Determination of selected trace elements in airborne aerosol particles using different sample preparation.

Determination of trace element concentrations in atmospheric aerosols is important because of their toxic effects on human health. Additionally, they are now widely used in source apportionment studies. There is a number of methods for sample preparation of ambient particulate matter. One of the most widely used is microwave-assisted digestion of filter-based samples. Since the water-soluble fraction is bioavaliable, the aim of our study was to determine the concentration of selected trace elements (V, Cr, Mn, Ni, Cu, Zn, As, Cd, Sb, Tl, and Pb) in this fraction and compare it to the amounts obtained by two different microwave digestion procedures - one using a mixture of H2O2 and HNO3 and the other using a mixture of HF, HCl, and HNO3. The recoveries of the digestion procedures used were tested on certified reference material (NIST SRM 1648 Urban Particulate Matter). The procedures were applied to filters containing PM10 particles collected at an urban background location in Ljubljana, Slovenia. Among the elements analysed, V, Zn, As, and Cd displayed the highest concentration within the water-soluble fraction, with Cr, Ni, Tl and Pb displaying the lowest concentrations. The comparison between the two applied digestion procedures showed that Cr, Ni, Sb and Tl were strongly bound to the sample matrix.

Measurements of size-segregated emission particles by a sampling system based on the cascade impactor.

A special sampling system for measurements of size-segregated particles directly at the source of emission was designed and constructed. The central part of this system is a low-pressure cascade impactor with 10 collection stages for the size ranges between 15 nm and 16 microm. Its capability and suitability was proven by sampling particles atthe stack (100 degrees C) of a coal-fired power station in Slovenia. These measurements showed very reasonable results in comparison with a commercial cascade impactor for PM10 and PM2.5 and with a plane device for total suspended particulate matter (TSP). The best agreement with the measurements made by a commercial impactor was found for concentrations of TSP above 10 mg m(-3), i.e., the average PM2.5/PM10 ratios obtained by a commercial impactor and by our impactor were 0.78 and 0.80, respectively. Analysis of selected elements in size-segregated emission particles additionally confirmed the suitability of our system. The measurements showed that the mass size distributions were generally bimodal, with the most pronounced mass peak in the 1-2 microm size range. The first results of elemental mass size distributions showed some distinctive differences in comparison to the most common ambient anthropogenic sources (i.e., traffic emissions). For example, trace elements, like Pb, Cd, As, and V, typically related to traffic emissions, are usually more abundant in particles less than 1 microm in size, whereas in our specific case they were found at about 2 microm. Thus, these mass size distributions can be used as a signature of this source. Simultaneous measurements of size-segregated particles at the source and in the surrounding environment can therefore significantly increase the sensitivity of the contribution of a specific source to the actual ambient concentrations.

The role of glucosamine-6-phosphate deaminase at the early stages of Aspergillus niger growth in a high-citric-acid-yielding medium.

Glucosamine-6-phosphate (GlcN6P) deaminase seems to be the main enzyme in Aspergillus niger cells responsible for rapid glucosamine accumulation during the early stages of growth in a high-citric-acid-yielding medium. By determining basic kinetic parameters on the isolated enzyme, a high affinity toward fructose-6-phosphate (Fru6P) was measured, while in the reverse direction the K(m) value for glucosamine-6-phosphate was lower than deaminases from other organisms measured so far. The enzyme characteristics of GlcN6P deaminase suggest it must compete with 6-phosphofructo-1-kinase (PFK1) for the common substrate-Fru6P in A. niger cells. Glucosamine accumulation seems therefore to remove an intermediate from the glycolytic flux, a situation which is reflected in slower citric acid accumulation and a specific growth rate after the germination of spores. When ammonium ions are depleted from the medium, one of the substrates for GlcN6P deaminase becomes limiting and Fru6P can be catabolised by PFK1 which enhances glycolytic flux. Other enzymatic features of GlcN6P deaminase such as pH optima for both aminating and deaminating reactions might play a significant role in rapid glucosamine accumulation during the early phase of fermentation and a slow consumption of aminosugar during the citric-acid-producing phase.

Chemical composition and hygroscopic properties of size-segregated aerosol particles collected at the Adriatic coast of Slovenia.

The chemical composition as well as the water uptake characteristics of aerosols was determined in size-segregated samples collected during November 2002 on the Slovenian coast. Major ions, water-soluble organic compounds (WSOC), short-chain carboxylic acids and trace elements were determined in the water-soluble fraction of the aerosol. Total aerosol black carbon (BC) was measured from filter samples. Our results showed that the origin of air masses is an important factor that controls the variation in the size distribution of the main components. Very high concentrations of WSOC as well as higher concentrations of BC were found under mostly continental influence. Besides the main ionic species (SO4(2-), NH4(+), K+) in the finest size fraction (0.17-0.53 microm), the concentration of NO3(-) was also high. The difference between the two different air mass origins is particularly expressed for Cl-, Na+, Mg2+ and Ca2+ determined in particles larger than 1.6 microm. As expected, a very good correlation was found between Na+ and Cl-. A good correlation was found between sea salt elements and elements of crustal origin (Na+, Cl-, Mg2+, Ca2+, Sr). A good relationship between typical anthropogenic tracers (K, V and Pb) was also observed. The mass growth factors, for all size fractions of aerosols collected under continental influence were very low (maximum 2.23 at 94%, 1.6-5.1 microm), while under marine influence the mass growth factors increased significantly with the particle size. At 97% humidity, the mass growth factors were 6.95 for the size fraction 0.53-1.6 microm and 9.78 for larger particles (1.6-5.1 microm).

Efficiency and characteristics of solid-phase (ion-exchange) extraction for removal of Cl- matrix.

Certain types of samples contain chloride in concentrations that are too high to accurately determine other anions by ion chromatography without any pretreatment. One of the most widely used approaches for such samples is matrix elimination using disposable cartridges containing a cation-exchange resin in the Ag+ form. The efficiency and characteristics of the commercially available cartridge for Cl- removal were tested by the on-line connection of the cartridge effluent to an inductively coupled plasma mass spectrometer. Displacement efficiency of Ag+ ions and loading capacity of the cartridges were studied at different flow-rates. Significant amounts of silver were detected in the effluent, which were attributed to colloidal AgCl as well as dissolved Ag+ ions. Because silver ions can cause irreversible damage to the analytical column, an Ag cartridge followed by an on line filter (pore size 0.22 microm) and cartridge in the H3O+ form were proposed for improvement of this sample pretreatment technique for chloride removal.

Determination of sulfur oxides formed during the S(IV) oxidation in the presence of iron.

The reaction products (i.e., sulfate (SO4(2-)) and dithionate (S2O6(2-))) of S(IV) oxidation in the presence of iron(III) under different experimental conditions were investigated. Ion-interaction chromatography was used for the separation of sulfate and dithionate using tetrabutylammonium hydroxide (TBAOH) as an ion-pair reagent. The chromatographic method was optimized by varying the composition of the mobile phase (i.e., concentration of TBAOH, acetonitrile and Na2CO3) and by varying the flow rate of the mobile phase. The method was successfully applied to the determination of dithionate formed during the S(IV) oxidation in the presence of Fe(III). In air-saturated solutions sulfate was observed as the only product, while in N2-saturated solutions dithionate was also determined, but it is the minor reaction product and represents about 4% of the total amount of oxidized HSO3- under the studied conditions.