ABSTRACT
An electrochemical method based on the concept of a biosensor for the monitoring of ozone is described for first time. The proposed method includes two parts: a selective sorbent for ozone, that is, eugenol, and a formaldehyde amperometric biosensor mounted into a flow-through cell. Ozone adds rapidly to the double bond of the allyl group of eugenol, which has been immobilized onto a hydrophobic C-18 reactor and the so produced formaldehyde is collected into the working buffer solution (sampler) and pumped to the detector. A multimembrane assembly consisting of an alcohol oxidase-modified nylon membrane sandwiched between an outer polycarbonate and an inner cellulose acetate membrane was fitted onto a Pt electrode and the enzymatically produced H2O2 was monitored at +0.65 V (vs Ag/AgCl/KCl 3 M). Under optimum conditions, a linear calibration curve over the concentration range 3-200 microg x mL(-1) ozone was constructed. The detection limit (S/N = 3) was calculated at 1.1 microg x mL(-1) ozone. The proposed method is interference-free from other gases such as O2, Ar, N2, N2O, NOCl, SO2, NH3, and CO2, which were tested at concentrations >200-fold higher than that of 100 microg x mL(-1) ozone used for comparison. Besides selectivity, the method is easy to perform and reproducible; its applicability in synthetic gaseous samples is also demonstrated.
Subject(s)
Alcohol Oxidoreductases/metabolism , Biosensing Techniques , Electrodes , Ozone/analysis , Sensitivity and SpecificityABSTRACT
This article describes an analytical method for the determination of magnesium taking advantage of the cloud point phenomenon employing a suitable chelating agent (chloranilate) for Mg analysis. The method encompasses pre-concentration of the metal chelate followed by flame atomic absorption spectrometry (FAAS) analysis. The chelating agent chosen for this task is a newly synthesised salt of chloranilic acid, trizma-chloranilate, which reacts with Mg but at the same time has a very low affinity for other metallic cations like silicon, aluminium and sodium, which interfere with the determination of Mg in FAAS. The condensed surfactant phase with the metal chelate(s) is introduced into the flame of an atomic absorption spectrometer after its treatment with an acidified methanolic solution. In this way, complex and time-consuming steps for sample treatment are avoided while increased sensitivity is achieved by the presence of both methanol and surfactant in the aspirated sample. The analytical curve was rectilinear in the range of 5-220 mugl(-1) and the limit of detection was as low as 0.75 mugl(-1) with a standard deviation of 5.2%. The method was applied for the determination of Mg in natural and mineral waters with satisfactory results and recoveries in the range of 97-102%.