Enhancing Photoelectric Powder Deposition of Polymers by Charge Control Substances.

Charge control substances (CCS) as additives for polymer powders are investigated to make polymer powders suitable for the electrophotographic powder deposition in powder-based additive manufacturing. The use of CCS unifies the occurring charge of a powder, which is crucial for this novel deposition method. Therefore, commercially available polymer powder is functionalized via dry coating in a shaker mixer with two different CCS and analyzed afterwards. The flowability and the degree of coverage of additives on the surface are used to evaluate the coating process. The thermal properties are analyzed by use of differential scanning calorimetry. Most important, the influence of the CCS on the powder charge is shown by measurements of the electrostatic surface potential at first and the powder deposition itself is performed and analyzed with selected formulations afterwards to show the potential of this method. Finally, tensile strength specimens are produced with the conventional deposition method in order to show the usability of the CCS for current machines.

Abrasion-Induced Acceleration of Melt Crystallisation of Wet Comminuted Polybutylene Terephthalate (PBT).

Within this contribution, the effect of grinding media wear on the melt crystallisation of polybutylene terephthalate (PBT) is addressed. PBT was wet ground in a stirred media mill in ethanol using different grinding media beads (silica, chrome steel, cerium-stabilised and yttrium-stabilised zirconia) at comparable stress energies with the intention to use the obtained particles as feed materials for the production of feedstocks for laser powder bed fusion additive manufacturing (PBF-AM). In PBF­AM, the feedstock's optical, rheological and especially thermal properties-including melt crystallisation kinetics-strongly influence the processability and properties of the manufactured parts. The influence of process parameters and used grinding media during wet comminution on the optical properties, crystal structure, molar mass distribution, inorganic content (wear) and thermal properties of the obtained powders is discussed. A grinding media-dependent acceleration of the melt crystallisation could be attributed to wear particles serving as nuclei for heterogeneous crystallisation. Yttrium-stabilised zirconia grinding beads proved to be the most suitable for the production of polymer powders for the PBF process in terms of (fast) comminution kinetics, unchanged optical properties and the least accelerated crystallisation kinetics.