Aluminum Nitride-based piezoelectric resonator was exposed to cigarette particles in a sealed chamber. In order to determine the resonance parameters of interest, an interface circuit was implemented and included within both open-loop and closed-loop schemes for comparison. The system was capable of tracking the resonance frequency with a mass sensitivity of 8.8 Hz/ng. Although the tests shown here were proven by collecting particles from a cigarette, the results obtained in this application may have interest and can be extended towards other applications, such as monitoring of nanoparticles in a workplace environment.

Gold-modified indium tin oxide as a transparent window in optoelectronic diagnostics of electrochemically active biofilms.

Microbial electrochemical technologies (METs) are one of the emerging green bioenergy domains that are utilizing microorganisms for wastewater treatment or electrosynthesis. Real-time monitoring of bioprocess during operation is a prerequisite for understanding and further improving bioenergy harvesting. Optical methods are powerful tools for this, but require transparent, highly conductive and biocompatible electrodes. Whereas indium tin oxide (ITO) is a well-known transparent conductive oxide, it is a non-ideal platform for biofilm growth. Here, a straightforward approach of surface modification of ITO anodes with gold (Au) is demonstrated, to enhance direct microbial biofilm cultivation on their surface and to improve the produced current densities. The trade-off between the electrode transmittance (critical for the underlying integrated sensors) and the enhanced growth of biofilms (crucial for direct monitoring) is studied. Au-modified ITO electrodes show a faster and reproducible biofilm growth with three times higher maximum current densities and about 6.9 times thicker biofilms compared to their unmodified ITO counterparts. The electrochemical analysis confirms the enhanced performance and the reversibility of the ITO/Au electrodes. The catalytic effect of Au on the ITO surface seems to be the key factor of the observed performance improvement since the changes in the electrode conductivity and their surface wettability are relatively small and in the range of ITO. An integrated platform for the ITO/Au transparent electrode with light-emitting diodes was fabricated and its feasibility for optical biofilm thickness monitoring is demonstrated. Such transparent electrodes with embedded catalytic metals can serve as multifunctional windows for biofilm diagnostic microchips.