ABSTRACT
A novel technique for the integration of planar-type single-electron transistors (SETs) composed of nanogaps is presented. This technique is based on the electromigration procedure, which is caused by a field emission current. The technique is called "activation." By applying the activation to the nanogaps, SETs can be easily obtained. Furthermore, the charging energy of the SETs can be controlled by adjusting the magnitude of the applied current during the activation process. The integration of two SETs was achieved by passing a field emission current through two series-connected initial nanogaps. The current-voltage (I(D)-V(D)) curves of the simultaneously activated devices exhibited clear electrical-current suppression at a low-bias voltage at 16 K, which is known as the Coulomb blockade. The Coulomb blockade voltage of each device was also obviously modulated by the gate voltage. In addition, the two SETs, which were integrated by the activation procedure, exhibited similar electrical properties, and their charging energy decreased uniformly with increasing the preset current during the activation. These results indicate that the activation procedure allows the simple and easy integration of planar-type SETs.
ABSTRACT
A newly investigated technique for the tuning of the tunnel resistance of nanogaps using electromigration method induced by a field emission current is presented to reduce the power consumption during the process. The method is called "activation" and is demonstrated with a current source. Planar-type initial nanogaps of Ni separated by 20-80 nm were defined on SiO2/Si substrates via electron-beam lithography and the lift-off process. Then, a bias current was applied to the initial nanogaps at room temperature, using a current source. The applied current was slowly ramped up until it reached the preset value. As a result, the process time of the current-source-based activation was 16 times shorter than activation using a voltage source. Furthermore, the tunnel resistance of the nanogaps was reduced from 100 T ohms to 70 M ohms by increasing preset current I(s) from 1 nA to 3.5 microA. Regarding the average power required for current-source-based activation, it can be successfully suppressed compared with that of voltage-source-based activation. These results imply that the current source directly and precisely tunes the field emission current passing through the nanogaps, and effectively causes the migration of atoms across the nanogaps, resulting in the successful control of the tunnel resistance of the nanogaps.
