Electrokinetically-delivered persulfate and pulsed direct current electric field induced transport, mixing and thermally activated in situ for remediation of PAHs contaminated soil.

Herein, we proposed and proved a novel strategy that enhanced the delivery of persulfate (PS) to soil by electrokinetics (EK), and then applying a pulsed direct current (DC) electric field thermally activated the PS in situ, and synchronously promoted PS plume mixing, contaminants-free radicals reaction and continued to replenish PS to the soil, to achieve efficient degradation of contaminants in low permeability zones. Results showed that transport rate of PS in tested soil by EK was approximately 12.3 times than diffusion. Applying an irregular pulsed DC field maintained the targeted temperature (30-50 â„ƒ) during activation phase, and generated two oxidative radicals (SO4∙-/∙OH). Concurrently, in the case, electromigration and electroosmosis have promoted the PS transport and the reactive mixing of PS/free radicals with polycyclic aromatic hydrocarbons (PAHs) contaminated soil and enhance the PAHs degradation. PS concentrations in pore fluid was characterized by an increase accompanied by continuous fluctuations. Eventually, in case of the long-term low-temperature activation (i.e., 30-40 ℃), a significant decreases (nearly 60%) in average concentration of PAHs in the whole soil cell was observed over 10 days. These results demonstrates that the novel strategy has great potentiality in the remediation of low permeability contaminated soil.

Enhanced electrokinetically-delivered persulfate and alternating electric field induced thermal effect activated persulfate in situ for remediation of phenanthrene contaminated clay.

Delivering persulfate (PS) efficiently into clay is an unsolved challenge. This study proposes a novel strategy with enhanced electrokinetically -delivery PS into clay by using PS for continuously flushing cathode to inhibit water electrolysis at cathode electrode. On this basis, a novel approach of heating soil by alternating current (AC) was used to thermally activate PS in situ. Results show that the mass transfer efficiency of PS by electroosmotic flow is about 20 times that by electromigration. Moreover, when PS was added in the anode chamber, using PS solution continuously flushing cathode created a relatively balanced the influent and effluent flow rates, significantly improving the mass transfer efficiency of PS. Compared to using NaNO3 solution flushing, a significant increase of 51.7% was achieved, reaching 78.8%, for the phenanthrene (PHE) average degradation rate in soil cell. In contrast, the best overall PHE removal rate was observed, reaching 87.8%, by a cycle strategy of enhanced electrokinetically -delivered PS followed by AC heating applied. Electron paramagnetic resonance spectroscopy analysis showed oxidative radicals (SO4∙-/•OH) were the major species responsible for enhanced PHE degradation. These results demonstrate that this cycle strategy is a viable method for remediation of polycyclic aromatic hydrocarbons in clay.

Petroleum hydrocarbon-contaminated soil bioremediation assisted by isolated bacterial consortium and sophorolipid.

Pollution in soil by petroleum hydrocarbon has become a global environmental problem. The bioremediation of petroleum hydrocarbon-contaminated soil was enhanced with the combination of an isolated indigenous bacterial consortium and biosurfactant. The biodegradation efficiency of total petroleum hydrocarbon (TPH) was increased from 12.2% in the contaminated soil to 44.5% and 57.7% in isolated consortium and isolated consortium & 1.5 g sophorolipid (SL)/kg dry soil, respectively. The half-life of TPH degradation process was decreased from 32.5 d in the isolated consortium reactor to 20.4 d in the isolated consortium & 1.5 g SL/kg dry soil. The addition of biosurfactant into contaminated soils improved the TPH desorption from solid matrix to the aqueous solution and the subsequent solubilization, which ultimately improved the bioavailability of TPH in contaminated soils. Biosurfactant also served as carbon sources which contributed to the stimulation of cell growth and microbial activity and accelerated the biodegradation process via co-metabolism. The enzyme activities and quantities of functional genes were demonstrated to be incremented in SL reactors. The biosurfactant improved the TPH bioavailability, stimulated the microbial activities and participated in the co-metabolism. The combination of bioaugmentation and SL benefitted the bioremediation of petroleum hydrocarbon-contaminated soil.

Removal of inorganic contaminants in soil by electrokinetic remediation technologies: A review.

The soil contaminated by inorganic contaminants including heavy metals, radioactive elements and salts has been posing risks for human health and ecological environment, which has been widely paid attention in recent years. The electrokinetic remediation (EKR) technology is recognized as the most potential separation technology, which is commonly used to clean sites that are contaminated with organic and inorganic contaminants. It is the most suitable remediation technology for low permeability porous matrices. The main transport mechanism of pollutants in EKR include electromigration, electroosmosis and electrophoresis, coupled with electrolysis and geochemical reactions. Although arduous endeavors have been carried out to build optimal operating conditions and reveal the mechanism of EKR process, a systematic theoretical foundation hasn't been sorted yet. A comprehensive review on electrokinetic remediation of inorganic contaminants in soil is given in this study, and a more systematic theoretical foundation is sorted out according to the latest theoretical achievements. This theoretical system mainly focuses on the scientific and practical aspects of the application of EKR technology in soil remediation, by which we try to dig into the core of this technology. It contains key motive power of electric phenomena, side effects, energy consumption and supply, and removal of heavy metals, radioactive elements and salts in soil during EKR. In addition, correlations between dehydration, crystallization effect, focusing effect and thermal effect are disclosed; optimal operating conditions for the removal of heavy metals by EKR and EKR coupled with PRB are discussed and sorted out. Also discussed herein is the relationship between energy allocation and energy saving. According to the related findings, some potential improvements are also proposed.

Application of alkyl polyglycosides for enhanced bioremediation of petroleum hydrocarbon-contaminated soil using Sphingomonas changbaiensis and Pseudomonas stutzeri.

Bioremediation is considered a cost-effective and environmentally sound method for degradation of petroleum hydrocarbons in contaminated soils. This study investigated the effects of biosurfactant alkyl polyglycosides (APG) on enhanced biodegradation of petroleum hydrocarbon-contaminated soils using Sphingomonas changbaiensis and Pseudomonas stutzeri and explored the mechanism responsible for the enhanced petroleum hydrocarbon degradation. To accomplish this, the following treatments were evaluated: (1) bioaugmentation with Sphingomonas changbaiensis; (2) bioaugmentation with Pseudomonas stutzeri; (3) a combination of Sphingomonas changbaiensis and APG; and (4) a combination of Pseudomonas stutzeri and APG. The results showed that the degradation rates of total petroleum hydrocarbons (TPH) in contaminated soil samples bioaugmented with S. changbaiensis and P. stutzeri for 30 days were 39.2 ± 1.9% and 47.2 ± 1.2%, respectively. The addition of biosurfactant APG enhanced the bioremediation processes and improved the biodegradation rates. The biodegradation rate at 1.5 g/kg APG in soil samples bioaugmented with S. changbaiensis was 52.1 ± 2.0%, while the rate at 1.5 g/kg APG in soil samples bioaugmented with P. stutzeri was 59.0 ± 1.8%. The half-life decreased from 39.7 d to 24.5 d and from 29.6 to 20.1 d when the dosage of APG was 1.5 g/kg in contaminated soil samples bioaugmented with S. changbaiensis and P. stutzeri, respectively. Mechanism studies showed that the addition of APG can increase the TPH solubility, promote the sorption of TPH onto microbial cells and subsequent trans-membrane transport by APG-induced structural changes, stimulate microbial activities and participate in the co-metabolism. Therefore, the combination of bioaugmentation and APG is an effective method for remediation of petroleum hydrocarbon-contaminated soil.

Treatment of decabromodiphenyl ether (BDE209) contaminated soil by solubilizer-enhanced electrokinetics coupled with ZVI-PRB.

Decabromodiphenyl ether (BDE209) is a typical soil contaminant released from e-waste recycling sites (EWRSs). Electrokinetics (EK) has been considered as an excellent treatment technology with a promising potential to effectively remove organic pollutants in soil. In this study, the treatment of BDE209-polluted soil by EK was explored. All the EK experiments were conducted under a constant voltage gradient (2 V cm-1) for 14 days. Deionized water (DI water), hydroxypropyl-ß-cyclodextrin (HPCD), sodium dodecyl sulfate (SDS), and humic acid (HA) were applied as the processing fluid. The experimental results showed that all the solubilizers could effectively promote the mobility and transport of BDE209 in the soil via the electro-osmotic flow (EOF) or electromigration. The removal efficiencies achieved in S1 section were 24, 22, and 26% using HPCD, SDS, and HA as the processing fluid. However, the removal of BDE209 for the entire soil cell was not achieved until zero valence iron (ZVI) was inserted at the center of soil column as a permeable reactive barrier (PRB) or (ZVI-PRB), which enhanced the degradation of BDE209. As ZVI-PRB was installed in EK5 and EK6 experiments, the corresponding average removal efficiencies increased to 16 and 13%, respectively. Additionally, the degradation products of BDE209 analyzed by GC-MS suggested that debromination of BDE209 was the main potential degradation mechanism in the EK treatment in the presence of ZVI-PRB.

[Enhanced Electrokinetic Remediation of Heavy Metals Contaminated Soils by Stainless Steel Electrodes as well as the Phenomenon and Mechanism of Electrode Corrosion and Crystallization].

Electrode corrosion and salt crystallization are important challenges that restrict the engineering application of electrokinetic technology. In the present study, using stainless steel as an electrode, and deionized water (DW), citric acid (CA) and polyaspartic acid (PASP) as electrolytes, Pb/Cu-contaminated soil was remediated by electrokinetic. All of the EK experiments were conducted in a 2 L soil cell reactor with a moisture level of about 35% blended with 1000 mg·g-1 of Pb and 778 mg·g-1 of Cu under a constant voltage gradient (1 V·cm-1, 2 V·cm-1) for 150 h. The removal efficiency of heavy metals and influencing factors, as well as the phenomenon and mechanism of electrode corrosion and salt crystallization were explored. The experimental results showed under the action of electric field, the Ca in the test soil would move to the cathode, and the crystal was formed in the alkaline condition. Additionally, the conductivity of the electrode was reduced. During the EK process, water at the anode was primarily oxidized, undergoing a reduction reaction at the cathode. Because H+ and OH- were transported through the soil by electromigration and electro-osmotic flow (EOF), changes in soil pH could occur. The concentrations distribution of Pb-Cu appeared to be related to the distribution of soil pH in the cell, which might be associated with the desorption and hydroxide precipitation of Pb-Cu. PASP resulted in obvious inhibitory effect on the corrosion of stainless steel electrode, CA and PASP could clearly destroy the formation of CaCO3 crystal, while barely effectively disrupted the formation of Ca (OH)2 crystal. Both CA and PASP could promote the removal of Pb, but the influence of PASP on the removal of Cu was not obvious, and the effect of CA was very significant. Combined with different corrosion inhibitor and reinforcing agent, stainless steel can be chosen as the engineering application electrode in electrokinetic remediation.

Electromechanical impedance response of a cracked Timoshenko beam.

Typically, the Electromechanical Impedance (EMI) technique does not use an analytical model for basic damage identification. However, an accurate model is necessary for getting more information about any damage. In this paper, an EMI model is presented for predicting the electromechanical impedance of a cracked beam structure quantitatively. A coupled system of a cracked Timoshenko beam with a pair of PZT patches bonded on the top and bottom surfaces has been considered, where the bonding layers are assumed as a Kelvin-Voigt material. The shear lag model is introduced to describe the load transfer between the PZT patches and the beam structure. The beam crack is simulated as a massless torsional spring; the dynamic equations of the coupled system are derived, which include the crack information and the inertial forces of both PZT patches and adhesive layers. According to the boundary conditions and continuity conditions, the analytical expression of the admittance of PZT patch is obtained. In the case study, the influences of crack and the inertial forces of PZT patches are analyzed. The results show that: (1) the inertial forces affects significantly in high frequency band; and (2) the use of appropriate frequency range can improve the accuracy of damage identification.

[Clinical analysis of missed diagnosis of duodenal injury in 9 cases].

OBJECTIVE: To study the reasons and possibly solutions for missed diagnosis of duodenal injury. METHOD The clinical records were retrospectively analyzed in 9 cases of missed diagnosis of duodenal injury treated in our hospital in the year 1992 to 2002. RESULTS Of the 15 cases of duodenal injury, missed diagnoses occurred in 9 cases. The reasons for the missed diagnoses included complications by injuries of the other abdominal organs that concealed duodenal injuries, neglect of the light injuries, and the lack of clinical experience on the part of the young doctors. CONCLUSION Duodenal injury frequently occurs along with other abdominal organ injuries and is easy to escape detection, which can be avoided by careful preoperative examination of the characteristics of injuries and the patients' clinical manifestations after the injury.