ABSTRACT
In this work, the complex refractive indexes of seven PEDOT:PSS samples, three with isotropic behavior and four with optical anisotropy, were determined. For the anisotropic samples, the ordinary and extraordinary components of the refractive index were described. The effect of the film thickness, measurement technique and preparation method on the extinction coefficient (k) and refractive index (n) of each sample was also discussed. Important differences (up to 20% in the average n) were found among the samples investigated. In most anisotropic films, the mean value of the extraordinary component was between 7 and 10% higher than that of the ordinary. In the three isotropic films, the average k rose when the film thickness increased. Moreover, the different sets of refractive index data were fitted to three different models: the original Forouhi-Bloomer model, the Liu (2007) model and the revised version of the Forouhi-Bloomer model (2019). In general, Liu's model gave better results, with small errors in n and k (<7.81 and 4.68%, respectively, in all the cases). However, this model had seven fitting parameters, which led to significantly longer computation time than the other two models. The influence of the differences in the measurement of the complex refractive index on the simulation of the optical properties of PEDOT:PSS multilayers was discussed. The results showed that n must be known precisely to accurately calculate the light absorption in a multilayer, without ignoring the isotropic or anisotropic behavior of the material or the influence of the layer thickness on its optical properties. This study aids in the development of simulation and optimization tools that allow understanding the optical properties of PEDOT:PSS films for their potential applications in organic optoelectronic devices, such as organic solar cells.
ABSTRACT
Poly(3-hexylthiophene) (P3HT) is one of the most attractive polymeric donor materials used in organic solar cells because of its high electrical conductivity and solubility in various solvents. However, its carrier mobility is low when compared to that of inorganic semiconductors; hence, the incorporation of appropriate nanomaterials to improve its electrical mobility and optical properties are pursued. In this work, a review of the changes in electrical conductivity, bandgap, hole collection properties and carrier mobility of P3HT when adding graphene (G) is presented. The main aim is to assess how the addition of different G contents influences the optical constants: refractive index (n) and extinction coefficient (k). The values of n and k as a function of the wavelength for six P3HT/G nanocomposites with G loadings in the range of 0.1-5 wt% have been fitted to two different models, Forouhi Bloomer and Cauchy, showing very good agreement between the experimental and the theoretical values. Furthermore, a rule of mixtures was successfully applied to calculate n using mass fraction instead of volume fraction, with errors lower than 6% for all the nanocomposites studied.
ABSTRACT
Graphene-related materials (GRMs) such as graphene quantum dots (GQDs), graphene oxide (GO), reduced graphene oxide (rGO), graphene nanoribbons (GNRs), and so forth have recently emerged as photovoltaic (PV) materials due to their nanodimensional structure and outstanding properties such as high electrical and thermal conductivity, large specific surface, and unique combination of mechanical strength and flexibility. They can be a crucial part of transparent electrodes, hole/electron transport materials, and active layers in organic solar cells (OSCs). Besides their role in charge extraction and transport, GRMs act as device protectors against environmental degradation through their compact bidimensional structure and offer good durability. This review briefly presents the synthesis methods of GRMs and describes the current progress in GRM-based OSCs. PV parameters (short circuit current, open circuit voltage, power conversion efficiency, and fill factor) are summarized and comparatively discussed for the different structures. The efficiency recently surpassed 15% for an OSC incorporating polymer-modified graphene as a transparent electrode. The long-term stability of OSCs incorporating GRMs is also discussed. Finally, conclusions and the outlook for future investigation into GRM-based devices for PVs are presented.
