Biochar as a sustainable alternative to carbon black in agricultural mulch films.

Examples of biochar as an alternative to traditional plastic fillers, like carbon black, are numerous and growing. However, in the agricultural mulch film application, both the polymer and its fillers are pushed to their mechanical limit to obtain an effective product, using the least amount of plastic. Through a combined techno-economic analysis (TEA) and life cycle assessment (LCA), this study characterizes the use of carbon-negative biochar as an opacity filler in mulch film applications. Due to its larger particle size, the biochar demands additional thickness to achieve equivalent opacity as carbon black in films. A thicker film translates to additional polymer demand, and a significant increase in price and environmental impact. A comparable formulation for an equal price ($623 per mulched ha) as a 2.6 wt % carbon black with 25 µm thickness was derived, needing 15 wt % biochar and a thickness of 30 µm. The biochar formulation resulted in a slightly higher global warming potential (3% increase), but much larger impact in the land use category (+339%), and the sample was deemed not fit for use in the intended mulch application. These results indicate that in applications where the polymeric matrix and its fillers are pushed to their mechanical limit, the displacement of traditional fillers by biochar is challenging. However, biochar derived from waste biomass (thus reducing land use impact) remains a valid, environmentally beneficial solution to displace traditional fillers for non-extreme plastic uses (commodity plastics) and thicker composites.

Evaluation of dose exposure in 64-slice CT colonography.

The radiation exposure of four different 64-slice MDCT-colonography (CTC) protocols was evaluated using an Alderson-Rando phantom. Protocols using 30 mAs (collimation 20 x 1.2 mm), 50 mAs (collimation 20 x 1.2 and 64 x 0.6 mm) and 80 mAs (20 x 1.2 mm) representing screening low-dose, routine, narrow collimation and oncologic staging setups were measured with an Alderson-Rando phantom (Alderson Research Laboratories Inc.). Scans were performed on a 64-row MDCT (SOMATOM Sensation 64, Siemens) simulating the prone and supine positions with a constant voltage of 120 kV. Dose values (male/female) were 2.5/2.9, 3.8/4.2, 4.2/4.5 and 5.7/6.4 mSv for 30, 50 (20 x 1.2 and 64 x 0.6 mm) and 80 mAs, respectively. Measurements showed an elevated dose for females (11.5% mean; compared to males). Use of narrow collimation combined with 50 mAs resulted in a small increase of dose exposure of 10.5 (male) and 7.1% (female). Gonad doses ranged from 0.9 to 2.6 mSv (male) and from 1.5 to 3.5 mSv (female). In all protocols, the stomach wall, lower colon, urinary bladder and liver were slightly more highly exposed (all <2.3 mSv) than the other organs, and the breast dose was <0.3 mSv in every setup. Values of radiation exposure in 64- and 16-slice CTC differ only marginally when using the narrow collimation. In 64-slice CTC, the use of narrow (64 x 0.6 mm) collimation shows slightly elevated dose values compared to wider (20 x 1.2 mm) collimation.

Multislice CT in cardiac and coronary angiography.

In the last 2 years, mechanical multidetector-row CT (MDCT) systems with simultaneous acquisition of four slices and a half second scanner rotation time have become widely available. Data acquisition with these scanners allows for considerably faster coverage of the heart volume compared with single slice scanning. This increased scan speed can be used for retrospective gating together with 1 mm collimated slice widths and allows coverage of the entire cardiac volume in one breath-hold. First results from studies in correlation with intracoronary ultrasound suggest that MDCT technology not only offers the possibility to visualize intracoronary stenoses non-invasively, but also to differentiate plaque morphology. This is especially the case with the next generation of 16-row MDCT systems. An increased number of simultaneously acquired slices and submillimetre collimation for cardiac applications allows true isotropic scanning with high temporal resolution. Contrast-enhanced MDCT is a promising non-invasive technique for the detection, visualization and characterization of stenotic artery disease. It could act as a gatekeeper prior to cardiac catherization and finally replace conventional diagnostic modalities.

[Left ventricular functional parameters using ECG-gated multidetector spiral CT in comparison with invasive ventriculography]. / Bestimmung linksventrikulärer Funktionsparameter mittels EKG-gesteuerter Mehrschicht-Computertomographie im Vergleich mit der invasiven Ventrikulographie.

PURPOSE: To evaluate the accuracy of left ventricular function using a multidetector CT (MDCT) with retrospective ECG-gating and to compare the results with conventional ventriculography. MATERIALS AND METHODS: In 26 patients, retrospectively ECG-gated MDCT of the heart (Volume Zoom, Siemens, Germany) as well as conventional coronary angiography including ventriculography was performed to exclude or follow coronary artery disease. CT examination (120 KV, 400 mAs) was carried out with 4 x 1 mm collimation (500 ms gantry rotation time). For CT angiography, 150 ml of contrast media was injected intravenously at a flow rate of 4 ml/s. All data sets of the functional cardiac parameters were reconstructed in end-systolic and end-diastolic phase. End-systolic volume (ESV), end-diastolic volume (EDV) and ejection fraction (EF) were determined from multiplanar reformations orthogonally through the cardiac short axis and analyzed using special evaluation software (ARGUS, Siemens). The results were compared with ESV, EDV and EF obtained from invasive ventriculography. RESULTS: In all cases, a sufficient quality of the MDCT images was achieved. EDV (150.1 +/- 16.2 ml MDCT vs. 138.7 +/- 16.9 ml ventriculography; mean difference 11.4 +/- 12.7 ml; r = 0.51) had an acceptable correlation to conventional ventriculography, and ESV (58.1 +/- 14.6 ml vs. 50.2 +/- 13.4 ml; mean difference 7.9 +/- 8.8 ml; r = 0.81) and EF (60.9 +/- 13.6 % vs. 64.9 +/- 12.7 %; mean difference 4.0 +/- 6.2 %; r = 0.79) showed a good correlation. In comparison with invasive ventriculography, MDCT tended to overestimate significantly EDV (p = 0.008) and ESV (p = 0.003) and to underestimate EF (p = 0.001). CONCLUSION: MDCT of the heart with retrospective ECG-gating enables efficient estimation of left ventricular function, providing important additional information of non-invasive cardiac imaging using MDCT. However, EDV and EVS were significantly overestimated and EF was underestimated in MDCT compared to ventriculography.

Estimation of radiation exposure in 16-detector row computed tomography of the heart with retrospective ECG-gating.

PURPOSE: We sought to evaluate the radiation exposure of cardiac CT scans with 16-row multidetector computed tomography (MDCT). Additionally the possibility of dose reduction by using a ECG-controlled tube current modulation technique was evaluated. METHODS AND MATERIAL: An Alderson Rando phantom equipped with thermoluminescent dosimeters was used for dose measurements. Effective dose was calculated according to ICRP 60. Exposure was performed on a 16-row MDCT scanner with standard protocols for CT coronary calcium scoring (120 kV, 133 mAs, 12 x 1.5 mm) and CT coronary angiography (120 kV, 400 mAs, 12 x 0.75 mm). Exposure was repeated at a simulated heart rate of 60 bpm with ECG-pulsed tube current modulation. RESULTS: Effective dose was 2.9 mSv (male) and 3.6 mSv (female) for the calcium scoring protocol. CT coronary angiography resulted in an effective dose of 8.1 mSv (male) and 10.9 mSv (female). Using ECG-pulsed tube current modulation radiation exposure can significant reduced: by 46 % (1.6 mSv) in calcium scoring and by 47 % (4.3 mSv) in CT coronary angiography. CONCLUSION: MDCT of the heart shows a significant radiation exposure, which can significantly be reduced by ECG-pulsed tube current modulation. Radiation exposure of cardiac MDCT is comparable to CT-examinations of chest or abdomen, but seem to be slightly higher compared to conventional coronary angiography.

[Visualization of pulmonary vein stenosis after radio frequency ablation for treatment of atrial fibrillation using multidetector computed tomography with retrospective gating]. / Darstellung von Pulmonalvenenstenosen nach Radiofrequenzablation zur Behandlung von Vorhofflimmern unter Verwendung der Multidetektor Computertomographie mit retrospektivem Gating.

PURPOSE: With the number of radio frequency ablations (RFA) for treatment of chronic atrial fibrillation increasing, the diagnostic evaluation for RFA associated pulmonary vein stenosis is getting more important. This study investigates the feasibility of the visualization of pulmonary vein stenosis using non-invasive multidetector computed tomography. MATERIALS AND METHODS: Twenty-eight patients were examined following RFA-treatment. A 4-slice (20 patients) and a 16-slice (8 patients) multidetector CT scanner (SOMATOM Volume Zoom and Sensation 16, Siemens, Forchheim, Germany) with retrospective gating was used to assess the pulmonary veins. Lesion severity was determined on a semi-quantitative scale (< 30 %, 30 - 50 %, > 50 %). RESULTS: CT was performed without any complications in all patients. Diagnostic image quality could be obtained in all examinations. The pulmonary veins showed lesions < 30 % in four patients, lesions of 30 -, 50 % in five patients and a stenosis > 50 % in one patient. Eighteen patients showed no lesions. CONCLUSION: Multidetector CT of the pulmonary veins seems to be able to visualize high-grade and low-grade lesions, but larger catheter-controlled studies are needed for further assessment of the diagnostic accuracy and clinical reliability of this noninvasive method.

[A testing device for quality assurance of 3D-ultrasound equipment]. / Ein Testobjekt zur Qualitätssicherung von 3D-Ultraschallgeräten.

A test object for 3D-ultrasound (US) imaging equipment was constructed, that could be used for various purposes: For training of the correct technical setup procedures and practical handling of a 3D-US equipment, as well as for various quality assurance procedures. The size and volume of these structures were known precisely (+/- 0.1 mm resp. +/- 0.06 mL, respectively; smallest volume: 0.1 mL). The stability of the structures was in agreement with guideline IEC 854 and allowed to quantify exactly the imaging and measurement errors of size and volume measurements performed with commercial 3D-equipment. The test object is well suited to validate measured volume data, as well as to perform procedures of technical quality assurance in a reproducible manner.

In vitro measurement accuracy of three-dimensional ultrasound.

OBJECTIVES: We sought to validate distance and volume measurements in three-dimensional (3-D) ultrasound images. BACKGROUND: Even with the latest equipment, it is not known how accurate 3-D echocardiographic measurements are. METHODS: Six models were imaged in ethanol solution and two within a tissue phantom using a mechanical rotation device rotating in 1 degrees intervals and a real-time 3-D scanner. Distance and volume measurements (n = 60) were performed in two-dimensional (2-D) and 3-D images using TomTec and InViVo software. RESULTS: Distance measurements had a mean total error between 1.12% and 2.31% for Acuson (2.5 MHZ, 3 MHZ, and 4 MHZ) and Hewlett Parkard (HP) fusion frequencies h and m, HP fusion harmonic B in the axial, and between 3.5% and 4.9% in the lateral dimension. HP Harmonic A and B, Volumetrics (2.5 MHZ), and HP fusion Harmonic A exhibited significantly higher differences to reality with a mean difference between 5.1% and 8.9% in the axial and between 6.2% and 7.9% in the lateral direction. Axial 2-D measurements were not different from real dimensions except Volumetrics model 1. In the lateral axis, all imaging modalities were different from reality except the fusion harmonic modus B. Using the HP fusion frequency h and HP fusion Harmonic B-mode, volume measurements in 3-D images significantly underestimated reality, while Acuson's fundamental frequency 3.5 MHZ was not different from real volumes. CONCLUSION: Three-dimensional visualization using different ultrasound settings results in different accuracy.