UV-Vis LED-assisted photo-Fenton process for mineralization of losartan and hydrochlorothiazide: optimization using desirability function.

This study presents the results obtained for the optimization of the mineralization of losartan (LOS) and hydrochlorothiazide (HCTZ) using the photo-Fenton process with a UV-Vis LED. Experimental design optimization employing a Doehlert matrix and a global desirability function enabled simultaneous evaluation of multiple responses, with factor fitting providing the best conditions that maximized the mineralization efficiency: Fe2+ at 10 mg L-1 and H2O2 at 100 mg L-1. High rates of mineralization of LOS and HCTZ were obtained, with dissolved organic carbon (DOC); removal of almost 75% after 90 min was observed for both pharmaceuticals. The kinetic model showed that the mineralization followed two regimes in the first minutes, with a fast progression followed by slower activity. The energy consumption calculated for mineralization of LOS and HCTZ at a concentration of 20 mg L-1 using the UV-Vis LED-assisted photo-Fenton process, at 60 min, was 130 kWh m-3. The desirability function provides a useful tool for finding optimal experimental conditions for the treatment of effluents with different characteristics. The UV-Vis LED was shown to be a good light source in the photo-Fenton process.

In vitro bioaccessibility of Al, Cu, Cd, and Pb following simulated gastro-intestinal digestion and total content of these metals in different Brazilian brands of yerba mate tea.

Yerba mate tea contains various biochemically active substances. However, it can contain toxic metals. Thus, this work reports the total concentrations of Cd, Cu, Pb and Al in the commercial products, as well as the concentrations in infusions prepared. The bioaccessibility of these metals in these infusions was determined for the first time by in vitro digestion. For Al, its bioaccessibility was estimated in the presence of other ingredients used in tea consumption. In addition, the concentrations of phenolic compounds in infusions were also determined. All metals studied were detected in the samples ranging from 76 ng g-1 (Cd) to 526 µg g-1 (Al). In general, Cd and Cu were the most bioaccessible metals, while Al was found in a relatively inert form. The addition of sugar and honey in infusions decreased the Al bioaccessibility. The relationship between the phenolic and the leaching of Al for the beverages was observed.

Jabuticaba (Myrciaria cauliflora) Seeds: Chemical Characterization and Extraction of Antioxidant and Antimicrobial Compounds.

This study was aimed to assess the effect of time and temperature on the extraction of antioxidant compounds from jabuticaba seeds (Myrciaria cauliflora cv. Sabará), to optimize the solvent proportion (water, ethyl alcohol, and propanone), and to characterize the extract according to the chemical composition, antioxidant, and antimicrobial properties. Proximal composition, total phenolic content (TPC), antioxidant, and antimicrobial activities were analyzed. The optimized solvent ratio of 60% water and 40% propanone provided a mean TPC of 8.65 g GAE/100 g seeds and the antioxidant activity toward 2,2-diphenyl-1-picrylhydrazyl (DPPH) was 82.79% ± 0.50%. Time and temperature parameters did not influence the yield of TPC. The gross seed extract was partially purified and both exhibited a high antioxidant activity and antimicrobial potential toward Gram-positive and Gram-negative bacteria. The purified jabuticaba seed lyophilized extract contained a higher (P < 0.05) TPC, o-diphenols, flavonols, and antioxidant activity measured by the DPPH assay and total reducing capacity as compared to the gross lyophilized extract. Electrospray ionization coupled with tandem mass spectrometry (ESI-MS/MS) data showed the presence of ellagitannins and ellagic acid in the extracts, which are probably the responsible for the antimicrobial and antioxidant activities.

An environmentally friendly reflectometric method for ranitidine determination in pharmaceuticals and human urine.

This paper describes an environmentally friendly method for quantitative determination of ranitidine using diffuse reflectance spectroscopy. This method is based on the reflectance measurements of the colored product produced from the spot test reaction between ranitidine and p-dimethylaminocinnamaldehyde (p-DAC), in acid medium, using filter paper as solid support. Experimental design methodologies were used to optimize the optimal conditions. All reflectance measurements were carried out at 590 nm and the linear range was from 1.42x10(-3) to 3.42x10(-2) mol L(-1), with a correlation coefficient of 0.997. The limit of detection was estimated to be 1.09x10(-3) mol L(-1) (R.S.D.=1.9%). The proposed method was successfully applied to the determination of ranitidine in commercial brands of pharmaceuticals and no interferences were observed from the common excipients in formulations. The results obtained by the proposed method were favorably compared with those obtained by an official procedure at 95% confidence level. Additionally, the method was also applied to the determination of ranitidine in human urine showing excellent recoveries (99.6-100.3%).

Flow-injection spectrophotometric determination of novalgin in pharmaceuticals using micellar medium.

A sensitive flow-injection (FI) procedure with spectrophotometric detection in a micellar medium is proposed for the determination of novalgin. The method is based on the instantaneous formation of a red-orange product (lambda(max) = 510 nm) after the reaction between novalgin and p-dimethylaminocinnamaldehyde (p-DAC) in a dilute acid medium. The sensitivity of this reaction was increased by a factor of 5.6 in the presence of sodium dodecyl sulfate (SDS). Experimental design methodologies were used to optimize the chemical and FI variables. The calibration curve was linear in the range of 1.45 x 10(-6) to 2.90 x 10(-5) mol L(-1) with an excellent correlation coefficient (r = 0.9999). The detection limit was 1.31 x 10(-7) mol L(-1) (n = 20, RSD = 2.0%). No interferences were observed from the common excipients. The results obtained by the proposed method were favorably compared with those given by the iodometric reference method at 95% confidence level.