Management of agricultural biomass wastes: preliminary study on characterization and valorisation in clay matrix bricks.

In this work the feasibility of using woody agricultural biomass wastes as grapes and cherries seeds, sawdust, as pore forming agent, and sugar cane ash, as silica precursor, in bricks, were reported. Sawdust and grapes and cherries seeds, thanks to their organic substances content, during their combustion, bring an energetic support in the bricks firing phase and act as pore forming agent. Usually the addition of this kind of waste is limited to 10wt.% in order to reach an equilibrium between positive (weight and shrinkage decrease and porosity increase) and negative (increase of water absorption and mechanical resistance decrease) effects. The results show that grapes and cherries seeds, added in a percentage of 5wt.% to a brick formulation, have better influence with respect to the sawdust, maintaining the mechanical properties of the fired brick (950°C), showing modulus of rupture around 21-23MPa with a weight reduction of 3-10% (respect to the standard one). Regarding the sugar cane ash, the addition of 5wt.% improves the mechanical properties (modulus of rupture around 27MPa) and no weight decrease is observed. These results confirmed the role played by this kind of agricultural waste, which thanks to its high silica content (61wt.%) is capable to demonstrate a filler and plasticity reducing effect on the brick bodies. Tests carried out highlighted that the addition of these by-products (5wt.%) do not change negatively the main technological properties measured (water absorption, linear shrinkage, flexural resistance, etc.) and permit to hypothesize their use to obtain bricks with both insulating and higher mechanical properties using a pore agent forming or silica carrier alternative raw materials, respectively.

Facile characterization of polymer fractions from waste electrical and electronic equipment (WEEE) for mechanical recycling.

In view of the environmental problem involved in the management of WEEE, and then in the recycling of post-consumer plastic of WEEE there is a pressing need for rapid measurement technologies for simple identification of the various commercial plastic materials and of the several contaminants, to improve the recycling of such wastes. This research is focused on the characterization and recycling of two types of plastics, namely plastic from personal computer (grey plastic) and plastic from television (black plastic). Various analytical techniques were used to monitor the compositions of WEEE. Initially, the chemical structure of each plastic material was identified by Fourier transform infrared (FTIR) spectroscopy and differential scanning calorimetry (DSC). Polymeric contaminants of these plastics, in particular brominated flame retardants (BFRs) were detected in grey plastics only using different techniques. These techniques are useful for a rapid, correct and economics identification of a large volumes of WEEE plastics.

Facile preparation of superhydrophobic coatings by sol-gel processes.

Different organic/inorganic compositions and deposition methods were used to prepare superhydrophobic surfaces using metal alkoxides and the sol-gel process. Both surface roughness and composition had to be adjusted in order to obtain very high contact angles and low contact angle hysteresis as a necessary requirement for superhydrophobicity. Multilayer samples with a fluorinated organic-inorganic top layer showed water contact angles of about 157 degrees with low hysteresis (2 degrees ). Water drops rolled easily off their surface at a tilt angle as low as 4 degrees .