Dosimetric properties of thermoluminescent NaCl pellets from Khewra Salt Mines, Pakistan.

Thermoluminescence (TL) and extended dosimetric characteristics of naturally occurring sodium chloride (NaCl) salt were studied. Pellets were prepared from mined crystalline salt obtained from Khewra Salt Mines, Pakistan and irradiated from 1 mGy to 10,000 mGy using cobalt-60 gamma source. The TL response showed two dominant peaks around 125°C and 230°C, respectively, at low doses, with an additional peak in between at doses beyond 300 mGy. A linear and supra-linear TL response was observed between 1 mGy-100 mGy and 100 mGy-10 Gy dose ranges, respectively. During the first 24 h post-irradiation, the TL intensity dropped by 20%. A maximum angular dependence of up to 50% was observed between 0° to 360°. For photon energies between 33 keV and 1.25 MeV significant energy dependence was observed for photons < 100 keV only. Sample sensitivity increased with dose a qualitatively similar behaviour to TLD-200. Effective atomic number (Zeff ) of the sample (14.6) was comparable to TLD-200 (16.3). No significant dose rate effects (deviation for a cobalt-60 source within 3.5%) on the TL sensitivity of the sample were found. The lowest detectable dose limit (LDDL) for salt sample was found to be 0.8 mGy whereas the sample reproducibility test showed a maximum of ±11% deviation from the first value.

Thermoluminescence (TL), kinetic parameters and dosimetric features of Pakistani limestone.

Thermoluminescence (TL), kinetic parameters and dosimetric features of Pakistani limestone (CaCO3) is reported in this study. Both compositional and structural analyses reveal that the material has a crystalline nature with rhombohedral structure and non-uniform crystallite size having major content of CaCO3. A powdered limestone sample of 30 mg is found to be the optimized weight for TL and other dosimetric studies. After irradiating the samples with a test dose of 100 Gy using a ß source three composite glow peaks termed as P1, P2 and P3 are visible at 100, 230 and 330 °C respectively using a linear heating rate of 1 °C/s during the TL readout. The Coefficient of Variation (COV) is found to be about 4%. Kinetic parameters (i.e., frequency factor (f), activation energy (E), and the kinetic order (b)) are estimated using both first and second Order of kinetics using an in-house Computerized Glow Curve Deconvolution (GCD) software. The figure-of-merit (FOM) is found to be 2.12%. The distribution of continuum traps with activation energy in the range of 0.77-2.59 eV is observed in the kinetic parameter analysis of the glow peaks of the sample. The TL response in the dose range of 1-5 Gy (not reported previously) and linearity in the dose response in the dose range of 1-10 Gy is observed in samples of Pakistani limestone. The Minimum Detectable Dose (MDD) is 1.01 Gy clearly resembling the experimentally linear fitted results. After a fading study for a period of thirty days, only the first peak i.e., P1 majorly fades while no major change is observed in the amplitude of peaks P2 and P3. In addition, P1 is the main contributor fading by 92% within the first 24 h of irradiation while P2 fades by 30 %. However, P3 shows stability with a very minor fading of 0.05% within 24 h of irradiation. This study concludes that Pakistani limestone can be further assessed as a potential radiation dosimeter for various applications.

Computerized glow curve deconvolution (CGCD): A comparison using asymptotic vs rational approximation in thermoluminescence kinetic models.

In this study an open-source tool GCD Analyzer, based on Microsoft® Excel, for Computerized Glow Curve Deconvolution analysis (CGCD) of thermoluminescence (TL) glow peak has been developed using a more accurate rational approximation. It is capable of deconvolution of glow curves having discrete or continuous trap distribution and can be used for routine as well as emergency radiation dosimetric analysis. This tool has a unique feature of TL glow curve analysis by combining discrete and continuous energy distributions for crystalline, amorphous, and mixed materials. To obtain best values of trap parameters like activation energy (E), frequency factor (s), order of kinetics (b), GCD Analyzer has the capability of analyzing glow curve using selectable individual peak of various physical kinetic models i.e. FOK, SOK, GOK, MOK, and Continuous Traps Distribution (CTD) with subtraction of optional background signal. The residual graph gives a clear visual understanding of the Figure of Merit (F.O.M). A comparison of asymptotic and rational approximation to the built-in second order exponential integral function E2(E/KT) for E/KT < 600 is also presented. The results are verified by deconvolution of test synthetic glow curves with F.O.M up to 0.0005%, experimental glow curve for CTD with F.O.M of 0.9781%, and in the case of GLOWCANIN project glow curves, the F.O.M is comparable to the least values achieved by inter-comparison participants.

Thermoluminescence study of pellets prepared using NaCl from Khewra Salt Mines in Pakistan.

In this study, the thermoluminescence characteristics of naturally occurring salt (NaCl) were assessed for the development of a radiation dosimeter. For this purpose, mined crystalline samples of salt were procured directly from Khewra salt mines in Pakistan. The samples were hand crushed, sieved, and compressed to pellets comparable in size to standard TLD chips, and irradiated to gamma radiation doses in the range of 5 mGy and 5000 mGy. Thermoluminescence (TL) response showed three main peaks in the glow curve around 115-130 °C, 150-170 °C, and 220-240 °C. A linear TL response was observed for the dose range of 5-100 mGy. The TL response became supra-linear for the dose ranges of 100-1000 mGy and 1000-5000 mGy. The Tm-Tstop method was applied to identify the overlapping peaks of the glow curve. Computerized glow curve deconvolution (CGCD) was then employed for the characterization of electron trap parameters such as frequency factor (s), activation energy (E), and the kinetic order (b), using General Order (GO) kinetics. The figure-of-merit (FOM) was found to be 1.08%, 0.94%, 0.77%, and 0.75%, at 500 mGy, 1 Gy, 2 Gy, and 5 Gy, respectively. The TL intensity faded by 20% within the first 24 h after irradiation and finally stabilized after two weeks. In addition, structural, morphological, and elemental analyses, were also performed using various analytical techniques. X-ray diffraction (XRD) showed that the salt crystallizes in a face-centered cubic structure. Scanning electron microscope (SEM) micrographs indicated that the crystallites are closely packed and cubic-shaped with non-uniform size, and mostly found in the agglomerated form. Similarly, the elemental analysis confirmed the presence of impurities such as Mg, Sr, S, K, O, and Ca, in the samples. The present study concludes that the pellets made from salt samples from Khewra mines have a potential for use as radiation dosimeters.

Temperature-Dependent Functional Response of Harmonia axyridis (Coleoptera: Coccinellidae) on the Eggs of Spodoptera litura (Lepidoptera: Noctuidae) in Laboratory.

Spodoptera litura (Fabricius) (Lepidoptera: Noctuidae) is a major pest of several economically important crops with worldwide distribution. Use of insecticides is the principal strategy for its management, which has subsequently led to insecticide resistance and control failures. Functional response of Harmonia axyridis (Pallas) (Coleoptera: Coccinellidae) at larval and adult stages was evaluated in this study, using S. litura eggs as the prey at various temperatures varying between 15 and 35 °C. Based on logistic model findings, linear parameters of various predatory stages of H. axyridis at various temperatures were significantly negative, which indicate a type II functional response. The theoretical maximum number (T/Th) of eggs consumed increased with increasing temperature for all predatory stages. According to the random predator equation, the coefficients of attack rate increased and that of handling time decreased as the temperature increased. The 4th instar and adult stages were superior candidates for biocontrol of the target prey, typically at higher temperatures. The maximum attack rate (0.546 ± 0.058 h) and lowest handling time (0.189 ± 0.004 h-1) were exhibited by the females at 30 and 35 °C, respectively, whereas these parameters were inferior for early instars. These findings clearly depict that the 4th instar and adult predators are efficient egg consumers and can serve as potential suppressors of S. litura field populations. The limitations of the predictions formulated by functional response trials are also discussed.

Lethal and Sublethal Effects of Chlorpyrifos on Biological Traits and Feeding of the Aphidophagous Predator Harmonia axyridis.

Except of pest control, insecticides have shown adverse effects on natural enemies as well. Thus, risk assessment of pesticides for biological control agents is critical for effective use in integrated pest management (IPM) schemes. In the present study, the lethal and sublethal effects of chlorpyrifos, a commonly used insecticide that may negatively affect biological control agents, were evaluated on a non-target predator, the Asian ladybeetle Harmonia axyridis. Previous studies have reported on lethal concentrations, but the effects of sublethal concentrations remain unclear. Lethal and sublethal concentrations of chlorpyrifos were applied to third instar larvae of H. axyridis, and different growth and developmental parameters were measured. Treatment with LC10 (4.62 mg a.i. L-1) significantly shortened the developmental period of third instar larvae, whereas it significantly prolonged those of fourth instar larvae and pupa. Treatment with LC30 (9.59 mg a.i. L-1) significantly increased the larval and pupal developmental period compared with that of the control, whereas feeding potential, female fecundity, and adult longevity significantly decreased after LC10 and LC30 treatment. The pre-oviposition period significantly increased compared with that of the control. Population growth parameters, the finite (λ) and intrinsic rate of increase (r) and the net reproductive rate (R0), decreased following exposure to sublethal concentrations of chlorpyrifos. According to the results, the use of chlorpyrifos in IPM schemes requires further research because even sublethal concentrations of this insecticide were harmful to H. axyridis population growth.

6Li atom percentage determination by atomic absorption-emission spectrometry using a natural lithium hollow cathode lamp.

A simple method has been developed for the determination of 6Li atom % using combined atomic emission-absorption spectrometry employing a commonly available natural lithium hollow cathode lamp. Unlike in previous practice, there is no need for specially fabricated and high cost 6Li and 7Li monoisotopic lamps in this method. The method requires adjustment of total lithium contents of the sample, i.e., 6Li + 7Li, to 2 microg x mL(-1) based upon atomic emission spectroscopy (AES) (C(aes)) against a 2 microg x mL(-1) natural lithium standard. The concentration of the sample was then analyzed by atomic absorption spectroscopy (AAS) measurements (C(aas)). The difference between the concentration measured by AES and AAS, i.e., C(aes)-C(aas), was calculated. The magnitude of the difference was found to be a function of 6Li fraction in the sample. A calibration curve was constructed by plotting 6Li atom % versus [(C(aes)-C(aas))/C(aes)] x 100. 6Li atom % of an unknown sample can be evaluated by putting its [(C(aes)-C(aas))/C(aes)] x 100 value in the calibration curve. The method is fast, convenient, and precise.

Mass spectrometric determination of 234U/238U ratio with improved precision.

A new mass spectrometric method is proposed for measurement of 234U/238U ratio with a single Daly electron multiplier detector using the general peak jump method. The method is based on precise measurement of the 235U/238U ratio and 234U/235U ratio, which are used to calculate the 234U/238U ratio using the equation 234U/238U = 235U/238U x 234U/235U. The results show a significant improvement, i.e., more than 35 times better precision in measuring the (234)U/(238)U ratio with this method (sigma = 2.9 x 10(-8)) as compared to direct measurement of 234U/238U (sigma = 1.1 x 10(-6)). The method widens the applicability of the single collector system, and it will potentially be helpful to improve the precision in the case of the static multicollector system also.

Measurement of radioactivity in the soil of Bahawalpur division, Pakistan.

Bahawalpur is the largest division of the Punjab province in Pakistan. It is larger than many countries of the world. Gamma activity from the naturally occurring radionuclides namely 226Ra, 232Th, the primordial radionuclide 40K and the artificial radionuclide 137Cs was measured in the soil of the Bahawalpur division using gamma spectrometry technique. The mean activity of 226Ra, 232Th, 40K and 137Cs were found to be 32.9 +/- 0.9, 53.6 +/- 1.4, 647.4 +/- 14.1 and 1.5 +/- 0.2 Bq kg(-1), respectively. The mean radium equivalent activity Raeq, external hazard index, internal hazard index and terrestrial absorbed dose rate for the area under study are 158.5 +/- 4.1 Bq kg(-1), 0.4, 0.5 and 77.32 nGy h(-1), respectively. The annual effective dose equivalent to the public was found to be 0.5 mSv.