Nanowire forest of pnictogen-chalcogenide alloys for thermoelectricity.

Pnictogen and chalcogenide compounds have been seen as high-potential materials for efficient thermoelectric conversion over the past few decades. It is also known that with nanostructuration, the physical properties of these pnictogen-chalcogenide compounds can be further enhanced towards a more efficient heat conversion. Here, we report the reduced thermal conductivity of a large ensemble of Bi2Te3 alloy nanowires (70 nm in diameter) with selenium for n-type and antimony for p-type (Bi2Te3-ySey and Bi2-xSbxTe3 respectively). The nanowire growth was carried out through electrodeposition in nanoporous aluminium oxide templates with high aspect ratios leading to a forest (109 per centimetre square) of nearly identical nanowires. The temperature dependence of thermal conductivity for the nanowire ensembles was acquired through a highly sensitive 3ω measurement technique. The change in the thermal conductivity of nanowires is largely affected by the roughness in addition to the size effect due to enhanced boundary scattering. The major factor that influences the thermal conductivity was found to be the ratio of the rms roughness to the correlation length of the nanowire. With a high Seebeck coefficient and electrical conductivity at room temperature, the overall thermoelectric figure of merit ZT allows the consideration of such forests of nanowires as efficient potential building blocks of future TE devices.

Measurement of anisotropic thermal conductivity of a dense forest of nanowires using the 3ω method.

The 3ω method is a dynamic measurement technique developed for determining the thermal conductivity of thin films or semi-infinite bulk materials. A simplified model is often applied to deduce the thermal conductivity from the slope of the real part of the ac temperature amplitude as a function of the logarithm of frequency, which in-turn brings a limitation on the kind of samples under observation. In this work, we have measured the thermal conductivity of a forest of nanowires embedded in nanoporous alumina membranes using the 3ω method. An analytical solution of 2D heat conduction is then used to model the multilayer system, considering the anisotropic thermal properties of the different layers, substrate thermal conductivity, and their thicknesses. Data treatment is performed by fitting the experimental results with the 2D model on two different sets of nanowires (silicon and BiSbTe) embedded in the matrix of nanoporous alumina templates, having thermal conductivities that differ by at least one order of magnitude. These experimental results show that this method extends the applicability of the 3ω technique to more complex systems having anisotropic thermal properties.

Specific heat measurement of thin suspended SiN membrane from 8 K to 300 K using the 3ω-Völklein method.

We present a specific heat measurement technique adapted to thin or very thin suspended membranes from low temperature (8 K) to 300 K. The presented device allows the measurement of the heat capacity of a 70 ng silicon nitride membrane (50 or 100 nm thick), corresponding to a heat capacity of 1.4 × 10(-10) J/K at 8 K and 5.1 × 10(-8) J/K at 300 K. Measurements are performed using the 3ω method coupled to the Völklein geometry. This configuration allows the measurement of both specific heat and thermal conductivity within the same experiment. A transducer (heater/thermometer) is used to create an oscillation of the heat flux on the membrane; the voltage oscillation appearing at the third harmonic which contains the thermal information is measured using a Wheatstone bridge set-up. The heat capacity measurement is performed by measuring the variation of the 3ω voltage over a wide frequency range and by fitting the experimental data using a thermal model adapted to the heat transfer across the membrane. The experimental data are compared to a regular Debye model; the specific heat exhibits features commonly seen for glasses at low temperature.