Effects of Oritavancin on Coagulation Tests in the Clinical Laboratory.

Previous studies have shown that some lipoglycopeptide and lipopeptide antimicrobial agents may cause falsely elevated values for some phospholipid-dependent coagulation tests. The effect of oritavancin, a lipoglycopeptide antibiotic, on coagulation test results was explored using pooled human plasma samples spiked with drug and in a clinical study after an infusion of a single 1,200-mg intravenous dose of oritavancin in normal healthy volunteers. Pooled plasma with oritavancin added ex vivo showed concentration-dependent prolongation of prothrombin time/international normalized ratio (PT/INR), activated partial thromboplastin time (aPTT), and dilute Russell viper venom time (DRVVT) test results. In contrast, oritavancin had no effect on the activated protein C resistance assay, chromogenic anti-factor Xa assay (anti-FXa), thrombin time, and an immunoassay for the laboratory diagnosis of heparin-induced thrombocytopenia. In participants that received a single dose of oritavancin, elevations in PT/INR result, aPTT, DRVVT, activated clotting time, and silica clotting time occurred, with the maximum times to resolution of test interference determined to be 12, 120, 72, 24, and 18 h, respectively. The anti-FXa assay was unaffected, whereas transient elevations in D dimer levels were observed in 30% of participants, with a maximum time to resolution of 72 h. Although oritavancin has no impact on the coagulation system in vivo, a single dose of oritavancin can produce falsely elevated values of some coagulation tests used to monitor hemostasis. The interference of oritavancin on affected tests is transient, and the test results revert to normal ranges within specified times after dosing.

Characterization of a thermostable hepatitis B vaccine formulation.

Cold chain requirements for vaccine storage and distribution are both economic and logistical burdens for immunization programs, especially those in lower-resource settings. Inadvertent exposure of vaccines to both heat and freezing temperatures within such cold chains are frequently occurring problems in both developing and industrialized countries. Here we report on a new hepatitis B vaccine formulation that is stable against repeated freezing at -20 degrees C and is also stable for 12 months at 37 degrees C. The thermostable vaccine contains all the components of the original vaccine plus 7.5% (v/v) propylene glycol, 40mM phosphate, and 40mM histidine with a final pH of 5.2. The propylene glycol is responsible for the freeze stability while the other components are essential for the heat stability. This formulation was found to be well tolerated in rabbits without any significant local or systemic side effects. The improved stability of this hepatitis B vaccine could be a key factor in ensuring vaccine effectiveness, extending immunization coverage, simplifying immunization logistics, and reducing the costs associated with the cold chain.

Development of a freeze-stable formulation for vaccines containing aluminum salt adjuvants.

Vaccines containing aluminum salt adjuvants are prone to inactivation following exposure to freeze-thaw stress. Many are also prone to inactivation by heat. Thus, for maximum potency, these vaccines must be maintained at temperatures between 2 degrees C and 8 degrees C which requires the use of the cold chain. Nevertheless, the cold chain is not infallible. Vaccines are subject to freezing during both transport and storage, and frozen vaccines are discarded (under the best circumstances) or inadvertently administered despite potentially reduced potency. Here we describe an approach to minimize our reliance on the proper implementation of the cold chain to protect vaccines from freeze-thaw inactivation. By including PEG 300, propylene glycol, or glycerol in a hepatitis B vaccine, particle agglomeration, changes in the fluorescence emission spectrum--indicative of antigen tertiary structural changes--and losses of in vitro and in vivo indicators of potency were prevented following multiple exposures to -20 degrees C. The effect of propylene glycol was examined in more detail and revealed that even at concentrations too low to prevent freezing at -10 degrees C, -20 degrees C, and -80 degrees C, damage to the vaccine could be prevented. A pilot study using two commercially available diphtheria, tetanus toxoid, and acellular pertussis (DTaP) vaccines suggested that the same stabilizers might protect these vaccines from freeze-thaw agglomeration as well. It remains to be determined if preventing agglomeration of DTaP vaccines preserves their antigenic activity following freeze-thaw events.

Characterization of the freeze sensitivity of a hepatitis B vaccine.

Recent studies have revealed that vaccines containing aluminum adjuvant are exposed to sub-zero temperatures while in the cold chain more frequently than was previously believed. This raises concerns that these freeze-sensitive vaccines may be damaged and offer inadequate protection. This study was undertaken to characterize the immediate qualitative changes of one such vaccine, hepatitis B, caused by freeze exposure. Hepatitis B vaccine was subjected to freezing temperatures ranging from 0 degrees C to -20 degrees C for up to three episodes with durations ranging from 1 hour to 7 days. The vaccine was analyzed for freezing point, particle size distribution, tertiary structure, and in vitro and in vivo potency. Whether or not hepatitis B vaccine freezes was shown to be dependent on an array of factors including temperature, rate of temperature change, duration of exposure, supercooling effects and vibration. Vaccine exposed to "mild" freezing (-4 degrees C or warmer) temperatures did not freeze and remained qualitatively unaltered. Single or repeated freezing events at temperatures of -10 degrees C or lower were associated with aggregation of the adjuvant-antigen particles, structural damage of the antigen, and reduction of immunogenicity in mice. Damage to the vaccine increased with duration of freezing, lower temperature, and the number of freezing episodes. With vibration, vaccine froze at -6 degrees C after 1 hour and damage occurred. Freezing and freeze damage to vaccines containing aluminum salt adjuvant represent real risks to the effectiveness of immunization and should be prevented by strengthening the cold chain system or, alternatively, development of freeze-stable vaccine formulations.