Photocatalytic inactivation of dual- and mono-species biofilms by immobilized TiO2.

Biofilms formed by different bacterial species are likely to play key roles in photocatalytic resistance. This study aims to evaluate the efficacy of a photocatalytic immobilized nanotube system (TiO2-NT) (IS) and suspended nanoparticles (TiO2-NP) (SS) against mono- and dual-species biofilms developed by Gram-negative and Gram-positive strains. Two main factors were corroborated to significantly affect the biofilm resistance during photocatalytic inactivation, i.e., the biofilm-growth conditions and biofilm-forming surfaces. Gram-positive bacteria showed great photosensitivity when forming dual-species biofilms in comparison with the Gram-positive bacteria in single communities. When grown onto TiO2-NT (IS) surfaces for immobilized photocatalytic systems, mono- and dual-species biofilms did not exhibit differences in photocatalytic inactivation according to kinetic constant values (p > 0.05) but led to a reduction of ca. 3-4 log10. However, TiO2-NT (IS) surfaces did affect biofilm colonization as the growth of mono-species biofilms of Gram-negative and Gram-positive bacteria is significantly (p ≤ 0.05) favored compared to co-culturing; although, the photocatalytic inactivation rate did not show initial bacterial concentration dependence. The biofilm growth surface (which depends on the photocatalytic configuration) also favored resistance of mono-species biofilms of Gram-positive bacteria compared to that of Gram-negative in immobilized photocatalytic systems, but opposite behavior was confirmed with suspended TiO2 (p ≤ 0.05). Successful efficacy of immobilized TiO2 for inactivation of mono- and dual-species biofilms was accomplished, making it feasible to transfer this technology into real scenarios in water treatment and food processing.

Short communication: determination of lactoferrin in Feta cheese whey with reversed-phase high-performance liquid chromatography.

In the current paper, a method is introduced to determine lactoferrin in sweet whey using reversed-phase HPLC without any pretreatment of the samples or use of a separation technique. As a starting point, the most common HPLC protocols for acid whey, which included pretreatment of the whey along with a sodium dodecyl sulfate-PAGE step, were tested. By skipping the pretreatment and the separation steps while altering the gradient profile, different chromatographs were obtained that proved to be equally efficient to determine lactoferrin. For this novel 1-step reversed-phase HPLC method, repeatability was very high over a wide range of concentrations (1.88% intraday to 5.89% interday). The limit of detection was 35.46µg/mL [signal:noise ratio (S/N)=3], whereas the limit of quantification was 50.86µg/mL (S/N=10). Omitting the pretreatment step caused a degradation of the column's lifetime (to approximately 2,000 samples). As a result, the lactoferrin elution time changed, but neither the accuracy nor the separation ability of the method was significantly influenced. We observed that this degradation could be easily avoided or detained by centrifuging the samples to remove fat or by extensive cleaning of the column after every 5 samples.

Identification of non-linear microbial inactivation kinetics under dynamic conditions.

In this study dynamic microbial inactivation experiments are exploited for performing parameter identification of a non-linear microbial model. For that purpose microbial inactivation data are produced and a differential equation exhibiting a shoulder and a loglinear phase is employed. The derived parameter estimates from this method were used to perform predictions on an independent experimental set at fluctuating temperature. Joint confidence regions and asymptotic confidence intervals of the estimated parameters were compared with previous studies originating from parameter identification under isothermal conditions. The developed approach can provide more reliable estimates for realistic conditions compared to the usual or standard two step approach.