ABSTRACT
This study introduces a zwitterionic material to modify polysulfone (PSf) membranes formed by a dual bath procedure, in view of reducing their fouling propensity. The zwitterionic copolymer, derived from a random polymer of styrene and 4-vinylpyrridine and referred to as zP(S-r-4VP), was incorporated to the PSf solution without any supplementary pore-forming additive to study the effect of the sole copolymer on membrane-structuring, chemical, and arising properties. XPS and mapping FT-IR provided evidence of the modification. Macrovoids appeared and then disappeared as the copolymer content increased in the range 1-4 wt%. The copolymer has hydrophilic units and its addition increases the casting solution viscosity. Both effects play an opposite role on transfers, and so on the growth of macrovoids. Biofouling tests demonstrated the efficiency of the copolymer to mitigate biofouling with a reduction in bacterial and blood cell attachment by more than 85%. Filtration tests revealed that the permeability increased by a twofold factor, the flux recovery ratio was augmented from 40% to 63% after water/BSA cycles, and irreversible fouling was reduced by 1/3. Although improvements are needed, these zwitterionic PSf membranes could be used in biomedical applications where resistance to biofouling by cells is a requirement.
ABSTRACT
Air plasma and spray technology are common methods for surface modification. In this study, air plasma is used to generate hydroxyl groups on various material surfaces. Then random copolymers of styrene and ethylene glycol methacrylate (PS-r-PEGMA) are spray-coated to achieve coating densities ranging between 0.1 and 0.6 mg/cm2. PS50-r-PEGMA50 led to the best overall antifouling properties, while a coating density of 0.3 mg/cm2 was enough to significantly reduce biofouling. This surface modification technique enabled efficient modification of a wide range of materials and biofouling reduction by at least 75% on polymeric surfaces (polystyrene, polyvinylidene fluoride, poly(tetrafluoroethylene), polydimethylsiloxane), metallic surfaces (steel, titanium alloy), or ceramic surface (glass). Applied to the modification of well plate used for blood-typing, this antifouling modification permitted to greatly increase the signal sensitivity (×4).
Subject(s)
Biofouling , Biofouling/prevention & control , Polymers , Polystyrenes , Titanium , UltrasonicsABSTRACT
Poly(ethylene terephtalate) (PET)-based materials face general biofouling issues that we addressed by grafting a copolymer of glycidyl methacrylate and sulfobetaine methacrylate, poly(GMA- r-SBMA). The grafting procedure involved a dip-coating step followed by UV-exposure and led to successful grafting of the copolymer as evidenced by X-ray photoelectron spectroscopy and zeta potential measurements. It did not modify the pore size nor the porosity of the PET membranes. In addition, their surface hydrophilicity was considerably improved, with a water contact angle falling to 30° in less than 20 s and 0° in less than 1 min. The effect of copolymer concentration in the coating bath (dip-coating procedure) and UV exposure time (UV step) were scrutinized during biofouling studies involving several bacteria such as Escherichia coli and Stenotrophomonas maltophilia, but also whole blood and HT1080 fibroblasts cells. The results indicate that if all conditions led to improved biofouling mitigation, due to the efficiency of the zwitterionic copolymer and grafting procedure, a higher concentration (15 mg/mL) and longer UV exposure time (at least 10 min) enhanced the grafting density which reflected on the biofouling results and permitted a better general biofouling control regardless of the nature of the biofoulant (bacteria, blood cells, fibroblasts).
