Subject(s)
Dental Health Services/standards , Health Services for the Aged/standards , Oral Health , Aged , Humans , Nursing Homes , SingaporeABSTRACT
OBJECTIVE: The aim of this pilot study was to assess the oral health knowledge among staff working in a local nursing home managed by a voluntary welfare organisation. METHOD: A self-administered questionnaire was completed by 53 nursing staff working in a home with 270 residents. The questionnaire was structured to assess the staff's knowledge of dental caries, periodontal disease and the care and use of dentures. RESULTS: 99.6% of the respondents felt that oral health care of the elderly was very important. However, only 45.3% of them attributed the cause of dental caries to the frequent intake of sugar. Bacteria in dental plaque was identified by 88.7% of them as the main cause of periodontal disease while 96.2% of them indicated that dentures should be cleaned at least once a day and rinsed after every meal. CONCLUSION: The staff of this nursing home demonstrated positive knowledge of periodontal disease and denture care. However, their knowledge of dental caries revealed substantial room for improvement. This could signal an area for future staff training and development. Such efforts would help establish a team of caregivers who can improve the oral health and quality of life for residents in the nursing home.
Subject(s)
Health Education, Dental , Nursing Homes , Nursing Staff , Adult , Aged , Aged, 80 and over , Attitude of Health Personnel , Attitude to Health , Dental Caries/etiology , Dental Plaque/microbiology , Dentures , Dietary Sucrose/adverse effects , Humans , Inservice Training , Middle Aged , Oral Hygiene , Periodontal Diseases/etiology , Pilot Projects , Quality of Life , Singapore , WorkforceABSTRACT
High-strength dental stone is widely used to produce dies for the fabrication of restorations with the lost-wax technique. It is normal to wait at least 24 hours for casts to dry and gain sufficient strength prior to initiating laboratory procedures. This waiting time may be greatly reduced by using microwave drying. This study determined the optimum microwave energy density for preserving working die accuracy of a Type IV high-strength dental stone (Silky Rock; Whipmix). Cylindrical die specimens were fabricated according to manufacturer's instructions and allowed to set for one hour. The specimens were subsequently treated as follows: Group I (Control group)--air dried; Group II--microwaved at 700W for 40 seconds; Group III--microwaved at 490W for 60 seconds. The percentage weight loss of cylindrical specimens (n = 6) and the percentage dimensional change (n = 7) of die specimens in three axes (x, y and z) were determined at 30 minutes, 1 hour and 24 hours after air drying/microwaving. Weight loss was measured using an electronic digital balance, while dimensional changes were assessed using image analysis software. Data was subject to ANOVA/Scheffe's tests at significance level 0.05. No significant difference in percentage weight loss was observed between air drying for 24 hours and microwaved specimens at all time intervals. Although no significant difference in percentage dimensional changes was observed between specimens microwaved at 490W for 60 seconds and specimens air dried for 24 hours, significant changes in x, y and z dimensions were observed after microwaving at 700W for 40 seconds at various time intervals. Microwave radiation at 490W for 60 seconds is recommended for drying Type IV high-strength dental stone. Further investigations are required to determine changes in physical properties associated with the aforementioned microwave power density.
