Reversible spin storage in metal oxide-fullerene heterojunctions.

We show that hybrid MnOx/C60 heterojunctions can be used to design a storage device for spin-polarized charge: a spin capacitor. Hybridization at the carbon-metal oxide interface leads to spin-polarized charge trapping after an applied voltage or photocurrent. Strong electronic structure changes, including a 1-eV energy shift and spin polarization in the C60 lowest unoccupied molecular orbital, are then revealed by x-ray absorption spectroscopy, in agreement with density functional theory simulations. Muon spin spectroscopy measurements give further independent evidence of local spin ordering and magnetic moments optically/electronically stored at the heterojunctions. These spin-polarized states dissipate when shorting the electrodes. The spin storage decay time is controlled by magnetic ordering at the interface, leading to coherence times of seconds to hours even at room temperature.

The potential of imogolite nanotubes as (co-)photocatalysts: a linear-scaling density functional theory study.

We report a linear-scaling density functional theory (DFT) study of the structure, wall-polarization absolute band-alignment and optical absorption of several, recently synthesized, open-ended imogolite (Imo) nanotubes (NTs), namely single-walled (SW) aluminosilicate (AlSi), SW aluminogermanate (AlGe), SW methylated aluminosilicate (AlSi-Me), and double-walled (DW) AlGe NTs. Simulations with three different semi-local and dispersion-corrected DFT-functionals reveal that the NT wall-polarization can be increased by nearly a factor of four going from SW-AlSi-Me to DW-AlGe. Absolute vacuum alignment of the NT electronic bands and comparison with those of rutile and anatase TiO2 suggest that the NTs may exhibit marked propensity to both photo-reduction and hole-scavenging. Characterization of the NTs' band-separation and optical properties reveal the occurrence of (near-)UV inside-outside charge-transfer excitations, which may be effective for electron-hole separation and enhanced photocatalytic activity. Finally, the effects of the NTs' wall-polarization on the absolute alignment of electron and hole acceptor states of interacting water (H2O) molecules are quantified and discussed.

Scanning tunneling microscopy contrast mechanisms for TiO2.

Controlled dual mode scanning tunneling microscopy (STM) experiments and first-principles simulations show that the tunneling conditions can significantly alter the positive-bias topographic contrast of geometrically corrugated titania surfaces such as rutile TiO2(011)-(2×1). Depending on the tip-surface distance, two different contrasts can be reversibly imaged. STM simulations which either include or neglect the tip-electronic structure, carried out at three density functional theory levels of increasing accuracy, allow assignment of both contrasts on the basis of the TiO2(011)-(2×1) structure proposed by Torrelles et al. [Phys. Rev. Lett. 101, 185501 (2008)]. Finally, the mechanisms of contrast formation are elucidated in terms of the subtle balance between the surface geometry and the different vacuum decay lengths of the topmost Ti(3d) and O(2p) states probed by the STM-tip apex.

Chemical resolution at ionic crystal surfaces using dynamic atomic force microscopy with metallic tips.

We demonstrate that well prepared and characterized Cr tips can provide atomic resolution on the bulk NaCl(001) surface with dynamic atomic force microscopy in the noncontact regime at relatively large tip-sample separations. At these conditions, the surface chemical structure can be resolved yet tip-surface instabilities are absent. Our calculations demonstrate that chemical identification is unambiguous, because the interaction is always largest above the anions. This conclusion is generally valid for other polar surfaces, and can thus provide a new practical route for straightforward interpretation of atomically resolved images.

Geometric structure of TiO2(011)(2 x 1).

Surface x-ray diffraction has been employed to elucidate the surface structure of the (011)-(2 x 1) termination of rutile TiO2. The data are inconsistent with previously proposed structures. Instead, an entirely unanticipated geometry emerges from the structure determination, which is terminated by zigzag rows of twofold coordinated oxygen atoms asymmetrically bonded to fivefold titanium atoms. The energetic stability of this structure is demonstrated by ab initio total energy calculations.

Adsorption of benzene, fluorobenzene and meta-di-fluorobenzene on Cu(110): a computational study.

We modelled the adsorption of benzene, fluorobenzene and meta-di-fluorobenzene on Cu(110) by Density Functional Theory. We found that the adsorption configuration depends on the coverage. At high coverage, benzene assumes a tilted position, while at low coverage a horizontal slightly distorted geometry is favoured. Functionalizing the benzene ring with one or two fluorine atoms weakens the bonding to the surface. A rotation is induced, which decreases the distance of the fluorine atom from the surface. STM simulations reveal that details about both, benzene adsorption geometry and fluorine position, can be only detected at short tip-surface distances.