ABSTRACT
Progress in developing novel gas sensors based on semiconducting metal oxides (SMOX) has been hindered by the cumbersome fabrication technologies currently employed. They involve time intensive synthesis procedures for gaining sensitive materials and preparation of the inks employed for realizing sensing layers. In this paper we review the opportunities offered by the relatively young method of flame spray pyrolysis, with which it is possible not only to synthesize a broad selection of SMOX in pure or doped form, but also to simultaneously deposit thick and highly porous gas sensitive films on a variety of substrates. In less than ten years the properties of nine base materials have been evaluated for all most relevant target gases and the obtained results are promising for future development.
ABSTRACT
A new method for investigation of the swelling of polymers on exposure to gas or vapour has been devised and tested. It uses an optical profilometer (based on the chromatic aberration of a lens system) which is integrated into a computer-controlled gas-dosing and mixing setup. Gas and/or vapour concentration-dependent measurements have been carried out for thick layers of the polymers commonly used in gravimetric and capacitive gas sensors: poly(acrylic acid) (PAA), poly(vinyl pyrrolidone) (PVP), poly(ether urethane) (PEUT), and polydimethylsiloxane (PDMS). The thickness of PAA, PVP, and PEUT films changed significantly on exposure to humidity. These data have been used to derive the sorption isotherms of the respective polymers, which were found to be Henry or Flory-Huggins isotherms. Comparison of the geometrical (swelling) responses with capacitive responses revealed a strong correlation. The correlation, which occurs because both types of response are proportional to the water content of the polymer, is also valid for polymers with nonlinear gas responses. Finally the geometrical and electrical characteristics of the capacitive samples were used to explain the dependence of the capacitive response of different polymers on the concentration of the target gas or vapour. In this way was deduced that PDMS, which does not swell on exposure to humidity, swells in the presence of 2,3-dimethylpentane, for which no profilometer evaluations are yet available.
ABSTRACT
In this work we investigated different thickness shear mode resonators (TSMRs) with fundamental frequencies of 10 and 30 MHz and surface acoustic wave devices with fundamental frequencies of 80 and 433 MHz. Four aspects were of primary interest in this comparison: noise levels and signal-to-noise ratios (S/N), influence of the polymer film thickness, influence of temperature on the transducer signal before and after coating, and minimum threshold values for monitoring different volatile organic compounds in the environment. We limited our investigations to a temperature range between 298 and 308 K, with 303 K the routine measuring temperature. Analyte concentrations (n-octane, tetrachloroethene) were chosen from the minimum detection limit up to 5000 µg/L. The temperature was found to strongly affect the performance of all the devices. The sorption of the analyte vapors into the polymeric films was demonstrated to be transducer-independent (identical partition coefficients for all the devices). The 30 MHz TSMRs showed very satisfying results in terms of S/N and limits of detection.
