Influence of different centrifugation protocols on equine semen preservation.

Three experiments were conducted to evaluate the impact of centrifugation on cooled and frozen preservation of equine semen. A standard centrifugation protocol (600 x g for 10 min=CP1) was compared to four protocols with increasing g-force and decreased time period (600 x g, 1200 x g, 1800 x g and 2400 x g for 5 min for CP2, 3, 4, and 5, respectively) and to an uncentrifuged negative control. In experiment 1, the influence of the different CPs on sperm loss was evaluated by calculating the total number of sperm cells in 90% of the supernatant. Moreover, the effect on semen quality following centrifugation was assessed by monitoring several sperm parameters (membrane integrity using SYBR14-PI, acrosomal status using PSA-FITC, percentage total motility (TM), percentage progressive motility (PM) and beat cross frequency (BCF) obtained with computer assisted sperm analysis (CASA)) immediately after centrifugation and daily during chilled storage for 3 d. The use of CP1 resulted in a sperm loss of 22%. Increasing the centrifugation force to 1800 x g and 2400 x g for 5 min led to significantly lower sperm losses (7.4% and 2.1%, respectively; P<0.05). Compared to the uncentrifuged samples, centrifugation of semen resulted in a better sperm quality after chilled storage. There were minimal differences between the CPs although total motility was lower for CP2 than for the other treatments (P<0.005). In experiment 2, the centrifuged samples were cryopreserved using a standard freezing protocol and analyzed immediately upon thawing. Samples centrifuged according to CP2 resulted in a higher BCF (P<0.005), whereas CP3 and CP5 yielded a lower BCF (P<0.05) when compared to CP1. There were no post thaw differences between CP1 and CP4. In experiment 3, DNA integrity of the different samples was analyzed using TUNEL. Although DNA integrity decreased over time, CP had no impact. In conclusion, the loss of sperm cells in the supernatant after centrifugation can be substantially reduced by increasing the g-force up to 1800 x g or 2400 x g for a shorter period of time (5 min) compared to the standard protocol without apparent changes in semen quality, resulting in a considerable increase in the number of insemination doses per ejaculate.

Selection of reference genes for quantitative real-time PCR in equine in vivo and fresh and frozen-thawed in vitro blastocysts.

BACKGROUND: Application of reverse transcription quantitative real-time polymerase chain reaction is very well suited to reveal differences in gene expression between in vivo and in vitro produced embryos. Ultimately, this may lead to optimized equine assisted reproductive techniques. However, for a correct interpretation of the real-time PCR results, all data must be normalized, which is most reliably achieved by calculating the geometric mean of the most stable reference genes. In this study a set of reliable reference genes was identified for equine in vivo and fresh and frozen-thawed in vitro embryos. FINDINGS: The expression stability of 8 candidate reference genes (ACTB, GAPDH, H2A/I, HPRT1, RPL32, SDHA, TUBA4A, UBC) was determined in 3 populations of equine blastocysts (fresh in vivo, fresh and frozen-thawed in vitro embryos). Application of geNorm indicated UBC, GAPDH, ACTB and HPRT1 as the most stable genes in the in vivo embryos and UBC, RPL32, GAPDH and ACTB in both in vitro populations. When in vivo and in vitro embryos were combined, UBC, ACTB, RPL32 and GAPDH were found to be the most stable. SDHA and H2A/I appeared to be highly regulated. CONCLUSIONS: Based on these results, the geometric mean of UBC, ACTB, RPL32 and GAPDH is to be recommended for accurate normalization of quantitative real-time PCR data in equine in vivo and in vitro produced blastocysts.