ABSTRACT
The article presents significant results in research on creating superhydrophobic properties of materials which can be used as an interesting material for use in self-cleaning polymer protective gloves and similar applications where the superhydrophobicity plays a significant role. In this work the influence of laser surface modification of MVQ silicone rubber was investigated. The research was conducted using a nanosecond-pulsed laser at 1060 nm wavelength. After a process of laser ablation, the surface condition was examined using a SEM microscope and infrared spectroscopy. During the tests, the contact angle was checked both before and after the laser modification of samples pre-geometrised in the process of their production. The test results presented in the paper indicate that the chemical and physical modifications contribute to the change in the MVQ silicone rubber contact angle. A significant increase (by more than 30°) in the contact angle to 138° was observed. It was confirmed that surface geometrisation is not the only factor contributing to an increase in the contact angle of the analyzed material; other factors include a change in laser texturing parameters, such as mean beam power, pulse duration, scanning speed and pulse repetition frequency.
ABSTRACT
For physical vapor deposition (PVD) technology, cleaning a substrate is one of the key preliminary processes before depositing the metal layer. In this article, we present the results of research on the modification of a textile composite substrate using laser technology and its influence on the surface resistance of silver structures intended for use in wearable electronics. As a result of the substrate modification, the resistance of the layers increased as compared with the structures produced on an unmodified substrate. An experimental planning technique was used to optimize the laser modification process.
ABSTRACT
This paper describes a method of laser ablation for improving the hydrophobic properties of vulcanized rubber. The treatment was tested on acrylonitrile rubber (NBR) and styrene butadiene rubber (SBR) containing carbon nanotubes and soot as fillers. The surface layer of the vulcanizates was modified using a nanosecond-pulsed laser at 1060 nm wavelength. The parameters of the ablation process were congruent, so no chemical changes in the polymeric material were observed. Evaluation of the surface condition of the laser-textured samples was performed using a Leica MZ6 stereoscopic microscope, operating with MultiScan 8.0 image analysis software. The contact angles were determined for all the samples before and after the surface modification process. Following modification of the surface morphology, with the best parameters of laser ablation, the contact angle increased, reaching 147°, which is very close to the threshold of superhydrophobicity (150°). On the basis of the results from several tests, laser ablation with a fiber-pulsed laser can be considered a very useful method for producing rubbers with superhydrophobic surfaces.
