Physicochemical and Sensory Characterization of Whey Protein-Enriched Semihard Cheese.

In view of potential future changes of German food legislation with regard to cheese product quality parameters, this study aimed to evaluate the quality of whey protein-enriched semihard cheese (WPEC). Model WPEC was produced in a pilot plant and on an industrial scale by adding defined amounts of high-heat (HH) milk to the cheese milk and comprehensively analyzed during cheese processing. The dry matter, total protein, pure protein, fat, and sodium chloride content of six-week ripened cheese samples were not significantly different (p < 0.05) when the technologically necessary heating of the curd was adapted to the amount of HH milk. However, the ripening, firmness, and melting behavior of WPEC was different compared to cheese without HH milk. During ripening, no formation of whey protein peptides was observed, but differences in the amount of some bitter peptides deriving from the casein fraction were found. Sensory data suggested a slightly more bitter taste perception by the panelists for the WPEC. Further technological adjustments are recommended to obtain marketable WPEC.

Identification of Marker Peptides for the Whey Protein Quantification in Edam-Type Cheese.

Several technologies are available for incorporating whey proteins into a cheese matrix. However, there is no valid analytical method available to determine the whey protein content in matured cheese, to date. Consequently, the aim of the present study was to develop a liquid chromatography-tandem mass spectrometry (LC-MS/MS) method for the quantification of individual whey proteins based on specific marker peptides ('bottom-up' proteomic approach). Therefore, the whey protein-enriched model of the Edam-type cheese was produced in a pilot plant and on an industrial scale. Tryptic hydrolysis experiments were performed to evaluate the suitability of identified potential marker peptides (PMPs) for α-lactalbumin (α-LA) and ß-lactoglobulin (ß-LG). Based on the findings, α-LA and ß-LG appeared to be resistant to proteolytic degradation during six weeks of ripening and no influence on the PMP was observed. Good levels of linearity (R2 > 0.9714), repeatability (CVs < 5%), and recovery rate (80% to 120%) were determined for most PMPs. However, absolute quantification with external peptide and protein standards revealed differences in model cheese depending on the PMP, e.g., 0.50% ± 0.02% to 5.31% ± 0.25% for ß-LG. As protein spiking prior to hydrolysis revealed differing digestion behavior of whey proteins, further studies are required to enable valid quantification in various cheese types.

High-Performance Thin-Layer Chromatography-Immunostaining as a Technique for the Characterization of Whey Protein Enrichment in Edam Cheese.

Whey protein-enriched cheese can be produced by means of a high-temperature treatment of a part of the cheese milk. In this way, the nutritional quality of the resulting cheeses can be increased while resources are conserved. High-performance thin-layer chromatography-immunostaining (HPTLC-IS) using specific ß-lactoglobulin (ß-LG) antibodies was applied to study the implementation and stability of ß-LG in two different sample sets of whey protein-enriched Edam model cheeses, including industrial-scale ones. Two methods were compared for the extraction of the proteins/peptides from the cheese samples. By applying tryptic hydrolysis directly from a suspended cheese sample instead of a supernatant of a centrifuged suspension, a better yield was obtained for the extraction of ß-LG. When applying this method, it was found that selected epitopes in the tryptic ß-LG peptides remain stable over the ripening period of the cheese. For four of the tryptic ß-LG peptides detected by immunostaining, the amino acid sequence was identified using MALDI-TOF-MS/MS. One of the peptides identified was the semi-tryptic peptide VYVEELKPTP. A linear relationship was found between the content of this peptide in cheese and the proportion of high-heated milk in the cheese milk. ß-LG enrichment factors of 1.72 (n = 3, sample set I) and 1.33 ± 0.19 (n = 1, sample set II) were determined for the cheese samples containing 30% high-heated milk compared to the non-enriched samples. The relative ß-LG contents in the cheese samples with 30% high-heated milk were calculated to be 4.35% ± 0.39% (sample set I) and 9.11% ± 0.29% (sample set II) using a one-point calibration. It can be concluded that the HPTLC-IS method used is a suitable tool for the analysis of whey protein accumulation in cheese, being therefore potentially directly applicable on an industrial scale. For more accurate quantification of the whey protein content in cheese, an enhanced calibration curve needs to be applied.

Benzyl isothiocyanate-modified α-lactalbumin - Two-dimensional high-performance thin-layer chromatography for analyzing modified peptides.

In complex food matrices, non-directed reactions between food proteins and secondary plant metabolites (SPM) are conceivable. In this study, the interaction between the bioactive metabolite from garden cress (Lepidium sativum) and selected Brassicaceae - benzyl isothiocyanate (BITC) - and the dairy protein α-lactalbumin (α-LA) was investigated. It was focused on monitoring the proteolytic degradation behaviour of unmodified and BITC-modified α-LA with two-dimensional high-performance thin-layer chromatography (2D-HPTLC). The two-dimensional approach of HPTLC offers high resolution in the separation of complex peptide mixtures and might enable differentiation of protein modifications. Based on the specific peptide patterns of native and modified peptides, conclusions can be drawn about differences in protein/peptide polarity, location of a modification, and digestibility. The aim was to characterize tryptically hydrolyzed unmodified and BITC-modified peptides using the 2D method and to investigate the influence of BITC modification of α-LA on polarity and digestibility. To determine the repeatability of peptide separation by 2D-HPTLC, the unmodified and BITC-modified protein hydrolyzates were separated six times. The absolute standard deviations between the retardation factors of the individual peptide spots varied between 0.52 and 4.79 mm for the x-coordinates and between 0.41 and 6.47 mm for the y-coordinates for all three samples. Here, the mean relative standard deviations ranged from 5.80 to 10.4% for the x-coordinates and from 5.91 to 18.3% for the y-coordinates. The results of the tryptic hydrolysis indicated that, depending on the concentration of BITC used, the modification sterically hinders the cleavage sites for the enzyme, resulting in a reduced digestibility. Covalent binding of the hydrophobic BITC altered the digestibility and polarity of the protein, leading to a difference in peptide patterns between the unmodified and modified α-LA. It was concluded that the reaction was undirected, resulting in a mixture of unmodified and modified peptides, and that elongated modified peptides were formed by BITC blocking of trypsin cleavage sites.

Two-dimensional high-performance thin-layer chromatography for the characterization of milk peptide properties and a prediction of the retention behavior - a proof-of-principle study.

High-performance thin-layer chromatography (HPTLC) is a suitable method for the analysis of peptides and proteins due to a wide selection of stationary and mobile phases and various detection options. Especially, two-dimensional HPTLC (2D-HPTLC) enables a higher resolution compared to one-dimensional HPTLC in the separation of complex peptide mixtures. Similar to 2D electrophoresis, characteristic peptide patterns can be obtained, allowing a differentiation of ingredients based on varying protein origins. The aim of this study was to evaluate 2D-HPTLC with regard to its suitability for the characterization of proteins/peptides and to verify whether it is possible to predict the retention behavior of peptides based on their properties. As models, the five most abundant milk proteins α-lactalbumin, ß-lactoglobulin, α-, ß-, and κ-Casein were used. In order to determine the repeatability of the peptide separation by 2D-HPTLC, each tryptic protein hydrolyzate was separated eight times. The standard deviations of the retardation factors for the separated peptides varied between 1.0 and 11.1 mm for the x-coordinate and 0.5-7.3 mm for the y-coordinate. It was also shown that after the chromatographic separation, peptides of the individual protein hydrolyzates were located in specific areas on the HPTLC plate, so that a clustering could be obtained for the whey proteins' as well as the caseins' hydrolyzates. For establishing correlations between the properties of the peptides and their retardation factors, 51 of 85 selected peptides were identified by matrix-assisted laser desorption/ionization time-of-flight tandem mass spectrometry (MALDI-TOF-MS/MS). On this basis, statistically significant correlations (α = 0.05) between the retardation factors of the peptides and their isoelectric points, as well as the percentage of anionic and non-polar amino acids in the peptides were established. Finally, it was investigated, whether the retardation factors for peptides can be predicted on the basis of a linear regression of the percentage of non-polar amino acids in a peptide. For this purpose, a mixture of artifical (synthetic) peptides (n = 14) was separated by 2D-HPTLC and the measured retardation factors were compared with the corresponding retardation factors calculated. Absolute deviations of 0.3-17.9 mm were obtained. In addition, the universal applicability of the method to other protein sources other than milk proteins (animal protein) was tested using a mixture of pea peptides (plant protein, n = 3) resulting in absolute deviations of 0.7-8.6 mm.

Development of a targeted HPLC-ESI-QqQ-MS/MS method for the quantification of sulfolipids from a cyanobacterium, selected leafy vegetables, and a microalgae species.

The use of macro- and microalgae, as well as cyanobacteria, becomes increasingly important for human nutrition, even in Western diets. Health effects, positive as well as negative, are believed to result mainly from minor components in the food. In macro- and microalgae as well as in certain cyanobacteria, one class of such minor compounds is sulfolipids, more precisely sulfoquinovosylmonoacylglycerol (SQMG) and sulfoquinovosyldiacylglycerol (SQDG) derivatives. SQMGs and SQDGs consist of a diacylglycerol esterified with varying fatty acid combinations and a sulfoquinovose moiety. Sulfoquinovose is a sulfonated hexose analogous to D-glucose, but featuring a stable carbon-sulfur bond. With regard to their chemical structure, SQDGs can be distinguished according to their sn1- and sn2-bound fatty acids. Although there is great interest in SQDGs, because of their controversially discussed bioactivities, only a negligible number of comprehensive methods for identification and quantification has been published, so far. Within this work, a sample preparation including a quantitative isolation of SQDGs from selected raw materials, a clean-up with solid-phase extraction (SPE), and a sensitive liquid chromatography-tandem mass spectrometry (LC-MS/MS) method for simultaneous identification and quantitation of different, intact SQMGs and SQDGs were developed and validated. The applicability of the method was further demonstrated by comparing a prominent cyanobacterium (Arthrospira sp.) with a microalgae preparation (Chlorella vulgaris), and selected leafy vegetables (spinach, basil).

Comparison and optimization of three commercial methods with an LC-MS/MS method for the determination of sulfites in food and beverages.

Sulfites are food additives found in a large variety of food products to help reduce oxidation and browning. A small subset of the population has "allergic-like" symptoms upon consumption of sulfite containing foods. There are several sulfite detection methods available in the literature that vary in analysis time and required instrumentation. There are also rapid screening tests available that have not been tested extensively for accuracy and precision. In this study, four different methods (an LC-MS/MS method, a spectrophotometric method, a test strip method and a spot test method) were used to determine the sulfite concentration of 10 different commercially sulfited products. Of these methods, the LC-MS/MS and the spectrophotometric method had the most comparable results. The test strips were only accurate at concentrations greater than 50 mg/kg (ppm) SO2. The spot test method was found to be inaccurate with both standard solutions and samples.