Elastic Recovery Properties of Ultralight Carbon Nanotube/Carboxymethyl Cellulose Composites.

Ultralight materials exhibit superelastic behavior depending on the selection, blending, and carbonization of the materials. Recently, ultimate low-density materials of 5 mg/cm3 or less have attracted attention for applications such as sensors, electrodes, and absorbing materials. In this study, we fabricated an ultralight material composed of single-walled carbon nanotubes (CNT) and sodium carboxymethyl cellulose (CMC), and we investigated the effect of density, composition, and weight average molecular weight of CMC on elastic recovery properties of ultralight CNT/CMC composites. Our results showed that the elastic recovery properties can be improved by reducing the density of the composite, lowering the mass ratio of CNTs, and using CMC with small molecular weight.

Light-induced levitation of ultralight carbon aerogels via temperature control.

We demonstrate that ultralight carbon aerogels with skeletal densities lesser than the air density can levitate in air, based on Archimedes' principle, when heated with light. Porous materials, such as aerogels, facilitate the fabrication of materials with density less than that of air. However, their apparent density increases because of the air inside the materials, and therefore, they cannot levitate in air under normal conditions. Ultralight carbon aerogels, fabricated using carbon nanotubes, have excellent light absorption properties and can be quickly heated by a lamp owing to their small heat capacity. In this study, an ultralight carbon aerogel was heated with a halogen lamp and levitated in air by expanding the air inside as well as selectively reducing its density. We also show that the levitation of the ultralight carbon aerogel can be easily controlled by turning the lamp on and off. These findings are expected to be useful for various applications of aerogels, such as in communication and transportation through the sky.

Pattern Formation in Heterostructured Gel by the Ferrocyanide-Iodate-Sulfite Reaction.

Pattern formation in the reaction-diffusion systems for the ferrocyanide-iodate-sulfite reaction has been investigated. Previous studies have been conducted in a uniform medium. However, in this study, we reported the pattern formation in heterostructured gels with different network densities. The chemical states of the gel depend on the diffusivity, which in turn depends on the network density of the gel. Consequently, a pH pattern reflecting the heterostructured gel emerged. Furthermore, adjusting the condition produces novel patterns in the heterostructured gel.

Solution Plasma Process-Derived Defect-Induced Heterophase Anatase/Brookite TiO2 Nanocrystals for Enhanced Gaseous Photocatalytic Performance.

We report a simple room-temperature synthesis route for increasing the reactivity of a TiO2 photocatalyst using a solution plasma process (SPP). Hydrogen radicals generated from the SPP chamber interact with the TiO2 photocatalyst feedstock, transforming its crystalline phase and introducing oxygen vacancy defects. In this work, we examined a pure anatase TiO2 as a model feedstock because of its photocatalytic attributes and well-characterized properties. After the SPP treatment, the pure anatase crystalline phase was transformed to an anatase/brookite heterocrystalline phase with oxygen vacancies. Furthermore, the SPP treatment promoted the absorption of both UV and visible light by TiO2. As a result, TiO2 treated by the SPP for 3 h showed a high gaseous photocatalytic performance (91.1%) for acetaldehyde degradation to CO2 compared with the activity of untreated TiO2 (51%). The SPP-treated TiO2 was also more active than nitrogen-doped TiO2 driven by visible light (66%). The overall photocatalytic performance was related to the SPP treatment time. The SPP technique could be used to enhance the activity of readily available feedstocks with a short processing time. These results demonstrate the potential of this method for modifying narrow-band gap metal oxides, metal sulfides, and polymer composite-based catalyst materials. The modifications of these materials are not limited to photocatalysts and could be used in a wide range of energy and environment-based applications.

Solution plasma synthesis of a boron-carbon-nitrogen catalyst with a controllable bond structure.

Synthesis of boron-carbon-nitrogen (BCN) nanocarbon with a controllable bond structure for enhanced oxygen reduction reaction (ORR) activity and durability was performed using a new method of discharge in organic solution mixtures named the 'Solution Plasma Process'. Using selected precursors a new strategy for the simultaneous synthesis of nanocarbon co-doped with heteroatoms was found. The synergistic effect of N and B in an uncoupling bond state improved the formation of new active sites for the ORR performance by changing the electronic structure of the base carbon. Meanwhile, when B and N are bonded together, the BCN catalyst contributes to a reduced ORR activity by forming a balanced electronic structure in carbon. The BCN nanocarbon with an uncoupling bond state exhibits an enhanced ORR activity under alkaline conditions, with an onset potential of -0.25 V versus -0.31 V for B/N coupling and 3.43 transferred electrons during the ORR. Although the ORR activity of the B/N uncoupling nanocarbon was not as good as the typical Pt/C, the durability of this synthesized material (15.1% current decrease after 20 000 s of operation) was significantly better than that of the Pt/C catalyst (61.5% current drop under the same conditions). After the durability test, the increase of the chemical states containing oxygen was higher for Pt/C than B/N uncoupling.

Fastest Formation Routes of Nanocarbons in Solution Plasma Processes.

Although solution-plasma processing enables room-temperature synthesis of nanocarbons, the underlying mechanisms are not well understood. We investigated the routes of solution-plasma-induced nanocarbon formation from hexane, hexadecane, cyclohexane, and benzene. The synthesis rate from benzene was the highest. However, the nanocarbons from linear molecules were more crystalline than those from ring molecules. Linear molecules decomposed into shorter olefins, whereas ring molecules were reconstructed in the plasma. In the saturated ring molecules, C-H dissociation proceeded, followed by conversion into unsaturated ring molecules. However, unsaturated ring molecules were directly polymerized through cation radicals, such as benzene radical cation, and were converted into two- and three-ring molecules at the plasma-solution interface. The nanocarbons from linear molecules were synthesized in plasma from small molecules such as C2 under heat; the obtained products were the same as those obtained via pyrolysis synthesis. Conversely, the nanocarbons obtained from ring molecules were directly synthesized through an intermediate, such as benzene radical cation, at the interface between plasma and solution, resulting in the same products as those obtained via polymerization. These two different reaction fields provide a reasonable explanation for the fastest synthesis rate observed in the case of benzene.

Heterocarbon nanosheets incorporating iron phthalocyanine for oxygen reduction reaction in both alkaline and acidic media.

Heterocarbon nanosheets incorporating iron phthalocyanine (FP-NCNs-SP) have been successfully synthesized by a facile one-pot solution plasma process at high repetition frequency. It was found that the Fe-N4 catalytic active sites could be preserved on the FP-NCNs-SP without degradation. The FP-NCNs-SP also possessed large surface area, good conductivity and high degree of graphitization. Electrochemical evaluations demonstrated that NCNs-SP had excellent electrocatalytic activity and selectivity toward oxygen reduction reaction (ORR) in alkaline medium through a direct four-electron pathway. Although the significant improvement in ORR activity was clearly observed in acidic medium, it was much poorer than in alkaline medium. We believe that the results presented in this work will shed light on the advanced synthesis and design of ORR electrocatalysts at room temperature with an abundance of catalytically active sites and high ORR performance.

Accelerated nanoparticles synthesis in alcohol-water-mixture-based solution plasma.

An extraordinary high-speed synthesis of gold nanoparticles (AuNPs) was discovered by synthesizing the AuNPs in ethanol-water mixtures using a solution plasma process (SPP). The influence of the ethanol mole fraction (χethanol) in the ethanol-water mixtures on the reduction rate of gold chloride ions to AuNPs under the SPP system was studied. The results indicated that the reaction rate of the AuNPs synthesis exhibited a maximum value (i.e. 35.2 times faster than in a pure water system) at the significant point where the partial molar volumes of ethanol and water changed drastically.

Verification of Radicals Formation in Ethanol-Water Mixture Based Solution Plasma and Their Relation to the Rate of Reaction.

Our previous research demonstrated that using ethanol-water mixture as a liquid medium for the synthesis of gold nanoparticles by the solution plasma process (SPP) could lead to an increment of the reaction rate of ∼35.2 times faster than that in pure water. This drastic change was observed when a small amount of ethanol, that is, at an ethanol mole fraction (χethanol) of 0.089, was added in the system. After this composition, the reaction rate decreased continuously. To better understand what happens in the ethanol-water mixture-based SPP, in this study, effect of the ethanol content on the radical formation in the system was verified. We focused on detecting the magnetic resonance of electronic spins using electron spin resonance spectroscopy to determine the type and quantity of the generated radicals at each χethanol. Results indicated that ethanol radicals were generated in the ethanol-water mixtures and exhibited maximum quantity at the xethanol of 0.089. Relationship between the ethanol radical yield and the rate of reaction, along with possible mechanism responsible for the observed phenomenon, is discussed in this paper.

Synthesis of mono-dispersed nanofluids using solution plasma.

Small-sized and well-dispersed gold nanoparticles (NPs) for nanofluidics have been synthesized by electrical discharge in liquid environment using termed solution plasma processing (SPP). Electrons and the hydrogen radicals are reducing the gold ions to the neutral form in plasma gas phase and liquid phase, respectively. The gold NPs have the smallest diameter of 4.9 nm when the solution temperature was kept at 20 °C. Nucleation and growth theory describe the evolution of the NP diameter right after the reduction reaction in function of the system temperature, NP surface energy, dispersion energy barrier, and nucleation rate. Negative charges on the NPs surface during and after SPP generate repulsive forces among the NPs avoiding their agglomeration in solution. Increasing the average energy in the SPP determines a decrease of the zeta potential and an increase of the NPs diameter. An important enhancement of the thermal conductivity of 9.4% was measured for the synthesized nanofluids containing NPs with the smallest size.

Autonomous viscosity oscillation via metallo-supramolecular terpyridine chemistry of branched poly(ethylene glycol) driven by the Belousov-Zhabotinsky reaction.

Herein, we report an autonomous viscosity oscillation of polymer solutions coupled with the metal-ligand association/dissociation between Ru and terpyridine (tpy), driven by the Belousov-Zhabotinsky (BZ) reaction. The tpy ligand for the Ru catalyst was attached to the terminals of poly(ethylene glycol) (PEG) with different numbers of branches (linear-, tetra-, and octa-PEG). It is well known that mono-tpy coordination is stable when Ru is oxidized (Ru(tpy)(3+)), whereas bis-tpy coordination is stable when the Ru centre is reduced (Ru(tpy)2(2+)). In the oxidized state, the three different polymers existed as solutions. In contrast, when the Ru centre was reduced, gels were obtained for the tetra- and octa-PEG owing to the formation of a three-dimensional polymer network through Ru-tpy coordination. Rheological measurements confirmed that the sol-gel transition occurred much more quickly in the octa-PEG system than in the tetra-PEG system, because of the requirement of fewer crosslinking points. The polymer solutions exhibited self-oscillation of absorbance and viscosity when BZ substrates were added to the solutions of Ru(2+)-tpy-modified tetra-/octa-PEG. This indicated that the Ru(tpy)2(2+) attached to the polymer ends could work as a metal catalyst for the BZ reaction. By increasing the number of branches from 4 to 8, the amount of crosslinking changed more remarkably during the oscillation, with a maximum value closer to that necessary for gelation. Thus, viscosity oscillation with a larger amplitude in the region of higher viscosity was achieved by using octa-PEG.

Effect of gel network on pattern formation in the ferrocyanide-iodate-sulfite reaction.

Stationary patterns have been researched experimentally since the discovery of the Turing pattern in the chlorite-iodide-malonic acid (CIMA) reaction and the self-replicating spot pattern in the ferrocyanide-iodate-sulfite (FIS) reaction. In this study, we reproduced the pattern formation in the FIS reaction by using poly(acrylamide) gels. Gels with different swelling ratios were prepared to use as a medium. The effect of the swelling ratio was compared with the effect of thickness. It was found that the swelling ratio greatly influenced pattern formation. Oscillating spot patterns appeared at high swelling ratios, and lamellar patterns appeared at a low swelling ratio. Self-replicating spot patterns appeared in between the two areas. The front velocities, which were observed in the initial stage of pattern formation, depended on the swelling ratio. Furthermore, this dependence obeys the free volume theory of diffusion. These results provide evidence that the change in front velocities is caused by a change in diffusion. Pattern formation can be controlled not only by thickness but also by swelling ratio, which may be useful for creating novel pattern templates.