Crystal structure of the reduced form of p-hydroxybenzoate hydroxylase refined at 2.3 A resolution.

The crystal structure of the reduced form of the enzyme p-hydroxybenzoate hydroxylase from Pseudomonas fluorescens, complexed with its substrate p-hydroxybenzoate, has been obtained by protein X-ray crystallography. Crystals of the reduced form were prepared by soaking crystals of the oxidized enzyme-substrate complex in deaerated mother liquor containing 300-400 mM NADPH. A rapid bleaching of the crystals indicated the reduction of the enzyme-bound FAD by NADPH. This was confirmed by single crystal spectroscopy. X-ray data to 2.3 A were collected on oscillation films using a rotating anode generator as an X-ray source. After data processing and reduction, restrained least squares refinement using the 1.9 A structure of the oxidized enzyme-substrate complex as a starting model, yielded a crystallographic R-factor of 14.8% for 11,394 reflections. The final model of the reduced complex contains 3,098 protein atoms, the FAD molecule, the substrate p-hydroxybenzoate and 322 solvent molecules. The structures of the oxidized and reduced forms of the enzyme-substrate complex were found to be very similar. The root-mean-square discrepancy for all atoms between both structures was 0.38 A. The flavin ring is almost completely planar in the final model, although it was allowed to bend or twist during refinement. The observed angle between the benzene and the pyrimidine ring is 2 degrees. This value should be compared with observed values of 10 degrees for the oxidized enzyme-substrate complex and 19 degrees for the enzyme-product complex. The position of the substrate is virtually unaltered with respect to its position in the oxidized enzyme. No trace of a bound NADP+ or NADPH molecule was found.

The coenzyme analogue adenosine 5-diphosphoribose displaces FAD in the active site of p-hydroxybenzoate hydroxylase. An x-ray crystallographic investigation.

p-Hydroxybenzoate hydroxylase (PHBH) is an NADPH-dependent enzyme. To locate the NADPH binding site, the enzyme was crystallized under anaerobic conditions in the presence of the substrate p-hydroxybenzoate, the coenzyme analogue adenosine 5-diphosphoribose (ADPR), and sodium dithionite. This yielded colorless crystals that were suitable for X-ray analysis. Diffraction data were collected up to 2.7-A resolution. A difference Fourier between data from these colorless crystals and data from yellow crystals of the enzyme-substrate complex showed that in the colorless crystals the flavin ring was absent. The adenosine 5'-diphosphate moiety, which is the common part between FAD and ADPR, was still present. After restrained least-squares refinement of the enzyme-substrate complex with the riboflavin omitted from the model, additional electron density appeared near the pyrophosphate, which indicated the presence of an ADPR molecule in the FAD binding site of PHBH. The complete ADPR molecule was fitted to the electron density, and subsequent least-squares refinement resulted in a final R factor of 16.8%. Replacement of bound FAD by ADPR was confirmed by equilibrium dialysis, where it was shown that ADPR can effectively remove FAD from the enzyme under mild conditions in 0.1 M potassium phosphate buffer, pH 8.0. The empty pocket left by the flavin ring is filled by solvent, leaving the architecture of the active site and the binding of the substrate largely unaffected.

X-ray structure of lipoamide dehydrogenase from Azotobacter vinelandii determined by a combination of molecular and isomorphous replacement techniques.

The crystal structure of lipoamide dehydrogenase from Azotobacter vinelandii has been determined by a combination of molecular replacement and isomorphous replacement techniques yielding eventually a good-quality 2.8 A electron density map. Initially, the structure determination was attempted by molecular replacement procedures alone using a model of human glutathione reductase, which has 26% sequence identity with this bacterial dehydrogenase. The rotation function yielded the correct orientation of the model structure both when the glutathione reductase dimer and monomer were used as starting model. The translation function could not be solved, however. Consequently, data for two heavy-atom derivatives were collected using the Hamburg synchotron facilities. The derivatives had several sites in common, which was presumably a major reason why the electron density map obtained by isomorphous information alone was of poor quality. Application of solvent flattening procedures cleaned up the map considerably, however, showing clearly the outline of the lipoamide dehydrogenase dimer, which has a molecular weight of 100,000. Application of the "phased translation function", which combines the phase information of both isomorphous and molecular replacement, led to an unambiguous determination of the position of the model structure in the lipoamide dehydrogenase unit cell. The non-crystallographic 2-fold axis of the dimer was optimized by several cycles of constrained-restrained least-squares refinement and subsequently used for phase improvement by 2-fold density averaging. After ten cycles at 3.5 A, the resolution was gradually extended to 2.8 A in another 140 cycles. The 2.8 A electron density distribution obtained in this manner was of much improved quality and allowed building of an atomic model of A. vinelandii lipoamide dehydrogenase. It appears that in the orthorhombic crystals used each dimer is involved in contacts with eight surrounding dimers, leaving unexplained why the crystals are rather fragile. Contacts between subunits within one dimer, which are quite extensive, can be divided into two regions separated by a cavity. In one of the contact regions, the level of sequence identity with glutathione reductase is very low but it is quite high in the other. The folding of the polypeptide chain in each subunit is quite similar to that of glutathione reductase, as is the extended conformation of the co-enzyme FAD.(ABSTRACT TRUNCATED AT 400 WORDS)

The influence of purification and protein heterogeneity on the crystallization of p-hydroxybenzoate hydroxylase.

The structure of the enzyme p-hydroxybenzoate hydroxylase was determined to a resolution of 0.25 nm [Wierenga et al. (1979) J. Mol. Biol. 131, 53-73] with crystals belonging to space group C222(1). Subsequently it was impossible to repeat the growth of this crystal form and only poor quality tetragonal crystals could be obtained. We have thoroughly investigated this problem and found that Cibacron-blue-purified enzyme appears to be heterogeneous with respect to aggregation state and Cys-116 oxidation. Most importantly, it could be firmly established that C222(1) crystals can only be grown from purely dimeric p-hydroxybenzoate hydroxylase possessing an intact SH group. Ion-exchange chromatography on DEAE-Sepharose can successfully remove those forms of the enzyme which impede successful crystallization. Sulfite and dithiothreitol improve crystallization by dissociating the enzyme oligomers into dimers; sulfite especially gives excellent results.

Purification, crystallization and preliminary X-ray investigation of quinoprotein methylamine dehydrogenase from Thiobacillus versutus.

The enzyme methylamine dehydrogenase or primary-amine:(acceptor) oxidoreductase (deaminating) (EC 1.4.99.3) was purified from the bacterium Thiobacillus versutus to homogeneity, as judged by polyacrylamide gel electrophoresis. The native enzyme has a Mr of 123 500 and contains four subunits arranged in a alpha 2 beta 2 configuration, the light and heavy subunits having a Mr of 12900 and 47500 respectively. The isoelectric point is 3.9. The purified enzyme was crystallized from 37--42% saturated ammonium sulphate in 0.1 M sodium acetate buffer, pH 5.0. The space group is P3(1)21 or P3(2)21, with one alpha 2 beta 2 molecule in the asymmetric unit. The cell dimensions are: a = b = 13.01 nm; c = 10.40 nm. The X-ray diffraction pattern extends to at least 0.25-nm resolution.

Heat-labile enterotoxin of Escherichia coli. Characterization of different crystal forms.

Heat-labile enterotoxin (LT) was obtained in large quantities (several-gram amounts) and great purity from Escherichia coli C600 carrying the LT-coding multicopy plasmid EWD299. By growing this strain on a medium that allows high cell densities in the early stationary phase, we increased the net LT production per milliliter by a factor of 200, compared to natural porcine enterotoxigenic E. coli. Adsorption and redesorption on Controlled-Pore Glass usually resulted in a 50-100-fold purification of LT in one simple step, which was followed by established purification procedures. LT shows a natural tendency to form large crystals, which, however, are disordered. After numerous trials, conditions were found which virtually eliminated the disorder. Much better crystals were obtained by employing CdCl2 and KF as coprecipitating agents. CdCl2 yielded crystals which did not contain A subunits as judged by electrophoresis of dissolved crystals. Adding KF results in beautifully shaped crystals which diffracted beyond 2 A and are suitable for a high resolution structure determination.

Structure of papain refined at 1.65 A resolution.

Papain is a sulfhydryl protease from the latex of the papaya fruit. Its molecules consist of one polypeptide chain with 212 amino acid residues. The chain is folded into two domains with the active site in a groove between the domains. We have refined the crystal structure of papain, in which the sulfhydryl group was oxidized, by a restrained least-squares procedure at 1.65 A to an R-factor of 16.1%. The estimated accuracy in the atomic co-ordinates is 0.1 A, except for disordered atoms. All phi/psi angles for non-glycine residues are found within the outer limit boundary of a Ramachandran plot and this provides another check on the quality of the model. In the alpha-helical parts of the structure, the C = O bonds are directed more away from the helix axis than in a classical alpha-helix, leading to somewhat longer hydrogen bonds, 2.98 A, compared to 2.89 A. The hydrogen-bonding parameters and conformational angles in the anti-parallel beta-sheet structure show a large diversity. Hydrogen bonds in the core of the sheet are generally shorter than those at the more twisted ends. The average value is 2.91 A. The hydrogen bond distance Ni+3-Oi in turns is relatively long and the geometry is far from linear. Hydrogen bond formation, therefore, is perhaps not an essential prerequisite for turn formation. Although the crystallization medium is 62% (w/w) methanol in water, only 29 out of 224 solvent molecules can be regarded with any certainty as methanol molecules. The water molecules play an important role in maintaining structural stability. This is specially true for internal water. Twenty-one water molecules are located in contact areas between adjacent papain molecules. It seems as if the enzyme is trapped in a grid of water molecules with only a limited number of direct interactions between the protein molecules. The residues in the active site cleft belong to the most static parts of the structure. In general, disorder in atomic positions increases when going from the interior of the protein molecule to its surface. This behavior was quantified and it was found that the point of minimum disorder is near the molecular centroid.